Vergleich ausgewählter Elutionsverfahren zur Beurteilung der Mobilität von Metallen

Comparison of Selected Elution Procedures for the Valuation of the Mobility of Metals from Sediment and Sewage Sludge Several methods of extraction are generally used to evaluate environmental or ecological toxicity and deposition of waste material. In this paper, the application of the German standard methods DIN 38414-S7, DIN 38414-S4, pH_stat method, “Schweizer method” (elution test, Switzerland), and some variants of the pH_stat method on two very different samples are described. A rudimental sediment and a municipal sewage sludge are chosen as sample materials. The metal contents of extract solutions are determined by ICP-OES. The results of the DIN-S4 extractions depend definitely on the mechanic way of movement, i.e. the amount of heavy metals which are mobilized out of the samples differs considerably. In fact, DIN-S7 in combination with DIN-S4 is not sufficient to estimate the mobility of heavy metals. Solid samples should only be evaluated by applying a combination of several methods of extraction. The usefulness of the pH_stat method for an evaluation is discussed.     

Distribution and Chemical Forms of Heavy Metals in the Flood 1997 Sediments of the Upper and Middle Odra River and its Tributarie:, Poland

At the beginning of August 1997, 72 samples of flood sediments were taken along the Upper and Middle Odra river and its tributaries. The concentrations of Zn, Pb, Cu, Cd, Co, Ni, Cr, Mn, and Fe in the bulk samples and in the <20 μm fraction were determined by AAS method. The contents of metals vary in wide ranges and are significantly higher in the <20 μm fraction of sediments. The range concentrations vary as following: Zn 274...3 656 mg/kg, Pb 79...1 773 mg/kg, Cd 1.7...11.8 mg/kg, Cu 38...2 244 mg/kg, Cr 14...384 mg/kg, Co 4...73 mg/kg, Hg 0.2...3.9 mg/kg, Mn 214...6 972 mg/kg, and Fe 1.5...16.3 %. The highest amount of the metals was found in the Wrocław and Głogów regions. The mobile (exchangeable and carbonatic fractions) portions of metals reached up to 50 % of Zn, 40 % of Pb and Cu and 60 % of Mn.     

Applicability of Single and Sequential Extractions for Assessing the Potential Mobility of Heavy Metals in Contaminated Soils

Heavy metal polluted sites are bearing an acute hazardous risk for the groundwater, but also a potential one. While the acute risk can be assessed directly via seepage water measurements, determination of the potential risk is much more complex. It results from the sum of all reactions that are capable to mobilize heavy metals under worst case environ-mental conditions. Using a fourfold sequential extraction (SE₄) such a worst case was simulated for four soils highly contaminated with Pb, Zn, and Cu. The resulting potential mobilizable amounts ϕ_pm have been compared with those derived from 6 single extractions. By means of variance analyses, it is shown that ϕ_pm of lead can be represented by a single extraction with NH₂OH. In contrary, ϕ_pm of zinc can be represented using the pH_stat test or an extraction with aqua regia, while ϕ_pm of copper can be represented only by aqua regia extraction. The water-soluble amounts deriving from the DEV-S4 test do not correlate with the potential mobilizable amounts of any metal. Therefore, an assessment of contaminated sites should include an aqua regia extraction additionally to the seepage water analysis.     

Heavy Metal Load of Sediments of the River Gurk (Carinthia/Austria) — Merits and Limitations of Sequential Leaching Schwermetallbelastung des Sediments der Gurk in Kärnten — Vorzüge und Einschränkungen sequentieller Löseverfahren

By means of the analysis of sediments cored in the small river Gurk (Carinthia/Austria), the input of Ag, Cd, Ce, Cr, Hg, La, Mo, Ni, V, and W from a chemical industrial plant could be detected. To estimate the actual load, and to obtain data for comparison with other sites, both unsieved fine sediments and sediments sieved to 20 μm were investigated from the same cores. Environmental mobilities of toxic heavy metals (Co, Cr, Cu, Ni, Zn) have been shown by sequential leaching following Tessier/Förstner. In the last step, HNO₃ leaches a purely geogenic fraction, which is fairly constant along the investigated river. Whereas the additional Cr from the input of the chemical plant is mainly found in the oxalate-leachable fraction, short-time-load to unpolluted sediments in the laboratory is found mainly in hydroxylamine/acetic acid. Both is due to the high affinity of Cr to Fe- and Mn-oxides. Adsorption/desorption experiments reveal that the low carbonate content of the Gurk sediments increases the importance of Fe/Mn-oxides for the sorption of Cr compared to other samples containing carbonate. The Ni-load was primarily found in weak-acid-leachable and oxalate-leachable fractions. Similarly, the oxalate-leachable fraction is dominant for adsorption of other metals and phosphorus. Other interelement relationships among the amounts leached, which are attributable partly to carbonate-, silicate-, organic or coating phases, have been found by means of factor analyses together with marker fractions for each type.