Transport of oceanic nitrate from the continental shelf to the coastal basin in relation to the path of the Kuroshio

Hydrographic and biogeochemical observations were conducted along the longitudinal section from Ise Bay to the continental margin (southern coast of Japan) to investigate changes according to the Kuroshio path variations during the summer. The strength of the uplift of the cold deep water was influenced by the surface intrusion of the Kuroshio water to the shelf region. When the intrusion of the Kuroshio surface water to the shelf region was weak in 2006, the cold and NO₃⁻-rich shelf water intruded into the bottom layer in the bay from the shelf. This bottom intrusion was intensified by the large river discharge. The nitrogen isotope ratio (δ¹⁵N) of NO₃⁻ (4–5‰) in the bottom bay water was same as that in the deeper NO₃⁻ over the shelf, indicating the supply of new nitrogen to the bay. The warm and NO₃⁻-poor shelf water intruded into the middle layer via the mixing region at the bay mouth when the Kuroshio water distributed in the coastal areas off Ise Bay in 2005. The regenerated NO₃⁻ with isotopically light nitrogen (δ¹⁵N=−1‰) was supplied from the shelf to the bay. This NO₃⁻ is regenerated by the nitrification in the upper layer over the shelf. The contribution rate of regenerated NO₃⁻ over the shelf to the total NO₃⁻ in the subsurface chlorophyll maximum layer in the bay was estimated at 56% by a two-source mixing model coupled with the Rayleigh equation.     

The Effects of Hydrophilic Polymer and Soil Salinity on Corn Growth in Sandy and Loamy Soils

The interaction effects of different applied ratios of a hydrophilic polymer (Superab A200) (0, 0.2, 0.6% w/w) under various soil salinity levels (initial salinity, 4 and 8 ms/cm) were evaluated on available water content (AWC), biomass, and water use efficiency for corn grown in loamy sand and sandy clay loam soils. The results showed that the highest AWC was measured at the lowest soil salinity. The application of 0.6% w/w of the polymer at the lowest salinity level increased the AWC by 2.2 and 1.2 times greater than those of control in the loamy sand and sandy clay loam soils, respectively. The analysis of variance of data showed that the effect of salinity was significant on biomass and water use efficiency of corn in the loamy sand and sandy clay loam soils. The highest amounts of these traits were measured in soils with the lowest salinity level. Application of polymer at the rate of 0.6% in the loamy sand soil and at the rate of 0.2% in the sandy clay loam soil resulted in the highest aerial and root biomass and water use efficiency for corn. At these polymer rates the amounts of water use efficiency for corn were 2.6 and 1.7 times greater than those of control in the loamy sand and sandy clay loam soils, respectively. Thus, the use of hydrophilic polymer in soils especially in the sandy soils increases soil water holding capacity, yield, and water use efficiency of plant. On the other hand, decreases the negative effect of soil salinity on plant and helps for irrigation projects to succeed in arid and semi‐arid areas.     

Profiles of chloride and stable isotopes in pore-water obtained from a 2000 m-deep borehole through the Mesozoic sedimentary series in the eastern Paris Basin

Water stable isotopes and chloride profiles in pore-water through more than 800 m of sediments were obtained from a 2000 m-deep borehole (EST 433) drilled by Andra in the eastern Paris Basin. Vapour exchange method and aqueous leaching were used to obtain the stable isotope and chloride concentrations of pore-water from 24 rock samples. Petrophysical measurements included water contents, grain densities and porosities of the studied formations. Pore-water and some groundwater samples collected during the drilling are mainly of meteoric origin: they plot near the Global Meteoric Water Line, distributed between heavy-isotope depleted Oxfordian groundwater and enriched Triassic groundwater, in good agreement with previous data. The δ²H and δ¹⁸O values describe curved profiles in the Callovo-Oxfordian formation, and show an increase with depth below this formation (Dogger and Liassic). Similar trends were observed for the chloride concentrations, except in the Liassic formation where they are more or less constant. The low chloride concentrations in the basal Jurassic layers indicate that the source of salinity to the Dogger aquifer is likely the middle Liassic formation and not the Triassic salt as previously suggested. A preliminary modelling exercise showed that currently available diffusion parameters (diffusion coefficients and accessible porosities) might be used to properly simulate these exchanges for deuterium. This is not the case for chloride, perhaps because the used values for anion accessible porosity were not relevant and/or the applied modelling conditions were unsuitable.     

Persistency of flow patterns in a water repellent sandy soil – Conclusions of TDR readings and a time-delayed double tracer experiment

On a former waste water disposal field with water repellent sandy soil under grass vegetation we analyzed the persistency of flow patterns on a 150 m × 25 m plot by (i) continuous TDR-measurements on a 2 m × 1 m transect combined with seasonal soil moisture sampling campaigns, and (ii) a time-delayed double tracer experiment on a second 3 m × 1 m transect. Here, we applied bromide under wettable soil conditions in spring and chloride under water repellent soil conditions in autumn. At the end of the tracer experiment, after a travel time of 328 days for Br and 87 days for Cl, respectively, the transect was excavated and sampled in high spatial resolution. Tracer concentration, water content, water drop penetration times (WDPT), and soil organic matter content (SOM) of each sample were analyzed in order to characterize flow patterns. The TDR readings were used to predict the effective cross section (ECS) of subsurface flow and flow shifts over the season.During summer, when ECS is low and consecutive precipitation events occur, flow paths – once created – persist over time. However, over longer times (from autumn to autumn), the spatial arrangements of the flow paths can change completely. The Cl distribution showed typical fingering structures with high concentrations in the less water repellent flow paths. In contrast, Br was found mostly in the dry, hydrophobic areas indicating that it was transported before the soil became water repellent. Consequently, the flow patterns generated in spring and early summer differ completely from those in autumn and winter because of water repellent structures established during the vegetative period. These structures could be identified using a critical water content (θ_crit) concept, considering both soil water content and SOM.As not all soil parts being active during to season, four flow categories could be identified: about 10% permanent (=stable flow paths), 45% periodic (i.e. water repellent in summer), 40% occasional (water repellent in summer and autumn), and 5% permanent water repellent.     

