循环应力下饱和黏土剪切变形特性试验研究

针对饱和重塑黏土,利用土工静力-动力液压三轴-扭转多功能剪切仪,在不固结不排水(UU)条件下进行了应力控制式循环扭剪和竖向-扭转耦合试验,通过对试验结果的对比分析探讨了初始预剪应力和应力反向对应力-应变关系特性的影响,并阐述了不同加荷模式下孔隙水压力发展特性。以此为基础,综合考虑剪切变形和正向偏差变形的共同效应,同时为了能够反映平均残余变形和循环变形的影响,建议了一个综合应变破坏标准的算式。进而通过利用试验数据与目前常用的应变标准比较,表明这种破坏标准具有普遍适用性和较好的稳定性,适用于判定各种应力条件下黏土试样破坏及其强度。     

Effects of frequency and cyclic stress ratio on creep behavior of clay under cyclic loading

The mechanical behavior of clay subjected to cyclic loading is important to consider in the design of the foundations of many types of structures that must resist cyclic loading, such as subgrades and offshore foundations, because clay undergoes greater settlement under cyclic loading than under static loading. The difference in settlement between these two loading patterns due to creep behavior is affected by the cyclic frequency and the cyclic stress ratio. This study investigated the effects of the frequency and cyclic stress ratio of cyclic loading on the creep behavior of a natural clay in China using stress-controlled triaxial tests. The assessed the following parameters: three frequencies, four cyclic stress ratios, and six vertical stresses. The test results indicate that the soft clay displays accelerated creep behavior under dynamic loads. A specific “limit frequency” (in this case, 0.2 Hz) and a “safe load” at which the strain of the soft clay increases very slowly were observed. The effect of the effective axial stress on the creep behavior increases with the increase in the cyclic stress ratio. Based on the tests, the critical cyclic stress ratio is 0.267 at a certain effective axial stress and frequency.     

基于有限差分法的复合系泊链缆动力模型及其验证

具有链—缆—链结构的复合系泊链缆因其相对于全钢链质量和成本上的优势而在深水系泊中得以广泛应用。基于细长杆理论采用有限差分法建立了可以考虑链—缆—链结构的复合系泊缆数值模型,将其应用于不同工况下全钢链和复合链缆运动的数值模拟中,并开展了验证。首先,将单根钢链顶张力数值模拟结果与不同工况下的模型试验结果进行了对比,验证了数值预报程序应用于全钢链的准确性。然后,对于复合系泊链缆开展了静刚度和动刚度迭代数值模拟,并将模拟结果同已发表文章中的算例结果进行比较,验证了该数值模型在复合链缆模拟上的准确性。发现对于单根钢锚链的验证,激励半径越大,激励周期越小,一个周期内顶张力幅值及其极差越大,钢链运动就越剧烈。对于链—缆—链式复合系泊链缆的验证,发现静刚度迭代中数值模拟结果与算例结果差异较小;对于动刚度迭代,除个别大幅慢漂工况外,两者有较高的吻合;且激励周期越小,激励半径越大,复合系泊链缆顶张力越大,弹性模量越小,运动越剧烈。对于聚酯缆刚度的敏感性分析,发现改变动刚度经验公式参数的情况下,杨氏模量的静刚度迭代和动刚度迭代结果误差分别最大达到了60.81%和68.21%,因此合成纤维材料特性对复合系泊链...     

损伤聚酯纤维系缆动刚度特性实验研究

系泊系统设计和分析是深海油气开发平台的关键问题,对于采用合成纤维系缆的绷紧式系泊系统,由于材料属性和安装、使用等因素可能造成缆绳不同程度的损伤,因此有必要研究损伤缆在复杂海况下的非线性动力特性尤其是动刚度演变规律。采用合成纤维系缆循环加载实验系统,对6 mm和8 mm的聚酯(polyester)缆绳试样进行实验研究。引入损伤度指标衡量缆绳的损伤程度,通过剪切股纱减小缆绳的有效承载面积以制造损伤,分别考察了损伤度、平均载荷、应变幅值和循环周次对缆绳动刚度的影响。通过量纲分析得到损伤缆动刚度相似准则,在此基础上分析实验数据获得考虑各主要影响因素的动刚度演变经验公式。这些工作为今后更为复杂的全尺寸损伤缆绳的动刚度研究奠定了基础。     

海洋系泊工程中合成纤维系缆研究述评

在回顾合成纤维缆绳的分类和工程应用的基础上,概述了各类纤维缆绳的优缺点和工程适用性。介绍了合成纤维系缆实验技术的国内外研究进展,并综述了合成纤维缆绳的破断强度、动刚度、蠕变、蠕变回复、蠕变破断和疲劳破坏的研究现状,在此基础上展望了今后需要继续开展的合成纤维系缆研究方向。这将为海洋系泊工程中合成纤维系缆的研究和应用提供重要参考。     

