Recognition of Space Weather Impact on the Isophot Detectors

The effects of changes in the space environment on the ISOPHOT photoconductivedetectors over the whole ISO mission were studied using the complete setof responsivity check measurements taken after the curing of the detectors.We found that the responsivity of the Ge-based, low bias voltage far-infrared detectors (P3, C100, and C200) is sensitive to the conditions of the Space Weather.We present evidence that an increased responsivity level (20% – 50%) after curing of the detectors is linked to the onset of geomagnetic storms. TheSi-based, high bias voltage detectors P1, P2 and PHT–SS show only small changesin their responsivity. An exception is the PHT–SL array which shows a similar,but less pronounced behaviour as the FIR detectors. While these relationshave been demonstrated by our study, a detailed physical understanding is still outstanding. The Space Weather dependent scatter of the responsivity,being the photometric scaling factor (conversion from measured photo currentto inband power on the detector), justifies the observing mode design to include frequent monitoring of its actual level.     

CMOS-APS Detectors for Solar Physics: Lessons Learned during the SWAP Preflight Calibration

CMOS-APS imaging detectors open new opportunities for remote sensing in solar physics beyond what classical CCDs can provide, offering far less power consumption, simpler electronics, better radiation hardness, and the possibility of avoiding a mechanical shutter. The SWAP telescope onboard the PROBA2 technology demonstration satellite of the European Space Agency will be the first actual implementation of a CMOS-APS detector for solar physics in orbit. One of the goals of the SWAP project is precisely to acquire experience with the CMOS-APS technology in a real-live space science context. Such a precursor mission is essential in the preparation of missions such as Solar Orbiter where the extra CMOS-APS functionalities will be hard requirements. The current paper concentrates on specific CMOS-APS issues that were identified during the SWAP preflight calibration measurements. We will discuss the different readout possibilities that the CMOS-APS detector of SWAP provides and their associated pros and cons. In particular we describe the “image lag” effect, which results in a contamination of each image with a remnant of the previous image. We have characterised this effect for the specific SWAP implementation and we conclude with a strategy on how to successfully circumvent the problem and actually take benefit of it for solar monitoring.     

关于空间探测器定位在太阳系中特殊点上的有关问题

WSO／UV(世界空间紫外天文台)以及监测太阳活动的特殊探测器(Solar Sentinel)都需要在日-地(月)系的平动点附近运行，且相对日-地(月)系要求其几何位置几乎保持不变，因此有必要阐明平动点的动力学特征及其附近的运动状况。基于这一点，对限制性三体模型下，日-地(月)系中平动点附近扰动运动的稳定性作了详尽的分析，尤其讨论了共线平动点具有不稳定动力学特征时，如何使WSO／UV这类空间探测器保持在其附近的情况；同时阐明了轨道保持不变的条件和相应的轨控措施。     

1995年10月24日昆明日食观测选题

本文介绍了１９９５年１０月２４日亚洲将要发生的日全食概况。提出了届时昆明日食的观测选题。文中对时频、射电和色球观测选题的意义和可能的观测结果作了预测性的讨论。     

Tidal disruptions: II. A continuum theory for solid bodies with strength, with applications to the Solar System

We present a comprehensive theory for the breakup conditions for ellipsoidal homogeneous secondary bodies subjected to the tidal forces from a nearby larger primary: for materials ranging from purely fluid ones, to granular rubble-pile gravel-like ones, and to those with either cohesive or granular strength including cohesive rocks and metals. The theory includes but greatly extends the classical analyses given by Roche in 1847, which dealt only with fluids, and also our previous analysis [Holsapple, K.A., Michel, P., 2006. Icarus 183, 331-348], which dealt only with solid but non-cohesive bodies. The results here give the distance inside of which breakup must occur, for both a steadily orbiting satellite and for a passing or impacting object. For the fluid bodies there is a single specific shape (a “Roche Ellipsoid”) that can be in equilibrium at any given distance from a primary, and especially only one shape that can exist at the overall minimum distance (d/R)(ρ/ρp)^1/3=2.455, the classical well-known “Roche limit.” In contrast, solid bodies can exist at a given distance from a primary with a range of shapes. Here we give multiple plots of the minimum distances for various important combinations of body shape, spin, mass density, and the strength parameters characterized by an angle of friction and cohesive strength. Such results can be used in different ways. They can be used to estimate limits on strengths and mass densities for orbiting bodies at a known distance and shape. They can be used to determine breakup distances for passing bodies with an assumed strength and shape. They can be used to constraint physical properties such as bulk density of bodies with a known shape that were known to breakup at a given distance. A collection of approximately 40 satellites of the Solar System is used for comparison to the theory. About half of those bodies are closer than the Roche fluid limit and must have some cohesion and/or friction angle to exist at their present orbital distance. The required solid strength for those states is determined. Finally, we apply the theory to the break up of the SL9 comet at close approach with Jupiter. Our results make clear that the literature estimates of its bulk density depend markedly on unknown parameters such as shape, orientation and spin, and most importantly, material strength characterization.     

