Numerical Simulation of Dynamic Response of A Net Cage for Flatfish in Waves简

A numerical model of flatfish cage is built based on the lumped mass method and the principle of rigid body kinematics. To validate the numerical model, a series of physical model tests are conducted in the wave flume. The numerical results correspond well with the data sets from physical model test. The effect of weight of bottom frame, height of fish net and net shape on motion responses of fish cage and tension force on mooring lines is then analyzed. The results indicate that the vertical displacements of float collar and bottom frame decrease with the increase in the weight of bottom frame; the maximum tension force on mooring lines increases with the increasing weight of bottom frame. The inclination angles of float collar and bottom frame decrease with the increasing net height; the maximum tension force increases obviously with the increase of net height.     

The Effect of the Propeller Jet on Pile Groups简

The objective of this study is to determine the effect of jet propeller on the damage of berthing structures combined of armoured slope with pile groups. For this purpose, scour measurements were performed for four types berthing structures, which were armoured slope with tandem arrangements of piles for two and three piles and with side by side arrangements of piles for two and three piles. The effect of gap between piles on damage was investigated. The damage level induced by propeller jet between piles was determined. The gaps were 1, 2, 3, and 4 times the pile diameter. Three different values of Rpm （690, 820, and 950） were chosen for the tests. The diameter of circular piles is 40 mm. The slope ratio was 1/3 and the diameter of propeller was 10 cm.     

An Improved Coupling of Numerical and Physical Models for Simulating Wave Propagation简

An improved coupling of numerical and physical models for simulating 2D wave propagation is developed in this paper. In the proposed model, an unstructured finite element model （FEM） based Boussinesq equations is applied for the numerical wave simulation, and a 2D piston-type wavemaker is used for the physical wave generation. An innovative scheme combining fourth-order Lagrange interpolation and Runge-Kutta scheme is described for solving the coupling equation. A Transfer function modulation method is presented to minimize the errors induced from the hydrodynamic invalidity of the coupling model and/or the mechanical capability of the wavemaker in area where nonlinearities or dispersion predominate. The overall performance and applicability of the coupling model has been experimentally validated by accounting for both regular and irregular waves and varying bathymetry. Experimental results show that the proposed numerical scheme and transfer function modulation method are efficient for the data transfer from the numerical model to the physical model up to a deterministic level.     

Modeling and Simulation of Supercavity with Inertial Force in the Horizontal Curvilinear Motion

To make a curvilinear motion in the horizontal plane is one of the most contents for realizing the maneuverability of the supercavitating vehicle. It is significant to achieve the controllability and maneuverability of the vehicle in three dimensions both theoretically and practically on research. Models of angle of attack, gravity and inertial force effects on the supercavity in the horizontal curvilinear motion are established, respectively. The supercavity is simulated based on these models in combination with Logvinovich model and the unsteady gas-leakage rate model at the given ventilation rate, and the effect of the inertial force on it is analyzed numerically. Results show that the maximum deviation of the center line of the cross section of supercavity towards the outward normal direction of its trajectory increases as the cavitation number or curvature radius decrease and always occur in the tail because of the increase of inertial effects along the axis of supercavity from the cavitator when other models and flow parameters are constant for the given trajectory curvature. For the variable curvature, the supercavity sheds due to its instability caused by the time-varying angle of attack. The deviation increases along the length of supercavity if the curvature remains the same sign.     

Assessment of the effect of mooring systems on the horizontal motions with an equivalent force to model

The present work was carried out to assess the performance of an equivalent force model for the rapid analysis of mooring lines subject to horizontal motions. The verification is performed for cases of practical interest. Due to the very distinct behaviour of slack, moderately slack and taught moorings, these are analysed separately and the variation in the model coefficients is justified. It is shown that the methodology provides reasonable estimates of the mooring line behaviour. The final equation is very simple to introduce into a vessel motion program and is also thought to be useful in controller design or stability analysis.     

一般曲线坐标系下波浪传播的数值模拟

在曲线坐标系下,建立了缓变水深水域波浪传播的数值模拟模型.模型适宜于复杂变化的边界形状,克服了各种代数坐标变换的局限性.在建立模型时,将原始的椭圆型缓坡方程的近似型式——依赖时间变化的抛物型方程,作为控制方程,既克服了一般抛物近似方法的缺点,又便利了方程的求解;从开边界条件、不同反射特性的固壁边界条件相统一的表达式出发,对边界条件进行处理;用ADI法数值求解控制方程.对模型的验证表明,数值解与物模实验值吻合良好,模型对于具有复杂边界的工程实际有较强的适应性.     

Numerical simulation of wave-induced currents combined with parabolic mild-slope equation in curvilinear coordinates

Researches on breaking-induced currents by waves are summarized firstly in this paper. Then, a combined numerical model in orthogonal curvilinear coordinates is presented to simulate wave-induced current in areas with curved boundary or irregular coastline. The proposed wave-induced current model includes a nearshore current module established through orthogonal curvilinear transformation form of shallow water equations and a wave module based on the curvilinear parabolic approximation wave equation. The wave module actually serves as the driving force to provide the current module with required radiation stresses. The Crank-Nicolson finite difference scheme and the alternating directions implicit method are used to solve the wave and current module, respectively. The established surf zone currents model is validated by two numerical experiments about longshore currents and rip currents in basins with rip channel and breakwater. The numerical results are compared with the measured data and published numerical results.     