Coupled-dynamic analysis of floating structures with polyester mooring lines

A theory and numerical tool are developed for the coupled-dynamic analysis of a deepwater floating platform with polyester mooring lines. The formulas allow relatively large elongation and nonlinear stress–strain relationships, as typically observed in polyester fibers. The mooring-line dynamics are based on a rod theory and the finite element method (FEM), with the governing equations described in a generalized coordinate system. The original rod theory [Nordgren, R.P., 1974. On Computation of the Motion of Elastic Rods. Journal of Applied Mechanics, 41, 777–780] is generalized to allow larger elongation and nonlinear stress–strain relationship. The dynamic modulus of polyester is modeled following an empirical regression formula suggested by [Bosman, R.L.M., Hooker, J., 1999. The Elastic Modulus Characteristic of Polyester Mooring Ropes. In: Proceedings of the Offshore Technology Conference, OTC 10779. Houston, Texas], in which the axial stiffness is not constant, but depends on loading conditions. Two case studies, the static and dynamic behavior of a tensioned buoy and a classic spar with polyester mooring lines, are conducted. The time-domain simulation results are systematically compared with those from the original rod theory. The effects of large elongation and nonlinear stress–strain relations are separately assessed. It is seen that the mean offset, motions, and tension with polyester lines can be different from those by original rod theory with linear elastic lines.     

复合加载下桶形基础循环承载性能数值分析

作为一种新型基础形式,吸力式桶形基础除了承受海洋平台结构及自身重量等竖向荷载的长期作用之外,往往还遭受波浪等所产生的水平荷载及其力矩等其它荷载分量的瞬时或循环作用。对复合加载模式下软土地基中桶形基础及其结构的循环承载性能尚缺乏合理的分析与计算方法。应用Andersen等对重力式平台基础及地基所建议的分析方法,基于软黏土的循环强度概念,在大型通用有限元分析软件ABAQUS平台上,通过二次开发,将软土的循环强度与Mises屈服准则结合,针对吸力式桶形基础,基于拟静力分析建立了复合加载模式下循环承载性能的计算模型,并与复合加载作用下极限承载性能进行了对比。由此表明,与极限承载力相比,桶形基础的循环承载力显著降低。     

Stability analysis of suction bucket foundations under wave cyclic loading and scouring

Suction bucket foundation is a typical type for offshore turbines. Scour caused by wave and current can reduce the stability of foundation and then endanger the whole structure. This paper details a series of suction bucket model tests performed in sand under wave cyclic loading. The model tests investigate the effect of scour on stability of bucket foundation by artificially excavated scour hole around the foundation. It is revealed that the behavior of foundation bearing capacity can be divided into two stages: the initial cyclic stage and the final stage (showing either cyclic stability or cyclic failure). When the wave circulation is stable, the sand on the front and back sides of the foundation is suspected to be liquefied. With the increase in scour depth, the stability of foundation is gradually reduced, the behavior of foundation gradually changes from a state of cyclic stability to cyclic failure, and the number of waves that can be withstood is drastically reduced. Finally, the height of the center of rotation of the suction bucket was observed to descend with the increase in scour depth.     

Experimental study on the settlement of marine deposits of Anzali under cyclic loading by laminar box apparatus

The central Alborz mountain range, located in northern Iran, neighboring the Caspian Sea and where the two Persia and Eurasia plates meet, is known as a seismologically active area. In this regard, investigation of the behavior of saturated sand deposits located in this area may be of particular interest. Saturated sand deposits are subjected to instabilities owing to liquefaction or volume change due to earthquake shakings. A particular type of saturated sand deposits is Anzali sand which is abundant in Anzali port and other cities located in this area in northern Iran. This type of sand is a representative for most sands found in this area, i.e., the southern coastal line of Caspian Sea. This research is solely focused on the volume change behavior of marine deposits of Anzali area, often characterized as Anzali sand, in terms of the settlement of a model footing located on the surface of the sand by the aid of a transparent laminar shear box apparatus. Effects of a number of factors such as the frequency of the cyclic loading, the initial density of the sand, and the sample preparation method have been investigated. Observations indicated that the density index and the frequency of loading which are proportional to the energy of an earthquake have direct effects on the accumulation and amount of the final settlement of Anzali sand.     

Undrained strength behaviour of a cemented marine clay under monotonic and cyclic loading

The paper presents the results of a series of monotonic and cyclic triaxial shear tests carried out to study the influence of the strain effect and load cycles on the undrained shear strength of a cemented marine clay from the East coast of India. The undrained shear strength of Indian coastal marine clay has been established from a detailed shear testing carried out in three phases. Undisturbed soil samples taken out from the seabed were used in the test. In the first part, a comprehensive monotonic shear testing has been carried out under both stress-controlled and strain rate-controlled conditions. In the second phase on identical soil specimen, undrained cyclic shear tests were carried out at various cyclic stress ratios (CSR) and these stress levels are chosen in such a way so that no failure occurred during testing. In the final phase post cyclic monotonic shear testing was conducted to qualitatively evaluate the damage caused by cyclic loading. The monotonic shear test results bring out the influence of cementation that can be detected by the stress-controlled test. The cyclic stress results are analysed in terms of CSR. Further, the results are correlated in terms of stress path.     

循环荷载下半圆堤整体稳定性计算方法研究

针对圆弧滑动面法已无法准确判断土体强度发生弱化后半圆堤整体稳定性问题,建立基于循环强度结合D-P屈服准则的拟静力有限元模型来分析半圆堤整体稳定性。分析荷载破坏包络线的变化趋势,给出提高半圆堤整体稳定性的工程建议。并在有限元数值分析结果基础上,对变量进行无量纲化,通过优化分析进行非线性拟合归一得出描述半圆堤整体稳定性的极限状态方程。以长江口深水航道治理二期工程为例,结果表明简化计算方法是可靠的,可供工程设计借鉴和使用。