共查询到20条相似文献,搜索用时 109 毫秒
1.
为推广应用新型弧面胸墙沉箱堤,结合模型试验和数值模拟对比分析了深水工况下弧面胸墙沉箱堤和削角胸墙沉箱堤的反射形态。波面和波压的数值结果与试验数据吻合良好,验证了数值方法的有效性。反射系数表明,入射波浪在与弧面胸墙沉箱堤相互作用过程中的能量损耗最小,其反射强于削角胸墙沉箱堤。波面和流速包络图显示,两种堤型均在堤前形成了部分立波系统,腹点和节点以四分之一波长的距离增量交替出现,胸墙和直立部分产生的反射波存在相位差,导致初始腹点的位置向海侧偏移。弧面胸墙沉箱堤前叠合波的相位差影响最小,腹点包络高度最大,节点包络高度最小,反射效应最明显。两种堤型前中下层水流的周期平均速度均较小且对称,表明底床泥沙不会产生趋势性输移,但迎浪基床上方的环流系统可能引起局部冲刷。相对而言,弧面胸墙沉箱堤前的环流强度最弱,更有利于冲刷防护。 相似文献
2.
本文研究了随机波作用下吸能沉箱防波堤的各水动力特性。喷嘴负荷用最小二乘法进行线性处理。用局部有限元法求解流场。理论表明吸能沉箱防堤的吸能效率在不同的有效波周期处均较高,作用在其上的波力亦比传统直立堤的小。 相似文献
3.
本文根据黄海一观测站测得的直立堤上浮托力和堤前表面波的实测资料,探讨了直立堤上浮托力沿堤底面的分布规律及其与波高的关系,并与规范法作了比较。 相似文献
4.
5.
本文利用原体观测站测得的表面波与直立堤上浮托力的记录,计算了表面波与各测点浮托力的单谱及各测点浮托力与表面波之间的互谱,频率响应函数和凝聚函数等,揭示了直立堤上浮托力统计特征以及它们与堤前表面波间的频率、位相、量值关系.文中还介绍了浮托力观测装置及测点的位置分布. 相似文献
6.
本文提出直立堤上浮托力沿断面分布的三种模式:其一是堤的宽度较大,波浪尺度较小的情况,浮托力为零的点在堤的中部;其二是波浪尺度和堤的宽度适中的情况,浮托力为零的点恰在堤的后踵处;第三种情况是堤的宽度小而波浪的尺度大,浮托力为零的点不在堤的断面上,而在离开堤的一个虚拟点上,浮托力的分布实为梯形分布。为了确定浮托力的分布,我们对浮托力作用范围也作了一些讨论和推断。文中就浮托力谱沿直立堤断面的衰减作了分析和论述,推导出浮托力谱系数沿断面变化的规律。 相似文献
7.
本文应用工程结构的优化设计方法,由电算机设计出沉箱直立堤断面,使其为技术上合理,工程造价最省的最佳稳定断面。经优化可迅速地输出优化的直墙堤断面尺寸、工程量、各部造价及考虑维修费在内的工程总投资,为工程规划设计及可行性研究提供方便的设计方法。 相似文献
8.
海啸波作用下直立堤局部冲刷实验研究 总被引:1,自引:0,他引:1
基于波浪水槽动床实验,开展海啸波作用下直立堤局部冲刷实验研究。对海啸波上爬和回落过程、岸滩演变和直立
堤局部冲刷形态进行测量。在利用实测数据验证基础上,结合 FLOW 3D 进行数值模拟流场计算分析。研究结果表明,直立堤
的修建对岸滩起到明显的保护作用,但是直立堤两侧会出现明显的局部冲刷。直立堤向岸侧局部冲刷主要发生在海啸上爬时
刻,堤脚处形成的涡流是局部冲刷形成的主要原因。直立堤离岸侧的局部冲刷主要由海啸波回落水流越过堤顶生成水跌形成
的,随着直立堤堤顶高度的增加,最大局部冲刷深度会逐渐减小。 相似文献
9.
基于线性势流假定,对斜向波作用下带横隔板局部开孔沉箱防波堤的水平波浪力进行了理论研究。给出了开孔沉箱法向水平力和横隔板受力的理论计算方法,在极限情况下波浪力的计算结果与文献中的已有结果一致。利用数值算例分析了开孔沉箱总水平力的主要影响因素。开孔沉箱法向总水平力的减小主要集中于结构上半部分波浪影响范围以内。增加单个开孔沉箱的长度有利于减小结构所受总水平波浪力。当波浪入射角或沉箱前开孔墙孔隙影响系数幅值较大时,开孔沉箱横隔板上总水平力的最大值要超过相应的沉箱法向总水平力,此时要注意横隔板的强度问题。 相似文献
10.
应用椭圆余弦波的绕射理论,推导了V形防波堤的浅水波浪绕射解析解,从而对现有的Airy微幅波理论进行了有效拓展。据此理论对V形防波堤的浅水波绕射作用进行了解析计算,并与几何形状相近的圆弧型防波堤结果加以了对比。结果表明:椭圆余弦波理论计算的V形防波堤最大波浪力和最大绕射波面明显大于微幅波理论的对应值。本方法适用于张角180°的有限长直立薄壁防波堤的浅水波绕射作用计算,从而将无限长直立薄壁堤的反射波理论加以有效拓展。张角同为120°的V形堤与圆弧堤的堤后防浪效果相近,而180°圆弧堤的堤后防浪效果优于张角90°的V形堤。 相似文献
11.
