Surface wave array tomography in SE Tibet from ambient seismic noise and two-station analysis – II. Crustal and upper-mantle structure

We determine the 3-D shear wave speed variations in the crust and upper mantle in the southeastern borderland of the Tibetan Plateau, SW China, with data from 25 temporary broad-band stations and one permanent station. Interstation Rayleigh wave (phase velocity) dispersion curves were obtained at periods from 10 to 50 s from empirical Green's function (EGF) derived from (ambient noise) interferometry and from 20 to 150 s from traditional two-station (TS) analysis. Here, we use these measurements to construct phase velocity maps (from 10 to 150 s, using the average interstation dispersion from the EGF and TS methods between 20 and 50 s) and estimate from them (with the Neighbourhood Algorithm) the 3-D wave speed variations and their uncertainty. The crust structure, parametrized in three layers, can be well resolved with a horizontal resolution about of 100 km or less. Because of the possible effect of mechanically weak layers on regional deformation, of particular interest is the existence and geometry of low (shear) velocity layers (LVLs). In some regions prominent LVLs occur in the middle crust, in others they may appear in the lower crust. In some cases the lateral transition of shear wave speed coincides with major fault zones. The spatial variation in strength and depth of crustal LVLs suggests that the 3-D geometry of weak layers is complex and that unhindered crustal flow over large regions may not occur. Consideration of such complexity may be the key to a better understanding of relative block motion and patterns of seismicity.     

Wide-band coupling of Earth's normal modes due to anisotropic inner core structure

We investigate the importance of wide-band coupling of normal modes due to inner core anisotropy. We compare four different seismic models of inner core anisotropy, which were obtained by others using the splitting of Earth's normal modes. These models have been developed using a self-coupling (SC) approximation, which assumes that coupling between nearby modes through anisotropic inner core structure is negligible. We test the SC approximation by comparing the frequencies and quality factors of 90 inner core sensitive modes, computed for these models using either the SC approximation or full-coupling (FC) among large groups of modes. We find significant shifts in the quality factors and frequencies for some modes. Groups of modes which significantly couple together are constructed for six target modes. These groups are model dependent and in some cases contain large numbers of modes. Synthetic seismograms are calculated to show that the difference between SC and FC is observable on the scale of seismograms and of the same order of magnitude as the difference between synthetic and observed seismograms. Thus, future models of inner core anisotropy should take cross-coupling between large groups of modes into account.     

Crustal structure of Iraq from receiver functions and surface wave dispersion: implications for understanding the deformation history of the Arabian–Eurasian collision

We report the crustal structure for two locations in Iraq estimated by joint inversion of P -wave receiver functions (RFs) and surface (Rayleigh) wave group velocity dispersion. RFs were computed from teleseismic recordings at two temporary broad-band seismic stations located in Mosul (MSL) in the Zagros Fold Belt and Baghdad (BHD) in the Mesopotamian Foredeep. Group velocity dispersion curves at the sites were derived from continental-scale tomography. The inversion results show that the crustal thicknesses are 39 km at MSL and 43 km at BHD. We observe a strong Ps _Moho at BHD consistent with a sharp Moho discontinuity. However, at MSL we observe a weak Ps _Moho suggesting a transitional Moho where crustal thickening is likely to be occurring in the deep crust. Both sites reveal low velocity surface layers consistent with sedimentary thickness of about 3 km at station MSL and 7 km at BHD and agreeing well with the previous reports. Ignoring the sediments, the crystalline crustal velocities and thicknesses are remarkably similar at both stations. The similarity of crustal structure suggests that the crust of the northeastern proto-Arabian Platform was uniform before subsidence and deposition of the sediments in the Cenozoic. If crystalline crustal structure is uniform across the northern Arabian Platform then crustal thickness variations in the Zagros Fold Belt and Thrust Zone should reveal the history of deformation and crustal shortening in the Arabian–Eurasian collision zone and not reflect pre-existing crustal thickness variations in the Arabian Plate.     

Crustal and uppermost mantle structure in southern Africa revealed from ambient noise and teleseismic tomography

Rayleigh wave phase velocity maps in southern Africa are obtained at periods from 6 to 40 s using seismic ambient noise tomography applied to data from the Southern Africa Seismic Experiment (SASE) deployed between 1997 and 1999. These phase velocity maps are combined with those from 45 to 143 s period which were determined previously using a two-plane-wave method by Li & Burke. In the period range of overlap (25–40 s), the ambient noise and two-plane-wave methods yield similar phase velocity maps. Dispersion curves from 6 to 143 s period were used to estimate the 3-D shear wave structure of the crust and uppermost mantle on an 1°× 1° grid beneath southern Africa to a depth of about 100 km. Average shear wave velocity in the crust is found to vary from 3.6 km s^–1 at 0–10 km depths to 3.86 km s^–1 from 20 to 40 km, and velocity anomalies in these layers correlate with known tectonic features. Shear wave velocity in the lower crust is on average low in the Kaapvaal and Zimbabwe cratons and higher in the surrounding Proterozoic terranes, such as the Limpopo and the Namaqua-Natal belts, which suggests that the lower crust underlying the Archean cratons is probably less mafic than beneath the Proterozoic terranes. Crustal thickness estimates agree well with a previous receiver function study of Nair et al. . Archean crust is relatively thin and light and underlain by a fast uppermost mantle, whereas the Proterozoic crust is thick and dense with a slower underlying mantle. These observations are consistent with the southern African Archean cratons having been formed by the accretion of island arcs with the convective removal of the dense lower crust, if the foundering process became less vigorous in arc environments during the Proterozoic.     

Multiple-taper spectral analysis of terrestrial free oscillations: part I

We present a new method for estimating the frequencies of the Earth's free oscillations. This method is an extension of the techniques of Thomson (1982) for finding the harmonic components of a time series. Optimal tapers for reducing the spectral leakage of decaying sinusoids immersed in white noise are derived. Multiplying the data by the best K tapers creates K time series. A decaying sinusoid model is fit to the K time series by a least squares procedure. A statistical F -test is performed to test the fit of the decaying sinusoid model, and thus determine the probability that there are coherent oscillations in the data. The F -test is performed at a number of chosen frequencies, producing a measure of the certainty that there is a decaying sinusoid at each frequency. We compare this method with the conventional technique employing a discrete Fourier transform of a cosine-tapered time-series. The multiple-taper method is found to be a more sensitive detector of decaying sinusoids in a time series contaminated by white noise.