Conductivity anomalies in the Baltic Shield in Finland

In 1981–84 six arrays of 30 or 31 magnetometers were operated on the Baitic Shield in central and southern Finland to deduce information about the electrical conductivity within the Earth's crust. The magnetometer sites cover the area with 20–60 km spacing allowing the identification of large-scale electrical structures within the crust. Each array recorded the three orthogonal magnetic field components on analogue film for about two months simultaneously at all the stations. Altogether 17 magnetic variation events of 2–6hr length have been digitized and analysed.
This paper includes results of the last array in south-western Finland, a comparison of two methods of induction vector estimation and combination of results from all the arrays. Four zones of anomalously high electrical conductivity have been observed. They are all interpreted as lying at depths greater than 5 km. The 'Oulu Anomaly' is wider than the others and rather short, about 100 km. The 'Southern Finland Anomaly' is probably a 500 km-long narrow zone. This and the 'Ostrobothnian Anomaly' surround three sides of the large Central Finland Granite area. The 'Outokumpu Anomaly' is probably deeper lying than the others. Blocks separated by these anomalies are presented. The blocks have different average resistivities.     

Upper-mantle structure of the Baltic Shield below the Swedish National Seismological Network (SNSN) resolved by teleseismic tomography

Upper-mantle structure under the Baltic Shield is studied using non-linear high resolution teleseismic P -phase tomography. Observed relative arrival-time residuals from 52 teleseismic earthquakes recorded by the Swedish National Seismological Network (SNSN) are inverted to delineate the structure of the upper mantle. The network consists of 47 (currently working) three-component broad-band stations located in an area about 450 km wide and 1450 km long. In order to reduce complications due to possible significant three-dimensionality of Earth structure, events chosen for this study lay close to in-line with the long-axis of the array  (±30°)  . Results indicate P -wave velocity perturbations of ±3 per cent down to at least 470 km below the network. The size of the array allows inversion for structures even at greater depths, and lateral variations of velocity at depths of up to 680 km appear to be resolved. Below the central part of the array (60°–64° N), where ray coverage is best, the data reveals a large region of relatively low velocity at depths of over about 300 km. At depths less than about 250–300 km, the models include a number of features, including an apparent slab-like structure dipping gently towards the north.     

Re-evaluation of focal depths and source mechanisms of selected earthquakes in the Afar depression

We present a stepwise inversion procedure to assess the focal depth and model earthquake source complexity of seven moderate-sized earthquakes  (6.2 > M _w > 5.1)  that occurred in the Afar depression and the surrounding region. The Afar depression is a region of highly extended and intruded lithosphere, and zones of incipient seafloor spreading. A time-domain inversion of full moment tensor was performed to model direct P and SH waves of teleseismic data. Waveform inversion of the selected events estimated focal depths in the range of 17–22 km, deeper than previously published results. This suggests that the brittle–ductile transition zone beneath parts of the Afar depression extends more than 22 km. The effect of near-source velocity structure on the moment tensor elements was also investigated and was found to respond little to the models considered. Synthetic tests indicate that the size of the estimated, non-physical, non-isotropic source component is rather sensitive to incorrect depth estimation. The dominant double couple part of the moment tensor solutions for most of the events indicates that their occurrence is mainly due to shearing. Parameters associated with source directivity (rupture velocity and azimuth) were also investigated. Re-evaluation of the analysed events shows predominantly normal faulting consistent with the relative plate motions in the region.     

