Gravitational wave emission from a companion black hole in the presence of an accretion disc around a super-massive Kerr black hole

Gravitational wave signal characteristics from a binary black hole system in which the companion moves through the accretion disc of the primary are studied. We chose the primary to be a super-massive  ( M = 10⁸ M_⊙)  Kerr black hole and the companion to be a massive black hole  ( M = 10⁵ M_⊙)  to clearly demonstrate the effects. We show that the drag exerted on the companion by the disc is sufficient to reduce the coalescence time of the binary. The drag is primarily due to the fact that the accretion disc on a black hole deviates from a Keplerian disc and becomes sub-Keplerian due to inner boundary condition on the black hole horizon. We consider two types of accretion rates on to the companion. The companion is deeply immersed inside the disc and it can accrete at the Bondi rate which depends on the instantaneous density of the disc. However, an accretion disc can also form around the smaller black hole and it can accrete at its Eddington rate. Thus, this case is also studied and the results are compared. We find that the effect of the disc will be significant in reducing the coalescence time and one needs to incorporate this while interpreting gravitational wave signals emitted from such a binary system.     

Reflected iron line from a source above a Kerr black hole accretion disc

In this paper we present a fully relativistic approach to modelling both the continuum emission and the reflected fluorescent iron line from a primary X-ray source near a Kerr black hole. The X-ray source is located above an accretion disc orbiting around the black hole. The source is assumed to be a static point source located on an arbitrary position above the disc, on or off the axis of rotation. We carry out Monte Carlo simulations in order to estimate the iron line spectrum as well as its equivalent width. Because of the gravitational lensing effect, an enhancement of the iron line is expected when the primary source is located close to the central black hole. We find that for a source located on the axis of rotation the enhancement is relatively modest. An observer at inclination 30° would measure an equivalent width of ∼300 eV in the extreme case of a maximally rotating black hole and a source located at height 1.5 gravitational radii from the centre. This corresponds to an equivalent width enhancement factor of about 2 compared with the classical value where no lensing effect comes into play. However, when allowing the source to be located off the axis of rotation, much stronger enhancement can be obtained. In the extreme case of a maximally rotating black hole and a source located just above the approaching side of the disc, an observer at inclination 30° could measure an equivalent width as high as ∼1.5 keV (i.e., ∼10 times the classical value). We also find that observers located at high inclination angles observe a stronger line than observers at low inclination angles.     

Super-Eddington accretion discs around Kerr black holes

We calculate the structure of the accretion disc around a rapidly rotating black hole with a super-Eddington accretion rate. The luminosity and height of the disc are reduced by the advection effect. In the case of large viscosity parameter, α>0.03, the accretion flow deviates strongly from thermodynamic equilibrium and overheats in the central region. With increasing accretion rate, the flow temperature steeply increases, reaches maximum, and then falls off. The maximum is achieved in the advection-dominated regime of accretion. The maximum temperature in the disc around a massive black hole of M =10⁸ M⊙ with α=0.3 is of order 3×10⁸ K. The discs with large accretion rates can emit X-rays in quasars as well as in galactic black hole candidates.     

Effects of magnetic coupling on radiation from accretion disc around a Kerr black hole

The effects of magnetic coupling (MC) process on the inner edge of the disc are discussed in detail. It is shown that the inner edge can deviate from the innermost stable circular orbit (ISCO) due to the magnetic transfer of energy and angular momentum between a Kerr black hole (BH) and its surrounding accretion disc. It turns out that the inner edge could move inwards and outwards for the BH spin a _* being greater and less than 0.3594, respectively. The MC effects on disc radiation are discussed based on the displaced inner edge. A very steep emissivity can be provided by the MC process, which is consistent with the observation of MCG-6-30-15. In addition, the BH spins of GRO J1655−40 and GRS 1915+105 are detected by X-ray continuum fitting based on this model.     

Towards incorporating a turbulent magnetic field in an accreting black hole model

A model proposed by Melia & Ruffert to evaluate the spectrum and radiation flux for accretion on to a black hole makes use of the 'equipartition assumption' in which the magnetic, turbulent and gravitational energy densities are assumed to be in approximate equilibrium for distances below the accretion radius, where Bondi–Hoyle infall begins. As a consequence, the mechanism for the dissipation of the magnetic field and the resulting effect on the flow of the accreting gas have not been treated quantitatively. Here we examine alternative approaches for modelling the dissipation of magnetic fields and turbulent flow to see how these may be incorporated into the model. The results of our study should be immediately applicable to the ever-improving measurements of the spectrum and size of the massive black hole at our Galactic Centre, in particular producing a more accurate estimate of its mass. Combined with greatly refined kinematic studies of this region, our work may constrain the dark matter concentration in the nucleus of our Galaxy.     

