THE CONFORMAL TRANSFORMATION OF A NETWORK OF TRIANGULATION

Abstract

In a recent issue of this Review, an example is given of the conformal transformation of a network of triangulation using Newton's interpolation formula with divided differences. While the application of the method appears to be new, attention should be drawn to the fact that Kruger employed Lagrange's interpolation formula in a discussion and extension of the Schols method in a paper which was published in the Zeitschrift für Vermessungswesen in 1896. A reference to this paper was given at the end of the paper, “Adjustment of the Secondary Triangulation of South Africa”, published in a previous issue of the E.S.R. (iv, 30, 480).     

A NOTE ON AZIMUTH DETERMINATION

Abstract

The purpose of this note is twofold; first, to criticize the “azimuth” section of the paper “Some Notes on Astronomy as Applied to Surveying”, by R. W. Pring (E.S.R., July 1952, xi, 85, 309–318),and secondly, out of these criticisms to develop an alternative method of making observations for azimuth. It will be apparent that this method owes much to the ideas put forward by Mr. Pring.     

Terrain radiometric calibration of airborne UAVSAR for forested area

In the field of biomass estimation, terrain radiometric calibration of airborne polarimetric SAR data for forested areas is an urgent problem. Illuminated area correction of σ -naught could not completely remove terrain features. Inspired by Small and Shimada, this paper tested gamma-naught on one mountainous forested area using airborne Uninhabited Aerial Vehicle Synthetic Aperture Radar data and found it could remove most terrain features. However, a systematic increasing trend from far range to near range is found in airborne SAR cases. This paper made an attempt to use the relationship between distance to SAR sensor and γ-naught to calibrate γ -naught. Two quantitative evaluation methods are proposed. Experimental results demonstrate that variation of γ -naught can be constrained to a limited extent from near range to far range. Since this method is based on ground range images, it avoids complicated orthorectification.     

TRIANGULATION: BEARINGS VERSUS ANGLES

Abstract

There has always been a marked difference of opinion on the relative merits of the methods of bearings and of angles as applied to triangulation, though it is probable that the majority of writers prefer the method of bearings for first-order work. The subject was mentioned in a recent issue of this Review (vii, 47, 19).     

EXPANSION OF PAPER AS AFFECTING BEARING

Abstract

The problem of the influence of the paper itself on bearings taken off maps or plans has been recently discussed by G. T. M. in this Review (iii, 22, 479). The following alternative method of solving the problem may be of interest; the same figure and symbols are used as in the article mentioned.     

THE DERIVATION OF CERTAIN PROJECTION FORMULAE FOR THE SPHERE

Abstract

The purpose of this article is to make available to readers of the Review a simple method of derivation from first principles of the projection farmulae for same of the more impartant normal conical projections.     

A statistical filter for geodetic observations

A method for filtering of geodetic observationwhich leaves the final result normally distributed, is presented. Furthermore, it is shown that if you sacrifice100.a% of all the observations you may be (1−β).100% sure that a gross error of the size Δ is rejected. Another and, may be intuitively, more appealing method is presented; the two methods are compared and it is shown why Method 1 should be preferred to Method 2 for geodetic purposes. Finally the two methods are demonstrated in some numerical examples.     

INTERPOLATING FROM TRAVERSE TABLES TO SECONDS

Abstract

In the Empire Survey Review, no. 4, 1932, Mr. Clendinning has described a method of interpolating from traverse tables to seconds. Below is another method, due to Prof. Nekrassov, for use with traverse tables published by him. The method is described in The Geodezist, Moscow, 1936, no. I, pp. 47–52.     

LONG LINES ON THE EARTH

Abstract

The Arc of the Geodesic.—In the first part of this paper a method was given for computing the azimuth of a geodesic. The method gives the convergence of the geodesic correctly up to the second power of e the eccentricity. The formula (9), however, also depends on the assumption that σ, the arc-length of the geodesic, can be obtained with sufficient accuracy from the Supplemental Dalby Theorem, that is to say, by a purely spherical computation. It is, therefore, needful to show that this supposition is justifiable; a means must in fact be indicated for verifying the assumption.     

APPROXIMATE METHODS OF SOLVING NORMAL EQUATIONS

Abstract

My attention has recently been drawn to an article by G. H. Menzies (E.5.R., vi, 46, 474) on this subject. The present note is intended to point out improvements in the Anér method, which he favours, and to refute some of his criticisms of the Relaxation method. References are to page and table numbers in Menzies's paper.     

RELAXATION AND THE CO-ORDINATE METHOD OF TRIANGULATION ADJUSTMENT

Abstract

Few, most certainly, will dispute the value of Mr Black's paper describing a method of “Systematic Relaxation”, which appeared in a previous number of this Review. At the same time, however, it seems to the writer to be only fair to readers to point out that the application of the method to triangulation adjustment is really a treatment, from a slightly different aspect, of methods that have long been established.     

A NOVEL METHOD OF MEASURING THE COEFFICIENT OF THERMAL EXPANSION OF INVAR

Abstract

In a letter published in a recent issue of Nature, Prof. L. F. Bates and Mr J. C. Wilson, of University College, Nottingham, have described a new and novel method of determining the coefficient of thermal expansion of invar. Although this method is hardly likely to be applied to the measurement of the coefficient of expansion of long invar tapes, such as are used by surveyors, yet it is so novel and ingenious in itself that a short reference to it may not be out of place in this Review. One extremely interesting thing about it is that no measurements of a length, or of changes of length, are involved.     