Water condition control of in situ soil water repellency: an observational study from a hillslope in a Japanese humid‐temperate forest

To evaluate the relationship between the moisture conditions and the water repellency of soil surfaces in situ, we periodically conducted field surveys for more than a year in a humid‐temperate forest in Japan. Measurements were made in four plots with varying soil physicochemical properties and under different topographic conditions across a hillslope. Each plot contained permanent quadrats with measurement points in a grid pattern. At each point, we measured the volumetric water content at 0‐ to 5‐cm depths and the water repellency at soil surfaces approximately twice a month. The repeated measurements enabled us to estimate the critical water content (CWC) below which soils repelled water at each point. We defined the representative CWC (RCWC) of a plot as the median of all CWCs in a plot and estimated the representative critical water potential (RCWP) on the basis of the RCWC using the water retention curve. The RCWC values differed among plots, but the corresponding RCWP values were similar (pF = 3.5–3.9). The relationship of the areal fraction showing water repellency against soil water potentials was similar across plots, but the relationship differed among plots against the soil moisture content. These results suggest that soil water potential is more indicative of the spatial occurrence of water repellency than moisture content on a hillslope where soil physicochemical properties vary. Plots located on ridge crests frequently exhibited lower water potentials and showed a higher areal fraction of water repellency, implying a greater chance of generating surface runoff by rainfall events. Copyright © 2011 John Wiley & Sons, Ltd.     

Soil water content in southern England derived from a cosmic‐ray soil moisture observing system – COSMOS‐UK

Cosmic‐ray soil moisture sensors have the advantage of a large measurement footprint (approximately 700 m in diameter) and are able to operate continuously to provide area‐averaged near‐surface (top 10–20 cm) volumetric soil moisture content at the field scale. This paper presents the application of this technique at four sites in southern England over almost 3 years. Results show the soil moisture response to contrasting climatic conditions during 2011–2014 and are the first such field‐scale measurements made in the UK. These four sites are prototype stations for a UK COsmic‐ray Soil Moisture Observing System, and particular consideration is given to sensor operating conditions in the UK. Comparison of these soil water content observations with the Joint UK Land Environment Simulator 10‐cm soil moisture layer shows that these data can be used to test and diagnose model performance and indicate the potential for assimilation of these data into hydro‐meteorological models. The application of these large‐area soil water content measurements to evaluate remotely sensed soil moisture products is also demonstrated. Numerous applications and the future development of a national COsmic‐ray Soil Moisture Observing System network are discussed. Copyright © 2016 John Wiley & Sons, Ltd.     

Seasonal soil water dynamics in the jarrah forest,Western Australia. II: Results from a site with fine-textured soil profiles

Seasonal soil water dynamics were measured at a fine-textured, upslope site within the jarrah forest of southwest Western Australia and compared to the results from a coarse-textured hillslope transect. Gravity drainage dominated during winter and early spring. This reversed in early summer and an upward potential gradient was observed to 7 m depth. A shallow ephemeral saturation zone was observed above a clay pan at 1.5 m depth. This saturation zone persisted through late winter and early spring, contrasting with the short-lived saturation in the duricrust on the hillslope transect. The annual maximum to minimum unsaturated soil water storage was about 530 mm, 50 mm greater than the hillslope transect and higher than most values reported elsewhere in Australia. Significant soil water content changes following winter rain were generally restricted to 6 m but at one site occurred to 9 m. These depths were significantly less than the coarser-textured hillslope transect. Soil water drying rates averaged 5 mm day^?1 during extended dry periods compared to 3.5 mm day^?1 on the hillslope transect. The drying rate occurred uniformly through the profile until late summer when a significant decrease in the upper 3 m was observed.     

Seasonal soil water dynamics in the jarrah forest,Western Australia. I: Results from a hillslope transect with coarse-textured soil profiles

Seasonal soil water dynamics were measured on a hillslope transect in the jarrah forest of southwest Western Australia over the period 1984-86 using mercury manometer tensiometers, gypsum blocks, and a neutron moisture meter. The soil water potential gradients indicated downward vertical drainage flux through winter and spring. There was generally a change to an upwards flux in early summer which was sustained through to autumn. A shallow ephemeral saturation zone was identified in and above a duricrust layer, lasting up to three days after heavy, late winter rainfall. The annual maximum to minimum unsaturated soil water storage on the hillslope was approximately 400 mm to 6 m depth and 480 mm to 15 m depth. This did not change significantly in years of substantially different winter rainfall. The magnitude of seasonal soil water storage was similar to other forested areas with deep soil profiles. The depth of observable infiltration was dependent on annual rainfall. This was consistent with the observation that groundwater levels responded to rainfall over the whole hillslope in wet years but only responded on the lower slopes in dry years. The average summer drying rate of the soil profile to 6 m depth of 3.5 mm day^?1 was within the range of values reported for forests elsewhere. In late summer, following an extended drought period, the drying rate decreased downslope but increased midslope.