Focal mechanisms of recent earthquakes in the Southern Korean Peninsula

We evaluate the stress field in and around the southern Korean Peninsula with focal mechanism solutions, using the data collected from 71 earthquakes ( M_L = 1.9–5.2) between 1999 and 2004. For this, the hypocentres were relocated and well-constrained fault plane solutions were obtained from the data set of 1270 clear P -wave polarities and 46 SH / P amplitude ratios. The focal mechanism solutions indicate that the prevailing faulting types in South Korea are strike-slip-dominant-oblique-slip faultings with minor reverse-slip component. The maximum principal stresses (σ₁) estimated from fault-slip inversion analysis of the focal mechanism solutions show a similar orientation with E–W trend (269°–275°) and low-angle plunge (10°–25°) for all tectonic provinces in South Korea, consistent with the E–W trending maximum horizontal stress (σ_Hmax) of the Amurian microplate reported from in situ stress measurements and earthquake focal mechanisms. The directions of the intermediate (σ₂) and minimum (σ₃) principal stresses of the Gyeongsang Basin are, however, about 90 deg off from those of the other tectonic provinces on a common σ₂–σ₃ plane, suggesting a permutation of σ₂ and σ₃. Our results incorporated with those from the kinematic studies of the Quaternary faults imply that NNW- to NE-striking faults (dextral strike-slip or oblique-slip with a reverse-slip component) are highly likely to generate earthquakes in South Korea.     

Azimuthal variation of the P phase in Icelandic receiver functions

A curious observation has been made on radial receiver functions calculated from teleseisms recorded by 29 broad-band seismometers distributed over Iceland. The arrival time of the direct P phase of the radial receiver functions depends critically upon the azimuth of the teleseismic source. For a seismic station in West Iceland, the direct P  phase of the radial receiver function arrives consistently later for easterly source azimuths than for westerly source azimuths. The reverse applies for stations in East Iceland. In the original seismograms, the delayed P phase of the receiver function appears up to 450 ms later on the radial than on the vertical component. The seismometer locations in East and West Iceland are separated by the Neovolcanic Zone, a constructive plate boundary. The delayed P phases occur for seismic rays travelling across this zone. However, it is not obvious how wave propagation across the plate boundary zone could cause the observed delays. The tentative explanation proposed here involves the regional dip of the Icelandic lava sequences towards the Neovolcanic Zone. A dipping interface at shallow depth results in a P–S converted phase arriving shortly after the P phase. These phases cannot be separated in the radial receiver functions, given the bandwidth of the observed signals. However, a calculation of receiver functions from estimates of the P , SV and SH wavefields clearly reveals a P–S converted phase at about 500 ms for easterly source azimuths in West Iceland and for westerly source azimuths in East Iceland. The amplitudes of the direct P phase and the P–S phase converted at a dipping interface would be expected to vary strongly with azimuth in accordance with the observed behaviour.     

Simulations of strong ground motion in SW Iberia for the 1969 February 28 (Ms= 8.0) and the 1755 November 1 (M∼ 8.5) earthquakes – II. Strong ground motion simulations

This is the second paper of a series of two concerning strong ground motion in SW Iberia due to earthquakes originating from the adjacent Atlantic area. The aim of this paper is to use the velocity model that was proposed and validated in the companion paper for seismic intensity modelling of the 1969 ( M _s= 8.0) and 1755 ( M = 8.5–8.7) earthquakes.
First, we propose a regression to convert simulated values of Peak Ground Velocity (PGV) into Modified Mercalli Intensity (MMI) in SW Iberia, and using this regression, we build synthetic isoseismal maps for a large ( M _s= 8.0) earthquake that occurred in 1969. Based on information on the seismic source provided by various authors, we show that the velocity model effectively reproduces macroseismic observations in the whole region. We also confirm that seismic intensity distribution is very sensitive to a small number of source parameters: rupture directivity, fault strike and fault dimensions. Then, we extrapolate the method to the case of the great ( M = 8.5–8.7) 1755 earthquake, for a series of hypotheses recently proposed by three authors about the location of the epicentral region. The model involving a subduction-related rupture in the Gulf of Cádiz results in excessive ground motion in northern Morocco, suggesting that the source of the 1755 earthquake should be located further west. A rupture along the western coast of Portugal, compatible with an activation of the passive western Iberian margin, would imply a relatively low average slip, which, alone, would could not account for the large tsunami observed in the whole northern Atlantic ocean. A seismic source located below the Gorringe Bank seems the most likely since it is more efficient in reproducing the distribution of high intensities in SW Iberia due to the 1755 earthquake.