Upper mantle and lithospheric heterogeneities in central and eastern Europe as observed by teleseismic receiver functions

Data from 90 permanent broad-band stations spread over central and eastern Europe were analysed using Ps receiver functions to study the crustal and upper-mantle structure down to the mantle transition zone. Receiver functions provide valuable information on structural features, which are important for the resolution of European lithospheric dynamics. Moho depths vary from less than 25 km in extensional areas in central Europe to more than 50 km at stations in eastern Europe (Craton) and beneath the Alpine–Carpathian belt. A very shallow Moho depth can be observed at stations in the Upper Rhine Graben area ( ca. 25 km), whereas, for example, stations in the SW Bohemian Massif show a significantly deeper Moho interface at a depth of 38 km. V_p / V_s ratios vary between 1.60 and 1.96, and show no clear correlation to the major tectonic units, thus probably representing local variations in crustal composition. Delayed arrivals of converted phases from the mantle transition zone are observed at many stations in central Europe, whereas stations in the cratonic area show earlier arrivals compared with those calculated from the IASP91 Earth reference model. Differential delay times between the P₄₁₀s and P₆₆₀s phases indicate a thickened mantle transition zone beneath the eastern Alps, the Carpathians and the northern Balkan peninsula, whereas the transition zone thickness in eastern and central Europe agrees with the IASP91 value. The thickening of the mantle transition zone beneath the eastern Alps and the Carpathians could be caused by cold, deeply subducted oceanic slabs.     

A study of shallow global mantle flow due to the accretion and subduction of lithospheric plates

Summary. Models of shallow, global mantle circulation due to the accretion and subduction of lithospheric plates are formulated as potential theory problems on a sphere. Subducting and accreting plate boundaries represent sources and sinks respectively for the sublithospheric flow. Solutions, which are obtained by finite difference approximations, give the instantaneous flow velocities within the asthenosphere compatible with plate boundaries and relative plate motions. Results are presented for present-day plate boundaries and relative plate motions for the case of a uniform viscosity asthenosphere and for that of a low viscosity zone at the base of the lithosphere. These results are discussed in terms of available geophysical data. Some of the implications of a shallow, mantle-wide circulation are also considered.     

Horizontal layered structure with heterogeneity beneath continents and island arcs from particle orbits of long-period P waves

We investigate the particle orbits of long-period (about 20 s) P waves observed with the global seismic network. By analysing 84 three-component seismograms recorded at 25 stations from 60 earthquakes occurring beneath 300 km, we quantitatively evaluate the orbits by three sets of eigenvalues and eigenvectors, using a covariance matrix method. The eigenvalues for P waves recorded at stations located on continents are explained by the standard horizontal layered structure model (iasp91). On the other hand, the orbits observed at stations close to island arcs are affected not only by the horizontal layered structure but also by heterogeneity due to subducting plates, mantle diapirs and so on. On the basis of a single-scattering model for a plane P wave, we quantify the heterogeneities by an isotropic scattering coefficient g0. Fitting the theoretical eigenvalues to the observed ones, we estimate g0 for the crust and upper mantle beneath continents to be less than 0.0005 km^-1, and the mean g₀ for the structure beneath island arcs to be about 0.0015 to 0.003 km^-1.     

Impact of regional mantle flow on subducting plate geometry and interplate stress: insights from physical modelling

Physical models of subduction investigate the impact of regional mantle flow on the structure of the subducted slab and deformation of the downgoing and overriding plates. The initial mantle flow direction beneath the overriding plate can be horizontal or vertical, depending on its location with respect to the asthenospheric flow field. Imposed mantle flow produces either over or underpressure on the lower surface of the slab depending on the initial mantle flow pattern (horizontal or vertical, respectively). Overpressure promotes shallow dip subduction while underpressure tends to steepen the slab. Horizontal mantle flow with rates of 1–10 cm yr⁻¹ provides sufficient overpressure on a dense subducting lithosphere to obtain a subduction angle of  ∼60°  , while the same lithospheric slab sinks vertically when no flow is imposed. Vertical drag force (due to downward mantle flow) exerted on a slab can result in steep subduction if the slab is neutrally buoyant but fails to produce steep subduction of buoyant oceanic lithosphere. The strain regime in the overriding plate due to the asthenospheric drag force depends largely on slab geometry. When the slab dip is steeper than the interplate zone, the drag force produces negative additional normal stress on the interplate zone and tensile horizontal stress in the overriding plate. When the slab dip is shallower than the interplate zone, an additional positive normal stress is produced on the interplate zone and the overriding plate experiences additional horizontal compressive stress. However, the impact of the mantle drag force on interplate pressure is small compared to the influence of the slab pull force since these stress variations can only be observed when the slab is dense and interplate pressure is low.     

Variation in style of magmatism and emplacement mechanism induced by changes in basin environments and stress fields (Pannonian Basin,Central Europe)

The development of high‐resolution 3D seismic cubes has permitted recognition of variable subvolcanic features mostly located in passive continental margins. Our study area is situated in a different tectonic setting, in the extensional Pannonian Basin system (central Europe) where the lithospheric extension was associated with a wide variety of magmatic suites during the Miocene. Our primary objective is to map the buried magmatic bodies, to better understand the temporal and spatial variation in the style of magmatism and emplacement mechanism within the first order Mid‐Hungarian Fault Zone (MHFZ) along which the substantial Miocene displacement took place. The combination of seismic, borehole and log data interpretation enabled us to delineate various previously unknown subvolcanic‐volcanic features. In addition, a new approach of neural network analysis on log data was applied to detect and quantitatively characterise hydrothermal mounds that are hard to interpret solely from seismic data. The volcanic activity started in the Middle Miocene and induced the development of extrusive volcanic mounds south of the NE‐SW trending, continuous strike‐slip fault zone (Hajdú Fault Zone). In the earliest Late Miocene (11.6–9.78 Ma), the style of magmatic activity changed resulting in emplacement of intrusions and development of hydrothermal mounds. Sill emplacement occurred from south‐east to north‐west based on primary flow‐emplacement structures. The time of sill emplacement and the development of hydrothermal mounds can be bracketed by onlapped forced folds and mounds. This time coincided with the acceleration of sedimentation producing poorly consolidated, water‐saturated sediments preventing magma from flowing to the paleosurface. The change in extensional direction resulted in change in fault pattern, thus the formerly continuous basin‐bounding strike‐slip fault became segmented which could facilitate the magma flow toward the basin centre.