波浪方向对两矩形驳船间窄缝内流体共振影响的数值研究

应用二阶非线性三维势流时域模型模拟两个并靠矩形驳船间的窄缝内流体共振现象。模型中,速度势分解为入射势和未知的散射势,其中散射势通过求解边界积分方程计算得到。采用四阶预报校正的方法对自由水面边界条件在时间上进行数值积分。本文研究了波浪方向对窄缝内一阶、二阶波高的影响。计算结果表明,入射波浪的角度不会影响窄缝内流体的共振频率,同时窄缝内流体发生共振时,最大的共振波高总是发生在窄缝中点处。然而,共振时对应的最大波高随着入射角度的变化而变化。同时,入射波浪的频率与窄缝内流体共振频率的相对大小导致窄缝内最大波高位置向上游或者下游移动。     

海洋中波浪下迎浪驳船运动对两矩形驳船间窄缝内水体共振的影响

A three-dimensional time-domain potential flow model is developed and applied to simulate the wave resonance in a gap between two side-by-side rectangular barges. A fourth-order predict-correct method is implemented to update free surface boundary conditions. The response of an up-wave barge is predicted by solving the motion equation with the Newmark-β method. Following the validation of the developed numerical model for wave radiation and diffraction around two side-by-side barges, the influence of up-wave barge motion on the gap surfaceresonance is investigated in two different locations of the up-wave barge relative to the back-wave barge at various frequencies. The results reveal that the freely floating up-wave barge significantly influences the resonance frequency and the resonance wave amplitude. Simultaneously, the up-wave barge located in the middle of the back-wave barge leads to a reduction in the resonance wave amplitude and motion response when compared with other configurations.     

Bragg reflection in a fully nonlinear numerical wave tank based on boundary integral equation method

We investigated the phenomenon of Bragg reflection of submerged structures in a 2D fully nonlinear numerical wave tank (NWT) based on the boundary integral equation method (BIEM). This model was validated by comparing not only the free surface elevations with that of the analytic solution of Stokes’ second-order wave theory, but also the reflection coefficients of submerged bars with that from other sources. The results of the present model show that the free surface nonlinear effect on the reflection coefficient of the primary resonance reduces significantly for all of the submerged bars considered. Finally, a case study is presented to demonstrate the reflecting capacity and overall performance of various submerged bars. Results indicate that sinusoidal bar has the maximum reflection capacity at the primary resonance, but the trapezoidal submerged bar is suggested as the better option for the practical convenience of coastal underwater construction.     

Freely floating-body simulation by a 2D fully nonlinear numerical wave tank

Nonlinear interactions between large waves and freely floating bodies are investigated by a 2D fully nonlinear numerical wave tank (NWT). The fully nonlinear 2D NWT is developed based on the potential theory, MEL/material-node time-marching approach, and boundary element method (BEM). A robust and stable 4th-order Runge–Kutta fully updated time-integration scheme is used with regriding (every time step) and smoothing (every five steps). A special φ_n-η type numerical beach on the free surface is developed to minimize wave reflection from end-wall and wave maker. The acceleration-potential formulation and direct mode-decomposition method are used for calculating the time derivative of velocity potential. The indirect mode-decomposition method is also independently developed for cross-checking. The present fully nonlinear simulations for a 2D freely floating barge are compared with the corresponding linear results, Nojiri and Murayama’s (Trans. West-Jpn. Soc. Nav. Archit. 51 (1975)) experimental results, and Tanizawa and Minami’s (Abstract for the 6th Symposium on Nonlinear and Free-surface Flow, 1998) fully nonlinear simulation results. It is shown that the fully nonlinear results converge to the corresponding linear results as incident wave heights decrease. A noticeable discrepancy between linear and fully nonlinear simulations is observed near the resonance area, where the second and third harmonic sway forces are even bigger than the first harmonic component causing highly nonlinear features in sway time series. The surprisingly large second harmonic heave forces in short waves are also successfully reproduced. The fully updated time-marching scheme is found to be much more robust than the frozen-coefficient method in fully nonlinear simulations with floating bodies. To compare the role of free-surface and body-surface nonlinearities, the body-nonlinear-only case with linearized free-surface condition was separately developed and simulated.     

Wave propagation in a fully nonlinear numerical wave tank: A desingularized method

The problem of wave propagation in a fully nonlinear numerical wave tank is studied using desingularized boundary integral equation method coupled with mixed Eulerian–Lagrangian formulation. The present method is employed to solve the potential flow boundary value problem at each time step. The fourth-order predictor–corrector Adams–Bashforth–Moulton scheme is used for the time-stepping integration of the free surface boundary conditions. A damping layer near the end-wall of wave tank is added to absorb the outgoing waves with as little wave reflection back into the wave tank as possible. The saw-tooth instability is overcome via a five-point Chebyshev smoothing scheme. The model is applied to several wave propagations including solitary, irregular and random incident waves.