The free nonlinear boundary value problem of physical geodesy

Summary Within potential theory of Poisson-Laplace equation the boundary value problem of physical geodesy is classified asfree andnonlinear. For solving this typical nonlinear boundary value problem four different types of nonlinear integral equations corresponding to singular density distributions within single and double layer are presented. The characteristic problem of free boundaries, theproblem of free surface integrals, is exactly solved bymetric continuation. Even in thelinear approximation of fundamental relations of physical geodesy the basic integral equations becomenonlinear because of the special features of free surface integrals.     

Fractional vegetation cover estimation in heterogeneous areas by combining a radiative transfer model and a dynamic vegetation model

ABSTRACT

A fractional vegetation cover (FVC) estimation method incorporating a vegetation growth model and a radiative transfer model was previously developed, which was suitable for FVC estimation in homogeneous areas because the finer-resolution pixels corresponding to one coarse-resolution FVC pixel were all assumed to have the same vegetation growth model. However, this assumption does not hold over heterogeneous areas, meaning that the method cannot be applied to large regions. Therefore, this study proposes a finer spatial resolution FVC estimation method applicable to heterogeneous areas using Landsat 8 Operational Land Imager reflectance data and Global LAnd Surface Satellite (GLASS) FVC product. The FVC product was first decomposed according to the normalized difference vegetation index from the Landsat 8 OLI data. Then, independent dynamic vegetation models were built for each finer-resolution pixel. Finally, the dynamic vegetation model and a radiative transfer model were combined to estimate FVC at the Landsat 8 scale. Validation results indicated that the proposed method (R²?=?0.7757, RMSE?=?0.0881) performed better than either the previous method (R²?=?0.7038, RMSE?=?0.1125) or a commonly used method involving look-up table inversions of the PROSAIL model (R²?=?0.7457, RMSE?=?0.1249).     

THE CLARKE FORMULÆ FOR LATITUDE,LONGITUDE AND REVERSE AZIMUTH,WITH CORRECTIVE TERMS FOR USE ON VERY LONG LINES

Abstract

This extremely simple and elegant method of computing geographical co-ordinates, given the initial azimuth and length of line from the standpoint, was published by Col. A. R. Clarke in 1880. There is no other known method giving the same degree of accuracy with the use of only three tabulated spheroidal factors. Clarke himself regarded this as an approximate formula (vide his remark in section 5, p. 109, “Geodesy”); but as this article demonstrates, it is capable of a high degree of precision in all occupied lati tudes when certain corrections are applied to the various terms. These corrections are comparatively easy to compute, require no further spheroidal factors, and some of them may be tabulated directly once and for all.     

NOTE ON THE REDUCTION OF CIRCUMMERIDIAN ALTITUDES TO THE MERIDIAN

Abstract

The method of reducing circummeridian altitudes or zenith distances to the meridian, using the factors m and n as tabulated by Chauvenet, is well known. The following method, which does not use these factars, has been faund both more convenient and more accurate in practice. The formula can be easily obtained by expanding m and n in powers of t, but far the sake af campleteness the derivatian is here given from the beginning.     

Upscaling in situ albedo for validation of coarse scale albedo product over heterogeneous surfaces

ABSTRACT

One of the essential steps for satellite albedo validation is upscaling in situ measurements to corresponding pixel scale over relatively heterogeneous land surfaces. Although the multi-scale validation strategy is applicable for heterogeneous surfaces, the calibration of the high-resolution imagery during upscaling process is never perfect, and thus the upscaling results suffer from errors. The regression-kriging (RK) technique can compensate the calibration part by applying kriging to upscale residuals and produce more accurate upscaling results. In this paper, in situ measurements and high spatial resolution albedo imagery combined with RK technique was proposed. This method is illustrated by upscaling surface albedo from in situ measurements scale to the coarse pixel scale in the core experimental area of HiWATER, where 17 WSN nodes were deployed at heterogeneous area. The upscaling results of this method were compared with the upscaling results from multi-scale strategy. The results show that the upscaling method based on in situ measurements and high-resolution imagery combined with RK technique can capture the spatial characteristics of surface albedo better. Further, an attempt was made to expand this method in time series. Finally, a preliminary validation of the Moderate Resolution Imaging Spectroradiometer albedo product was performed as the tentative application.     

THE ADJUSTMENT OF A FIRST-ORDER LEVELLING NETWORK

Abstract

In the E.S.R. January and April numbers of 1955, Vol. xiii, Nos. 95 and 96, Mr. Hsuan-Loh Su described the “Adjustment of a Level Net by Successive Approximations and by Electrical Analogy”. It does not seem to be as generally known as it should be that the rigid least square solution can be greatly simplified by utilizing the electrical analogy and solving by Kirchhoff's method. The method as detailed below has been in use for over 40 years.     

ON THE ORTHOMORPHIC PROPERTY OF SCHOLS ADJUSTMENT

Abstract

In vol. iv, nos. 29 and 30, of the E.S.R., there appeared an article by Mr. D. R. Hendrikz on the “Adjustment of the Secondary Triangulation of South Africa”. He shows that, in applying the Schols method of orthomorphic transmission to the adjustment of a secondary net to a primary triangle, the secondary sides suffer small displacements.     

LONG LINES ON THE EARTH: THE DIRECT PROBLEM

Abstract

19. Formulae.—In Nos. 6, vol. i, and 9, vol. ii, pp. 259 and 156, there has been described a new method for dealing with long geodesics on the earth's surface. There the so-called “inverse” problem has claimed first attention: given the latitudes and longitudes of the extremities of a geodesic, to find its length and terminal azimuths. It remains to discuss the “direct” problem : a geodesic of given length starts on a given azimuth from a station of known latitude and longitude; to find the latitude and longitude of its extremity and the azimuth thereat. The solution of this direct problem demands a certain recasting of the formulae previously given. In order of working the several expressions now assume the forms below.