A distinction technique between volcanic and tectonic depression structures based on the restoration modeling of gravity anomaly: a case study of the Hohi volcanic zone, central Kyushu, Japan

In this study, we propose a numerical modeling technique which restores the gravity anomaly of tectonic origin and identifies the gravity low of caldera origin. The identification is performed just by comparing the restored gravity anomalies with the observed gravity anomalies, thus we do not need detailed geophysical and geological information around the buried caldera. The technique has been successfully applied to distinguish the gravity low originated in the buried Shishimuta caldera from other gravity lows in the Hohi volcanic zone, central Kyushu in Japan.     

Variations in thickness of fault‐controlled dikes and its implications: A case study of Gosung area,South‐East Korea

Dikes are natural records that can be used to understand the way magma flows in the crust. Coastal platform outcrops in Gosung, South Korea, show clear evidences that their intrusion took place along pre‐existing fractures. We analyzed outcropping dikes, measuring variations in dike thickness as well as fracture density (cumulative number of fractures along strike) and geometry around the dikes. The geometry and thickness variations of dikes intruded along pre‐existing fractures can be interpreted to understand the effect of pre‐existing fractures to evolution on magma flow, especially related with fault damage zones. This helps us to gain a better understanding of magma and fluid flow along pre‐existing fractures. Magma flow is greater along planes that strike perpendicular to the direction of least compressive horizontal stress, and along well connected fractures that show a high degree of connectivity. At the fault tip and linkage damage zone, there is a concentration of extensional fractures; in these areas injected dikelets can form. As faults become linked, the fracture density increases, until they become fully linked and act as one through‐going fault plane. As faults evolve, the boundary conditions of the faults vary and this has an impact on dike characteristics. Fracture geometry around dikes that intruded pre‐existing faults can be used as a record of fault evolution and this can give insights into how the maturity of a fault system can affect to the related magma or fluid flow characteristics.     

The effect of a hydrous phase on P‐wave velocity anisotropy within a detachment shear zone in the slow‐spreading oceanic crust: A case study from the Godzilla Megamullion,Philippine Sea

We studied the contributions of plagioclase, clinopyroxene, and amphibole to the P‐wave velocity properties of gabbroic mylonites of the Godzilla Megamullion (site KH07‐02‐D18) in the Parece Vela Rift of the central Parece Vela Basin, Philippine Sea, based on their crystal‐preferred orientations (CPOs), mineral modes, and elastic constants and densities of single crystals. The gabbroic mylonites have been classified into three types based on their microstructures and temperature conditions: HT1, HT2 and medium‐temperature (MT) mylonites. The P‐wave velocity properties of the HT1 mylonite are dominantly influenced by plagioclase CPOs. Secondary amphibole occurred after deformation in the HT1 mylonite, so that its effect on P‐wave velocity anisotropy is minimal due to weak CPOs. Although the HT2 mylonite developed deformation microstructures in the three minerals, the P‐wave velocity properties of the HT2 mylonite are essentially isotropic, resulting from the destructive interference of different P‐wave velocity anisotropy patterns produced by the distinct CPOs of the three constituent minerals (i.e., plagioclase, clinopyroxene, and amphibole). The P‐wave velocity properties of the MT mylonite are influenced mainly by amphibole CPOs, whereas the effect of plagioclase CPOs on P‐wave velocity anisotropy becomes very small with a decrease in the intensity of plagioclase CPOs. As a result, the gabbroic mylonites tend to have weak P‐wave velocity anisotropy in seismic velocity, although their constituent minerals show distinct CPOs. Such weakness in the whole‐rock P‐wave velocity anisotropy could result from the destructive contributions of the different mineral CPOs with respect to the structural framework (foliation and lineation). These results show that amphibole has a high potential for P‐wave velocity anisotropy by aligning both crystallographically and dimensionally during deformation in the hydrous oceanic crust. The results also suggest that the effect of a hydrous phase on P‐wave velocity anisotropy within the detachment shear zone in a slow‐spreading oceanic crust varies depending on the degree of deformation and on the timing of hydrothermal activity.     

Integrated description of deformation modes in a sedimentary basin: A case study around a shallow drilling site in the Mizunami area, eastern part of southwest Japan

Abstract   Tectonic episodes in a sedimentary basin are described on the basis of an integrated study combining reflection seismic interpretation, drilling survey and paleomagnetism. A shallow inclined borehole penetrated a fault shown by reflection seismic and geological surveys in the Mizunami area, in the eastern part of southwest Japan. Paleomagnetic measurements were carried out on core samples successfully oriented using side-wall image logging of structural attitude. At six horizons, stable characteristic remanent magnetization (ChRM) was confirmed through thermal and alternating field demagnetization tests, which were carried by magnetite with minor amounts of high coercivity minerals, as revealed by experiments of stepwise acquisition of isothermal remanent magnetization. After correction of multiphase deformation inferred from borehole structural analysis, ChRM directions were combined with previous data and confirmed an easterly deflection reflecting the coherent clockwise rotation of the arc before the Middle Miocene. Compilation of reliable paleomagnetic data described differential rotation of the eastern part of southwest Japan raised by collision of the Izu–Bonin Arc since the Middle Miocene. The present study suggests that (i) the Mizunami area is adjacent to a highly deformed zone bounded by the Akaishi Tectonic Line (ATL), and (ii) forearc deformation of southwest Japan is localized around the ATL, which is quite different from gradual bending on the back-arc side without remarkable crustal break related to the collision event.