首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到20条相似文献,搜索用时 31 毫秒
1.
2.
3.
4.
5.
Organohalogen compounds are gaining in importance in the control of surface and drinking water due to their unwholesome properties. An accumulation of the organohalogen compounds, occurring mostly at low concentrations, is possible in different ways. The author discusses the possibility and problems of the extractability from waters with the aid of organic solvents. The group parameter EOX that can be determined does not allow any statement concerning components of individual substances, but gives some clues to the state of surface and drinking waters which are mostly anthropogenically polluted. Results of practical examples as well as theoretical considerations indicate the importance of the different distribution coefficients in the solvent/water extraction system. The degree of extraction can be considerably increased by the application of suitable mixtures of solvents. In waters with a known composition, the probably detectable EOX-quantity can be calculated by means of theoretical degrees of extraction.  相似文献   

6.
The patterns of variation of TiO2 conent during magmatic evolution are different in the so called “orogenic” and “anorogenie” basic associations; these last terms, which are the cause of much misunderstanding, can be replaced by the terms “isotitaniferous” and “anisotitaniferous”.  相似文献   

7.
8.
9.
10.
The “wave turbopause” is defined as the mesospheric altitude level where the temperature fluctuation field indicates a substantial increase in wave amplitudes in the vertical direction.The turbopause altitude is analyzed on the basis of four years of SABER data (2002–2005, Version 1.06). Substantial seasonal and latitudinal variations are found, with some interannual variability also present. Seasonal changes are annual at high latitudes, semi-annual at low latitudes, and a mixture of both at middle latitudes. Southern hemisphere data are similar as in the North if shifted by half a year. Latitudinal variations show a minimum in the tropics and two relative maxima at middle latitudes.The “wave turbopause” is found near to zero-wind lines or low-wind zones (zonal wind). It is compared to rocket and other measurements, and interesting similarities are obtained. The wave turbopause can also be found in the HAMMONIA GCM. A preliminary analysis shows results similar to those of the SABER measurements.  相似文献   

11.
12.
13.
14.
15.
16.
17.
In order to obtain high resolution correlograms, it is of importance amongst other things to get reflection signals with large bandwidth. An advantage of the VIBROSEIS *** *** Trade Mark and Service book of the Continental Oil Company.
method is that the frequencies radiated by the vibrators can be matched to the transmission response of the subsurface involved. By choosing the right frequency range, the highest possible amplitude and most favourable form may be given to the reflection signals. In a reflection correlogram, individual signals cannot be considered in isolation. Signals of different origin are interfering with one another. They very often have different amplitudes, so that it may be desirable in many cases to filter out events of certain apparent velocity. With the VIBROSEIS method this may be achieved quite simply. All frequencies of the noise signal are uniformly suppressed. The advantage is that noise signals, e.g. refraction signals, which cannot be sufficiently attenuated by wavelength filtering, may be completely eliminated by this velocity filtering without affecting the bandwith of the desired signal. The total dynamic range of the tape recording can be used for the registration of wanted events. To perform this kind of filtering several vibrators are necessary in the field; each of them is controlled by an individual signal. There is an unavoidable error of static and dynamic corrections which causes the results of reflection measurements to deteriorate when using multiple coverage. High frequency components especially are seriously affected by destructive interference. This difficulty can be avoided by using a VIBROSEIS signal with high frequency component amplitudes supported. For the probability of error of corrections a normal distribution is assumed. A smoothed amplitude characteristic may be achieved after stacking. The amplitude characteristic of seismic devices is commonly reduced to about 100 cps bandwidth. For further improvement of resolution of VIBROSEIS correlograms it is necessary to apply special filtering methods. This is of particular interest when any kind of gain control is used to display weak events more clearly. With increasing amplification the sidelobes of the strong signals may reach the size of the weak events. In order to eliminate this effect, the amplitude characteristic of the VIBROSEIS signal is adjusted for optimum suppression of side-lobes.  相似文献   

18.
In order to obtain high resolution correlograms, it is of importance amongst other things to get reflection signals with large bandwidth. An advantage of the VIBROSEIS *** *** Trade Mark and Service book of the Continental Oil Company.
method is that the frequencies radiated by the vibrators can be matched to the transmission response of the subsurface involved. By choosing the right frequency range, the highest possible amplitude and most favourable form may be given to the reflection signals. In a reflection correlogram, individual signals cannot be considered in isolation. Signals of different origin are interfering with one another. They very often have different amplitudes, so that it may be desirable in many cases to filter out events of certain apparent velocity. With the VIBROSEIS method this may be achieved quite simply. All frequencies of the noise signal are uniformly suppressed. The advantage is that noise signals, e.g. refraction signals, which cannot be sufficiently attenuated by wavelength filtering, may be completely eliminated by this velocity filtering without affecting the bandwith of the desired signal. The total dynamic range of the tape recording can be used for the registration of wanted events. To perform this kind of filtering several vibrators are necessary in the field; each of them is controlled by an individual signal. There is an unavoidable error of static and dynamic corrections which causes the results of reflection measurements to deteriorate when using multiple coverage. High frequency components especially are seriously affected by destructive interference. This difficulty can be avoided by using a VIBROSEIS signal with high frequency component amplitudes supported. For the probability of error of corrections a normal distribution is assumed. A smoothed amplitude characteristic may be achieved after stacking. The amplitude characteristic of seismic devices is commonly reduced to about 100 cps bandwidth. For further improvement of resolution of VIBROSEIS correlograms it is necessary to apply special filtering methods. This is of particular interest when any kind of gain control is used to display weak events more clearly. With increasing amplification the sidelobes of the strong signals may reach the size of the weak events. In order to eliminate this effect, the amplitude characteristic of the VIBROSEIS signal is adjusted for optimum suppression of side-lobes.  相似文献   

19.
20.
Vorgestellt wird ein einfaches Verfahren zur schnellen und gleichzeitig differenzierten Ansprache des Vcrkrautungszustandes von Fließgewässern für Zwecke der wasserwirtschaftlichen Praxis sowie zur ökologischen Beurteilung des Gewässers. Das Verfahren beruht auf der getrennten Bestimmung von Verkrautungsform und Verkrautungsgrad mit Hilfe eines Schlüssels, wobei die Verkrautungsform eine Synthese aus ökologischen und hydraulischen Einheiten darstellt. Die häufigsten Verkrautungsformen werden anhand von Bildern, die Anwendung anhand von Beispielen dargestellt.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号