Observations of the evolution of the aerosol, cloud and boundary‐layer characteristics during the 1st ACE‐2 Lagrangian experiment

During the 1st Lagrangian experiment of the North Atlantic Regional Aerosol Characterisation Experiment (ACE‐2), a parcel of air was tagged by releasing a smart, constant level balloon into it from the Research Vessel Vodyanitskiy . The Meteorological Research Flight's C‐130 aircraft then followed this parcel over a period of 30 h characterising the marine boundary layer (MBL), the cloud and the physical and chemical aerosol evolution. The air mass had originated over the northern North Atlantic and thus was clean and had low aerosol concentrations. At the beginning of the experiment the MBL was over 1500 m deep and made up of a surface mixed layer (SML) underlying a layer containing cloud beneath a subsidence inversion. Subsidence in the free troposphere caused the depth of the MBL to almost halve during the experiment and, after 26 h, the MBL became well mixed throughout its whole depth. Salt particle mass in the MBL increased as the surface wind speed increased from 8 m s⁻¹ to 16 m s⁻¹ and the accumulation mode (0.1μm to 3.0 μm) aerosol concentrations quadrupled from 50 cm⁻³ to 200 cm⁻³. However, at the same time the total condensation nuclei (>3 nm) decreased from over 1000 cm⁻³ to 750 cm⁻³. The changes in the accumulation mode aerosol concentrations had a significant effect on the observed cloud microphysics. Observational evidence suggests that the important processes in controlling the Aitken mode concentration which, dominated the total CN concentration, included, scavenging of interstitial aerosol by cloud droplets, enhanced coagulation of Aitken mode aerosol and accumulation mode aerosol due to the increased sea salt aerosol surface area, and dilution of the MBL by free tropospheric air.     

Evolution of boundary‐layer aerosol particles due to in‐cloud chemical reactions during the 2nd Lagrangian experiment of ACE‐2

The second Aerosol Characterisation Experiment (ACE‐2) was aimed at investigating the physical, chemical and radiative properties of aerosol and their evolution in the North Atlantic region. In the 2nd "Lagrangian" experiment, an air mass was tracked over a 30‐h period during conditions of extensive stratocumulus cover. Boundary‐layer measurements of the aerosol size distribution obtained with a passive cavity aerosol spectrometer probe (PCASP) during the experiment show a gradual growth in size of particles in the 0.1–0.2 μm diameter mode. Simultaneously, SO₂ concentrations were found to decrease sharply from 800 to 20 ppt. The fraction of sulphate in aerosol ionic mass increased from 0.68±0.07 to 0.82±0.09 for small particles (diameter below 1.7 μm) and from 0.21±0.04 to 0.34±0.03 for large particles (diameter above 1.7 μm). The measurements were compared with a multicyclic parcel model of gas phase diffusion into cloud droplets and aqueous phase chemical reactions. The model was able to broadly reproduce the observed transformation in the aerosol spectra and the timescale for the transformation of SO₂ to sulphate aerosol. The modelled SO₂ concentration in the boundary layer fell to below half its initial value over a 6.5‐h time period due to a combination of the entrainment of cleaner tropospheric air and cloud chemical reactions. NH₃ and HCl gas were also found to play an important rôle in cloud processing in the model.     

Lagrangian air mass tracking with smart balloons during ACE‐2

A 3rd‐generation smart balloon designed at National Oceanic and Atmospheric Administration, Air Resources Laboratory Field Research Division, in collaboration with the University of Hawaii, was released from ship‐board during the recent Second Aerosol Characterization Experiment (ACE‐2) to provide Lagrangian air‐mass tracking data. ACE‐2 is the 3rd in a series of field experiments designed to study the chemical, physical, and radiative properties and processes of atmospheric aerosols and their role in climate and is organized by the international global atmospheric chemistry (IGAC) program. The adjective smart in the title of this paper refers to the fact that the buoyancy of the balloon automatically adjusts through the act of pumping air into or releasing air from the ballast portion of the balloon when it travels vertically outside a barometric pressure range set prior to release. The smart balloon design provides GPS location, barometric pressure, temperature, relative humidity, and other data via a transponder to a C130 research aircraft flying in the vicinity of the balloon. The addition of 2‐way communication allows interactive control of the balloon operating parameters by an observer. A total of 3 cloudy Lagrangian experiments were conducted during the ACE‐2 field program which lasted from 16 June through 26 July 1997. This paper reviews the design and capability of the smart balloons and their performance during the ACE‐2 Lagrangian experiments. Future development and applications of the technology are discussed.     

An overview of the ACE‐2 CLOUDYCOLUMN closure experiment

CLOUDYCOLUMN is one of the 6 ACE‐2 projects which took place in June‐July 1997, between Portugal and the Canary Islands. It was specifically dedicated to the study of changes of cloud radiative properties resulting from changes in the properties of those aerosols which act as cloud condensation nuclei. This process is also refered to as the aerosol indirect effect on climate. CLOUDYCOLUMN is focused on the contribution of stratocumulus clouds to that process. In addition to the basic aerosol measurements performed at the ground stations of the ACE‐2 project, 5 instrumented aircraft carried out in situ characterization of aerosol physical, chemical and nucleation properties and cloud dynamical and microphysical properties. Cloud radiative properties were also measured remotely with radiometers and a lidar. 11 case studies have been documented, from pure marine to significantly polluted air masses. The simultaneity of the measurements with the multi‐aircraft approach provides a unique data set for closure experiments on the aerosol indirect effect. In particular CLOUDYCOLUMN provided the 1st experimental evidence of the existence of the indirect effect in boundary layer clouds forming in polluted continental outbreacks. This paper describes the objectives of the project, the instrumental setup and the sampling strategy. Preliminary results published in additional papers are briefly summarized.     