关于太阳射电快速活动真伪信号识别问题

本文列举了云南天文台四波段太阳射电实测中得到的几种干扰实例及确认的太阳快速信号，在认识到太阳射电和干扰信号十分相似的基础上，探讨如何识别真伪信号问题。     

云南1m太阳塔真空封窗减反射膜的设计

云南1m太阳塔(YNST)[1]是一个真空结构的塔式太阳望远镜,依靠4块平板封窗玻璃把整个光学系统密封在真空系统中。封窗玻璃的引入,不仅会对太阳光有一定的吸收和反射,使来自太阳辐射的能量有一定的损失,并会形成杂散光,影响成像质量。本文讨论了这些影响。根据云南1m红外太阳塔科学指导委员会确定的工作波段的要求,设计了一种膜系设计方法,可以利用最少的膜系层数来达到需要的结果。并用一组材料进行了模拟设计实验,获得了较为理想的优化结果,在关键波长处显著减小了反射率,减少了杂散光的形成。这种设计方法很适合象太阳塔这种很宽的波段里面对一组波长有很高要求的设计任务,将大大提高光能利用率,具有重要的价值。     

The web of three-planet resonances in the outer Solar System: II. A source of orbital instability for Uranus and Neptune

The motion of the giant planets from Jupiter to Neptune is chaotic with Lyapunov time of approximately 10 Myr. A recent theory explains the presence of this chaos with three-planet mean-motion resonances, i.e. resonances among the orbital periods of at least three planets. We find that the distribution of these resonances with respect to the semi-major axes of all the planets is compatible with orbital instability. In particular, they overlap in a region of 10⁻³ AU with respect to the variation of the semi-major axes of Uranus and Neptune. Fictitious planetary systems with initial conditions in this region can undergo systematic variations of semi-major axes. The true Solar System is marginally in this region, and Uranus and Neptune undergo very slow systematic variations of semi-major axes with speed of order 10⁻⁴ AU/Gyr.     

Multisite campaign on the open cluster M67 – II. Evidence for solar-like oscillations in red giant stars

Measuring solar-like oscillations in an ensemble of stars in a cluster, holds promise for testing stellar structure and evolution more stringently than just fitting parameters to single field stars. The most-ambitious attempt to pursue these prospects was by Gilliland et al. who targeted 11 turn-off stars in the open cluster M67 (NGC 2682), but the oscillation amplitudes were too small (<20 μmag) to obtain unambiguous detections. Like Gilliland et al. we also aim at detecting solar-like oscillations in M67, but we target red giant stars with expected amplitudes in the range 50–  500 μmag  and periods of 1 to 8 h. We analyse our recently published photometry measurements, obtained during a six-week multisite campaign using nine telescopes around the world. The observations are compared with simulations and with estimated properties of the stellar oscillations. Noise levels in the Fourier spectra as low as  27 μmag  are obtained for single sites, while the combined data reach  19 μmag  , making this the best photometric time series of an ensemble of red giant stars. These data enable us to make the first test of the scaling relations (used to estimate frequency and amplitude) with an homogeneous ensemble of stars. The detected excess power is consistent with the expected signal from stellar oscillations, both in terms of its frequency range and amplitude. However, our results are limited by apparent high levels of non-white noise, which cannot be clearly separated from the stellar signal.     