Dissipative accretion flows around a rotating black hole

We study the dynamical structure of a cooling dominated rotating accretion flow around a spinning black hole. We show that non-linear phenomena such as shock waves can be studied in terms of only three flow parameters, namely the specific energy     , the specific angular momentum (λ) and the accretion rate     of the flow. We present all possible accretion solutions. We find that a significant region of the parameter space in the     plane allows global accretion shock solutions. The effective area of the parameter space for which the Rankine–Hugoniot shocks are possible is maximum when the flow is dissipation-free. It decreases with the increase of cooling effects and finally disappears when the cooling is high enough. We show that shock forms further away when the black hole is rotating compared to the solution around a Schwarzschild black hole with identical flow parameters at a large distance. However, in a normalized sense, the flow parameters for which the shocks form around the rotating black holes are produced shocks closer to the black hole. The location of the shock is also dictated by the cooling efficiency in that higher the accretion rate     , the closer is the shock location. We believe that some of the high-frequency quasi-periodic oscillations may be due to the flows with higher accretion rate around the rotating black holes.     

Global solutions of adiabatic accretion flows with isothermal shocks in Kerr black hole geometry

This paper presents global solutions of adiabatic accretion flows with isothermal shocks in Kerr black hole geometry. It is known that in the previously studied cases, where the flow including the shock is either entirely adiabatic or entirely isothermal, there can be no more than one stable shock solution, and the solution can only be of α –x type. However, the solution topology in the present case shows remarkable new characteristics: for the same flow parameters there can be two stable shock solutions satisfying physical boundary conditions, and the solution can be of three types, namely α– x , x –α and α–α type. In addition, shocks in the present case occur for a parameter region different from that for Rankine–Hugoniot shocks. These results greatly increase the possibilities of shock formation in astrophysical flows. It is also significant that the effects of frame-dragging of a rapid Kerr black hole on the shock formation are discovered. Finally, a brief comparison is made between shocked inviscid flows and two types of shock-free viscous flows, namely those of Shakura & Sunyaev and Narayan & Yi, and some comments are made about the fact that numerous authors who have studied transonic global solutions of accretion flows have found no shocks.     

Behaviour of dissipative accretion flows around black holes

We investigate the behaviour of dissipative accreting matter close to a black hole, as this provides important observational features of galactic and extragalactic black hole candidates. We find a complete set of global solutions in the presence of viscosity and synchrotron cooling. We show that advective accretion flow can have a standing shock wave and the dynamics of the shock is controlled by the dissipation parameters (both viscosity and cooling). We study the effective region of the parameter space for standing as well as oscillating shock. We find that the shock front always moves towards the black hole as the dissipation parameters are increased. However, viscosity and cooling have opposite effects in deciding the solution topologies. We obtain two critical cooling parameters that separate the nature of the accretion solution.     

Critical properties of spherically symmetric black hole accretion in Schwarzschild geometry

The stationary, spherically symmetric, polytropic and inviscid accretion flow in the Schwarzschild metric has been set-up as an autonomous first-order dynamical system, and it has been studied completely analytically. Of the three possible critical points in the flow, the one that is physically realistic behaves like the saddle point of the standard Bondi accretion problem. One of the two remaining critical points exhibits the strange mathematical behaviour of being either a saddle point or a centre-type point, depending on the values of the flow parameters. The third critical point is always unphysical and behaves like a centre-type point. The treatment has been extended to pseudo-Schwarzschild flows for comparison with the general relativistic analysis.     

Transfer of energy and angular momentum in the magnetic coupling between a rotating black hole and the surrounding accretion disc

The transfer of energy and angular momentum in the magnetic coupling (MC) of a rotating black hole (BH) with its surrounding accretion disc is discussed based on a mapping relation derived by considering the conservation of magnetic flux with two basic assumptions: (i) the magnetic field on the horizon is constant, (ii) the magnetic field on the disc surface varies as a power law with the radial coordinate of the disc. The following results are obtained: (i) the transfer direction of energy and angular momentum between the BH and the disc depends on the position of a co-rotation radius relative to the MC region on the disc, which is eventually determined by the BH spin; (ii) the evolution characteristics of a rotating BH in the MC process without disc accretion are depicted in a parameter space, and a series of values of the BH spin are given to indicate the evolution characteristics; (iii) the efficiency of converting accreted mass into radiation energy of a BH–disc system is discussed by considering the coexistence of disc accretion and the MC process; (iv) the MC effects on disc radiation and the emissivity index are discussed and it is concluded that they are consistent with the recent XMM–Newton observation of the nearby bright Seyfert 1 galaxy MCG–6-30-15 with reference to a variety of parameters of the BH–disc system.     

Hot accretion discs with thermal Comptonization and advection in luminous black hole sources

We solve for the structure of a hot accretion disc with unsaturated thermal Comptonization of soft photons and with advection, generalizing the classical model of Shapiro et al. The upper limit on the accretion rate due to advection constrains the luminosity to ≲ 0.15 y^3/5 α^7/5 of the Eddington limit, where y and α are the Compton and viscosity parameters, respectively. The characteristic electron temperature and Thomson optical depth of the inner flow at accretion rates within an order of magnitude of that upper limit are ∼ 10⁹ K and ∼ 1, respectively. The resulting spectra are then in close agreement with the X-ray and soft γ-ray spectra from black hole binaries in the hard state and Seyferts. At low accretion rates, bremsstrahlung becomes the dominant radiative process.