Regional aerosol optical depth characteristics from satellite observations: ACE‐1, TARFOX and ACE‐2 results

Analysis of the aerosol properties during 3 recent international field campaigns (ACE‐1, TARFOX and ACE‐2) are described using satellite retrievals from NOAA AVHRR data. Validation of the satellite retrieval procedure is performed with airborne, shipboard, and land‐based sunphotometry during ACE‐2. The intercomparison between satellite and surface optical depths has a correlation coefficient of 0.93 for 630 nm wavelength and 0.92 for 860 nm wavelength. The standard error of estimate is 0.025 for 630 nm wavelength and 0.023 for 860 nm wavelength. Regional aerosol properties are examined in composite analysis of aerosol optical properties from the ACE‐1, TARFOX and ACE‐2 regions. ACE‐1 and ACE‐2 regions have strong modes in the distribution of optical depth around 0.1, but the ACE‐2 tails toward higher values yielding an average of 0.16 consistent with pollution and dust aerosol intrusions. The TARFOX region has a noticeable mode of 0.2, but has significant spread of aerosol optical depth values consistent with the varied continental aerosol constituents off the eastern North American Coast.     

Size‐segregated chemical, gravimetric and number distribution‐derived mass closure of the aerosol in Sagres, Portugal during ACE‐2

During the ACE‐2 field campaign in the summer of 1997 an intensive, ground‐based physical and chemical characterisation of the clean marine and continentally polluted aerosol was performed at Sagres, Portugal. Number size distributions of the dry aerosol in the size range 3–10 000 nm were continuously measured using DMPS and APS systems. Impactor samples were regularly taken at 60% relative humidity (RH) to obtain mass size distributions by weighing the impactor foils, and to derive a chemical mass balance by ion and carbon analysis. Hygroscopic growth factors of the metastable aerosol at 60% RH were determined to estimate the number size distribution at a relative humidity of 60%. A size segregated 3‐way mass closure study was performed in this investigation for the first time. Mass size distributions at 60% RH derived from number size distribution measurements and impactors samples (weighing and chemical analysis) are compared. A good agreement was found for the comparison of total gravimetrically‐determined mass with both number distribution‐derived (slope=1.23/1.09; R²>0.97; depending on the parameters humidity growth and density) and chemical mass concentration (slope=1.02; R²= 0.79) for particles smaller than 3 μm in diameter. Except for the smallest impactor size range relatively good correlations (slope=0.86–1.42) with small deviations (R²=0.76–0.98) for the different size fractions were found. Since uncertainties in each of the 3 methods are about 20% the observed differences in the size‐segregated mass fractions can be explained by the measurement uncertainties. However, the number distribution‐derived mass is mostly higher than the chemically and gravimetrically determined mass, which can be explained by sampling losses of the impactor, but as well with measurement uncertainties as, e.g., the sizing of the DMPS/APS.     

Microphysical properties of stratocumulus clouds during ACE‐2

Microphysical measurements performed during 8 flights of the CLOUDYCOLUMN component of ACE‐2, with the Meteo‐France Merlin‐IV, are analyzed in terms of droplet number concentration and size. The droplet concentration is dependent upon the aerosol properties within the boundary layer. Its mean value over a flight varies from 55 cm⁻³, for the cleanest conditions, to 244 cm⁻³, for the most polluted one. For each flight, the variability of the concentration, in selected cloud regions that are not affected by mixing with dry air or drizzle scavenging, ranges from 0.5 to 1.5 of the mean value. The mean volume diameter increases with altitude above cloud base according to the adiabatic cloud model. The frequency distribution of mean droplet volume normalized by the adiabatic value, for the selected regions, shows the same dispersion as the distribution of normalized concentration. The values of droplet concentration versus mean volume diameter are then examined in sub‐adiabatic samples to characterize the effects of mixing and drizzle scavenging. Finally, the ratio of mean volume diameter to effective diameter is analyzed and a simple relationship between these 2 crucial parameters is proposed.     

Cloud condensation nuclei and cloud droplet measurements during ACE‐2

During the 2nd Aerosol Characterization Experiment (ACE‐2), relationships between stratocumulus cloud properties and aerosols were examined. Here, the relevant measurements including the cloud condensation nuclei (CCN) activation spectrum, updraft velocity, cloud microphysical and aerosol properties are presented. It is shown that calculations of droplet concentration based on updraft velocity and the CCN activation spectrum are consistent with direct observations. Also discussed is an apparent disparity among measurements of the CCN activation spectrum, the accumulation mode size distribution, and the composition of the submicrometric aerosol. The observed consistency between CCN, updraft and cloud droplets is a necessary refinement; however, extended analyses of the ACE‐2 data set are needed to guide improvements in model simulations of the interaction between aerosols and cloud microphysics. In particular, there is need for an examination of aerosol size spectra and chemical composition measurements with a view towards validating droplet activation schemes which relate the aerosol and cloud dynamical properties to cloud albedo.