四川汶川5.12大地震同震滑动断层泥的发现及构造意义

2008年汶川8．0级地震沿龙门山断裂带内的映秀-北川断裂和灌县-安县断裂产生了近300km的同震地表破裂带。震后地质科学考察发现地表变形以逆冲为主,并伴有右旋走滑。地震地表破裂带大多沿古生代碳质泥岩、页岩和三叠系煤系地层内的滑动面出露地表,这些软弱地层为地震破裂带冲到地表提供了超低摩擦滑动带。我们发现在同震垂直和水平位错达6m左右的地袁破裂带,地震的同震滑动发生在厚度约O．5—2cm的狭窄滑动带内,以发育新鲜的灰色断层泥为特征,这些断层泥是地震断层快速滑动过程中岩石-流体相互作用的结果。     

四川汶川5.12大地震同震滑动断层泥的发现及意义

2008年汶川8.0级地震沿龙门山断裂带内的映秀—北川断裂和灌县—安县断裂产生了近300 km的同震地表破裂带。震后地质科学考察发现地表变形以逆冲为主,并伴有右旋走滑。地震地表破裂带大多沿古生代碳质泥岩、页岩和三叠系煤系地层内的滑动面出露地表,这些软弱地层为地震破裂带冲到地表提供了超低摩擦滑动带。我们发现在同震垂直和水平位错达6m左右的地表破裂带,地震的同震滑动发生在厚度约0.5~2cm 的狭窄滑动带内,以发育新鲜的灰色断层泥为特征,这些断层泥是地震断层快速滑动过程中岩石—流体相互作用的结果。     

Comminution and fluidization of granular fault materials: implications for fault slip behavior

Whilst faulting in the shallow crust is inevitably associated with comminution of rocks, the mechanical properties of the comminuted granular materials themselves affect the slip behavior of faults. Therefore, the mechanical behavior of any fault progresses along an evolutionary path. We analyzed granular fault rocks from four faults, and deduced an evolutionary trend of fractal size frequency. Comminution of fault rocks starts at a fractal dimension close to 1.5 (2-D measurement), at which a given grain is supported by the maximum number of grains attainable and hence is at its strongest. As comminution proceeds, the fractal dimension increases, and hence comminution itself is a slip weakening mechanism. Under the appropriate conditions, comminuted granular materials may be fluidized during seismic slip events. In this paper, we develop a new method to identify the granular fault rocks that have experienced fluidization, where the detection probability of fragmented counterparts is a key parameter. This method was applied to four fault rock samples and a successful result was obtained. Knowledge from powder technology teaches us that the volume fraction of grains normalized by maximum volume fraction attainable is the most important parameter for dynamic properties of granular materials, and once granular fault materials are fluidized, the fault plane becomes nearly frictionless. A small decrease in the normalized volume fraction of grains from 1 is a necessary condition for the phase transition to fluidization from the deformation mechanism governed by grain friction and crushing by contact stresses. This condition can be realized only when shearing proceeds under unconstrained conditions, and this demands that the gap between fault walls is widened. Normal interface vibration proposed by Brune et al. [Tectonophysics 218 (1993) 59] appears to be the most appropriate cause of this, and we presented two lines of field evidence that support this mechanism to work in nature.     

Apatite and zircon fission-track dating from the Hirabayashi-NIED borehole, Nojima Fault, Japan: Evidence for anomalous heating in fracture zones

Fission-track (FT) analysis using apatite and zircon was performed on samples from two fracture zones (FZ) at the depths of 1140 and 1310 m within the 1838 m borehole core penetrating the Ryoke Granitic Rocks in the Nojima Fault at Nojima-Hirabayashi, Awaji Island, Japan, drilled just after the 1995 Hyogo-ken Nanbu earthquake. Clear discordance in apatite and zircon FT age was found for two samples located at  2 m below the central part of each FZs where the presence of pseudotachylyte and/or fault gouge would predict the largest amount of slip. Asymmetric distribution was identified by discordant ages with respect to the central part of FZs. These very local discordant ages in the fault reflect thermal anomalies caused by secondary heating with an inferred maximum temperature in the region between apatite and zircon closure temperatures at a time post-48 Ma. As a source of the secondary heating, heat transfer or dispersion via geothermal fluids caused presumably the observed similarity in asymmetric distribution of discordant FT ages at two different FZs. Other samples yield concordant FT zircon and apatite ages and these indicate rapid cooling within the bounds of two closure temperatures of these minerals at  60 Ma of the Ryoke Granitic Rocks.