Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

Pressure dependence and anisotropy of P-wave velocities in ultrahigh-pressure metamorphic rocks from the Dabie–Sulu orogenic belt (China): Implications for seismic properties of subducted slabs and origin of mantle reflections

The compressional wave velocities (Vp), pressure derivatives (Vp′) and anisotropy (A) of three types of eclogites and country rocks from the Dabie–Sulu ultrahigh-pressure (UHP) metamorphic belt, China, have been measured under confining pressures up to 800 MPa. Type-1 eclogites, which are coarse-grained and subjected to almost no retrograde metamorphism, experienced recovery-accommodated dislocation creep at peak metamorphic conditions (in the diamond stability field). Type-2 eclogites are fine-grained reworked Type-1 materials that experienced recrystallization-accommodated dislocation creep under quartz/coesite boundary conditions during the early stage of exhumation. Type-3 eclogites are retrogressed samples that were overprinted by significant amphibolite facies metamorphism during a late stage of exhumation within the crust. Type-1 eclogites are richer in Al₂O₃ and MgO but poorer in SiO₂ and Na₂O than Type-2 and Type-3 eclogites. Anisotropy of Type-1 and Type-2 eclogites is generally low (<4%) because volumetrically important garnet is elastically quasi-isotropic, while Type-3 eclogites can exhibit high anisotropy (>10%) due to the presence of strongly anisotropic retrograde minerals such as amphibole, plagioclase and mica. The transition of the pressure dependence of velocity from the poroelastic to elastic regimes occurs at a critical pressure (P_c), which depends mainly on the density and distribution of microcracks and in turn on the exhumation history of rocks. The Vp–pressure relationship can be expressed by Vp=a(lnP)²+blnP+c (P≤P_c) and Vp=V₀+DP (P≥P_c), where P is the confining pressure, a and b are constants describing the closure of microcracks below P_c, c is the velocity when P is equal to one (MPa), V₀ is the projected velocity of a crack-free sample at room pressure, and D is the intrinsic pressure derivative above P_c. When data are curve-fit, pressure derivatives and anisotropy as functions of pressure are determined. The average Vp of the eclogites in the linear regime is 8.42+1.41×10⁻⁴P for Type-1, 7.80+1.58×10⁻⁴P for Type-2, and 7.33+2.04×10⁻⁴P for Type-3, where Vp is in km/s and P in MPa. The decrease in V₀ and increase in D from Type-1 to Type-3 eclogites are attributed to a decrease in garnet content and an increase in retrograde minerals. The NE–SW trending, NW-dipping, slab-like high Vp anomaly (8.72 km/s at a depth of 71 km) which extends from the Moho to at least 110 km beneath the Dabie–Sulu region, can be interpreted as the remnant of a subducted slab which is dominated by Type-1 eclogites and has frozen in the upper mantle since about 200–220 Ma. Such relic crustal materials, subducted and preserved as eclogite layers intercalated with felsic gneiss, garnet–jadeite quartzite, marble and serpentinized peridotite, could be responsible for regionally observed seismic reflectors in the upper mantle.