Wave motion over a submerged breakwater with an upper horizontal porous plate and a lower horizontal solid plate

This study examines the hydrodynamic performance of a modified two-layer horizontal-plate breakwater. The breakwater consists of an upper submerged horizontal porous plate and a lower submerged horizontal solid plate. By means of the matched eigenfunction expansion method, a linear analytical solution is developed for the interaction of water waves with the structure. Then the reflection coefficient, the transmission coefficient, the energy-loss coefficient and the wave forces acting on the plates are calculated. The numerical results obtained for limiting cases are exactly the same as previous predictions for a single submerged horizontal solid plate and a single submerged horizontal porous plate. Numerical results show that with a suitable geometrical porosity of the upper plate, the uplift wave forces on both plates can be controlled at a low level. Numerical results also show that the transmission coefficient will be always small if the dimensionless plate length (plate length versus incident wavelength) exceeds a certain moderate value. This is rather significant for practical engineering, as the incident wavelength varies over a wide range in practice. Moreover, it is found that the hydrodynamic performance of the present structure may be further enhanced if the lower plate is also perforated.     

Tide simulation using the mild-slope equation with Coriolis force and bottom friction

Since the mild-slope equation was derived by Berkhoff (1972),the researchers considered various mechanism to simplify and improve the equation,which has been widely used for coastal wave field calculation.Recently,some scholars applied the mild-slope equation in simulating the tidal motion,which proves that the equation is capable to calculate the tide in actual terrain.But in their studies,they made a lot of simplifications,and did not consider the effects of Coriolis force and bottom friction on tidal wave.In this paper,the first-order linear mild-slope equations are deduced from Kirby mild-slope equation including wave and current interaction.Then,referring to the method of wave equations’ modification,the Coriolis force and bottom friction term are considered,and the effects of which have been performed with the radial sand ridges topography.Finally,the results show that the modified mild-slope equation can be used to simulate tidal motion,and the calculations agree well with the measurements,thus the applicability and validity of the mild-slope equation on tidal simulation are further proved.     

Study on scattering wave force of horizontal and vertical plate type breakwaters

The interaction between wave and horizontal and vertical plates is investigated by the boundary element method,and the relations of wave exciting force with plate thickness,submergence and length are obtained.It is found that:1) The efficient wave exciting force exists while plate submergence is less than 0.5 m,and the plate is very thin with order O(0.005 m).2) The maximum heave wave exciting force exists,and it is the main factor for surface and submerged horizontal plate while the roll force can be ignored.3) The maximum sway wave exciting force exists,it is the main factor for surface or submerged vertical plate,and the roll force is about 20 times of horizontal plate.     

Numerical and simplified methods for the calculation of the total horizontal wave force on a perforated caisson with a top cover

The VOF method and the k–ε model, combined with the equation of state of air at constant temperature, have been used to calculate the total horizontal wave force caused by monochromatic waves acting on a perforated caisson with a top cover. From comparison of various parameters, such as the total horizontal force, the pressure difference on the front wall, the pressure on the back wall and the pressure on the top cover, between the numerical results and test data, it can be seen that the numerical results agree well with the test data. It is concluded that the method described in this paper can be utilized to calculate wave forces acting on perforated caissons with a top cover in the case of nonovertopping, nonbreaking waves. A simplified method to calculate the total horizontal force has been developed, based on test data, using a least-squares method. A comparison between the numerical results and the values calculated from the simplified equations shows good agreement. Therefore the simplified equations can be used in engineering applications to evaluate the total horizontal force on a perforated caisson with a top cover.     

Numerical study of the motions and drift force of a floating OWC device

The motion and the drift force of a floating OWC (oscillating water column) wave energy device in regular waves are studied taking account of the oscillating surface-pressure due to the pressure drop across the duct of the air chamber. The potential problem inside the chamber is formulated by making use of the Green integral equation associated with the Rankine-type Green function while the outer problem with the Kelvin-type Green function. The added mass, wave damping and excitation coefficients as well as the motion and drift force of the OWC device are calculated for various values of parameter related to the pressure drop.     

不同运动自由度组合串列双圆柱涡激振动数值模拟

基于自主研发的紧致插值曲线CIP (Constrained Interpolation Profile)方法数学模型,对均匀来流条件时不同运动自由度组合下的串列双圆柱涡激振动问题开展二维数值模拟。模型针对雷诺数Re=100,质量比m*=2的串列双圆柱涡激振动问题,选取上、下游圆柱不同运动自由度组合工况进行模拟。重点分析圆柱的升阻力系数、运动位移随折合速度Ur变化的响应。研究表明:当上游圆柱双自由度运动时,随着下游圆柱运动自由度的增加,下游圆柱对上游圆柱涡激振动响应的影响减弱;当下游圆柱双自由度运动时,随着上游圆柱运动自由度的增加,上游圆柱对下游圆柱涡激振动响应的影响变强。研究结果表明圆柱运动自由度组合形式对串列双圆柱涡激振动的影响不可忽略。