Dong Hyawn KIM 《海洋工程》2017,31(3):317-321
Evaluating the expected sliding distance of a vertical slit caisson breakwater is proposed. Time history for the wave load to a vertical slit caisson is made. It consists of two impulsive wave pressures followed by a smooth sinusoidal pressure. In the numerical analysis, the sliding distance for an attack of single wave was shown and the expected sliding distance during 50 years was also presented. Those results were compared with a vertical front caisson breakwater without slit. It was concluded that the sliding distance of a vertical slit caisson may be over-estimated if the wave pressure on the caisson is evaluated without considering vertical slit. 相似文献
12.
Interaction Between Waves and A Comb-Type Breakwater 总被引:2,自引:1,他引:2
The characteristics of wave transmission, reflection and energy dissipation of comb-type caisson breakwaters are studied through laboratory physical model tests. Regular and irregular waves, with a wide range of wave heights and periods and a constant water depth, are considered. Different dimensions of each portion of the comb-type caisson breakwater are tested. Empirical formulae for calculating the reduction coefficient k, which is the ratio of horizontal wave force on unit length of the comb-type breakwater to that on unit length of the vertical wall breakwater, and for calculating the reflection coefficient of waves k, are obtained from the measurements. The comb-type caisson breakwater has been found to be very efficient in dissipating incident wave energy and in reducing wave reflection, and has already been used for the construction of an island breakwater in the Dayao Bay of Dalian Port, Liaoning Province, China. Compared with the cost of a common caisson breakwater, about 24. 5% of the investm 相似文献
13.
《Coastal Engineering》2001,44(2):117-139
In this paper, laboratory data for free surface displacements and velocity fields in front of a caisson breakwater covered with wave-dissipating blocks, together with wave pressures acting on the caisson, are presented and discussed. The core of the breakwater is made of a concrete caisson with a vertical front wall. The caisson is protected by a thick layer of tetrapods and is supported by a rubble mound. The breakwater is placed on the 1/25 impermeable slope. Two types of incident waves are used in the experiments: nonbreaking waves and spilling-type breaking waves. In the breaking wave case, the incident wave breaks offshore before it reaches the breakwater. The velocity data are obtained by using both the Laser Doppler Velocimeter (LDV) and the Electromagnetic Current Meter (EMCM). The raw data are analyzed using a numerical-filtering scheme so that turbulent fluctuations are separated from the phase-dependent wave motions. The vertical profiles of the time-averaged (over a wave period) turbulent velocity components at several vertical cross-sections in front of the breakwater are then analyzed. The spatial variations of the time-averaged turbulence velocity suggest that turbulence is generated inside the protective armor layer and transported into the flow region in front of the breakwater. The wave pressures on the vertical face and on the bottom of the caisson are also reported. 相似文献
14.
为使防波堤同时具有良好的掩护效果和水体交换能力,提出了两种带有透浪通道的新型直立式防波堤。基于Fluent求解器建立了三维数值波浪水槽,通过与试验结果对比,验证了该数值水槽求解波浪与透空堤作用具有较高的精度。对两种防波堤在规则波作用下的透浪特性进行了研究,结果表明:透射系数K_t与透空率呈正线性相关,且可通过调整透浪通道间距,使相同透空率下K_t降低20%~30%。对同一结构,K_t随相对波长的增大而显著增大,但受相对波高的影响较小。在透空率大于0.16后,异型沉箱防波堤的消浪性能明显优于错位沉箱。基于数值计算结果,给出了以上两种透空堤波浪透射系数的经验公式。 相似文献
15.
16.
17.
In the dynamic stability analysis of a caisson breakwater, most of current studies pay attention to the motion characteristics of caisson breakwaters under a single periodical breaking wave excitation. And in the lifetime stability analysis of caisson breakwater, it is assumed that the caisson breakwater suffers storm wave excitation once annually in the design lifetime. However, the number of annual severe storm occurrence is a random variable. In this paper, a series of random waves are generated by the Wen Sheng-chang wave spectrum, and the histories of successive and long-term random wave forces are built up by using the improved Goda wave force model. It is assumed that the number of annual severe storm occurrence is in the Poisson distribution over the 50-year design lifetime, and the history of random wave excitation is generated for each storm by the wave spectrum. The response histories of the caisson breakwater to the random waves over 50-year design lifetime are calculated and taken as a set of samples. On the basis of the Monte Carlo simulation technique, a large number of samples can be obtained, and the probability assessment of the safety of the breakwater during the complete design lifetime is obtained by statistical analysis of a large number of samples. Finally, the procedure of probability assessment of the breakwater safety is illustrated by an example. 相似文献
18.
19.
Dong Hyawn KIM 《中国海洋工程》2014,(6):739-748
A new load surface based approach to the reliability analysis of caisson-type breakwater is proposed. Uncertainties of the horizontal and vertical wave loads acting on breakwater are considered by using the so-called load surfaces, which can be estimated as functions of wave height, water level, and so on. Then, the first-order reliability method(FORM) can be applied to determine the probability of failure under the wave action. In this way, the reliability analysis of breakwaters with uncertainties both in wave height and in water level is possible. Moreover, the uncertainty in wave breaking can be taken into account by considering a random variable for wave height ratio which relates the significant wave height to the maximum wave height. The proposed approach is applied numerically to the reliability analysis of caisson breakwater under wave attack that may undergo partial or full wave breaking. 相似文献
20.
Wang Jianyi Senior Engineer River Harbour Department Nanjing Hydraulic Research Institute Nanjing 《中国海洋工程》1992,(1)
This paper describes the design of a perforated caisson breakwater and presents the results of model test. Tests with regular and irregular waves have demonstrated that the perforated caisson breakwater has the advantages of low reflection coefficient, good wave-absorbing performance, relatively small wave height in front of the breakwater, and small amount of overtopping. Analyses have been made of the coefficient of reflection, wave height in front of the breakwater, and wave overtopping. Relevant figures and tables are presented for reference. 相似文献