A Quaternary uplift record for the Auckland region, North Island, New Zealand, based on marine and fluvial terraces

Marine and fluvial terrace sequences near the Waitakere Ranges on the North Island of New Zealand have been surveyed, yielding an inventory of 13 fluvial and 12 marine terrace levels. Based on sparse tephra age control and correlation with the global palaeoclimatic record, rates of regional Quaternary uplift have been reconstructed. Between 1000 ka and 345 ka the time-averaged uplift rate was 0.072 mm a^− 1, between 345 ka and 50 ka it increased to 0.278 mm a^− 1, accelerating to 0.42 mm a^− 1 since 50 ka. The fluvial terrace sequence did not yield clear sedimentary records or other datable material. However, although others have disputed the existence of marine terraces in this study region, a pattern of accelerating regional uplift, superimposed onto glacio-eustatic sea-level changes, is substantiated as the only possible mechanism for maintaining the considerable relief and the active denudation processes inland. The observed uplift is similar to that in other regions where the uplift has been attributed to coupling between surface processes and lower-crustal flow, making this a likely mechanism in the North Island of New Zealand. Regarding the fluvial terrace sequence, the proposed general model is of an actively incising river, carving out on average one strath terrace every ~ 16,000 years. The incision phases are reactivated by sea-level lowering and interrupted by net aggradation events due to landslides triggered by cyclones and/or fires within the catchment; volcanic ash falls also cause transient increases in sediment supply.     

Pedestal crater heights on Mars: A proxy for the thicknesses of past, ice-rich, Amazonian deposits

Mid-latitude pedestal craters on Mars offer crucial insights into the timing and extent of widespread ice-rich deposits during the Amazonian period. Our previous comprehensive analysis of pedestal craters strongly supports a climate-related formation mechanism, whereby pedestals result from impacts into ice-rich material at mid latitudes during periods of higher obliquity. The ice from this target deposit later sublimates due to obliquity changes, but is preserved beneath the protective cover of the armored pedestal. As such, the heights of pedestals act as a proxy for the thicknesses of the paleodeposits. In this analysis, our measurement of 2300 pedestal heights shows that although pedestals can reach up to ∼260 m in height, ∼82% are shorter than 60 m and only ∼2% are taller than 100 m. Mean pedestal heights are 48.0 m in the northern mid latitudes and 40.4 m in the southern mid latitudes, with the tallest pedestals located in Utopia Planitia, Acidalia Planitia and Malea Planum. We use these data in conjunction with prior climate model results to identify both regional and global trends regarding ice accumulation during obliquity excursions. Our data provide evidence for multiple episodes of emplacement and removal of the mid-latitude ice-rich deposit based on stratigraphic relationships between pedestal craters and the close proximity of pedestals with significantly different heights.     

Expanding,homogeneous, ellipsoidal density perturbations. III. A simple theory for the acquisition of angular momentum by tidal torques with the effects of the spin growth on the expansion included

The effects of the acquisition of angular momentum on the expansion of homogeneous, ellipsoidal density perturbations is investigated by generalizing the theory of previous papers of this series, where spin grows to the first order in overdensity. A small difference is found to be between the two cases, except for the fact that the body under consideration becomes unbound earlier in the current approach. A comparison is also made with the results of a different theory, where spin grows to the second order in overdensity. Quasi-oblate triaxial configurations turn out to gain less angular momentum in respect to both oblate and more elongated configurations with same minor to major axis ratio. In all cases of physical interest, the spin growth from the beginning to the maximum ellipsoidal volume exceeds the spin growth from the maximum ellipsoidal volume to the turnaround of the major axis, by a factor of at least 3. It is also inferred that the spin growth from the turnaround of the major axis on, probably does not exceed about one third the angular momentum previously gained.     

Contribution to the search for binaries among Am stars – VII. Orbital elements of seven new spectroscopic binaries, implications on tidal effects

We present the results of a radial-velocity study of seven Am stars (HD 3970, 35035, 93946, 151746, 153286, 204751 and 224002) observed at the Observatoire de Haute-Provence (OHP) and the Cambridge Observatories with CORAVEL instruments. We find that these systems are single-lined spectroscopic binaries whose orbital elements are determined for the first time. Among this sample, HD 35035 and 153286 have long periods, with   P = 2.8  and 9.5 yr, respectively, which is rather unusual for Am stars. Four systems have orbits with large eccentricities (with   e ≥ 0.4  ). Physical parameters are inferred from this study for the primaries of those systems.
We then investigate the influence of tidal interaction, which has already led to the synchronism of the primaries and/or to the circularization of the orbits of some systems belonging to this sample. We extend this study to the list of 33 objects studied in this series of papers and derive values of the critical fractional radii   r = R / a   for circularization and synchronization of Am-type binaries. We find that the stars with   r ≳ 0.15  are orbiting on circular orbits and that synchronism is likely for all components with   r ≳ 0.20  .