The Stress Concentration of Multiplanar Tubular Joints of Offshore Structure

- The formulation for the stress concentration matrix of multiplanar tubular joint with braces subjected to combined load is established in this paper. The formulations for SCF values of multiplanar tubular joints are compared with those by Wordsworth and Efthymiou. The stiffening effect and load-interaction effect are discussed. A spatial offshore jacket with braces subjected to combined load is computed as a numerical example. The maximum stress of each multiplanar tubular joint and its location are found through SCF matrix. Finally, the difference between the maximum stresses of multiplanar tubular joints and their corresponding uniplanar tubular joints are discussed.     

Stress concentration factors (SCFs) of bulge formed K-joints under balanced axial loads

A novel stiffened joint called bulge formed joint was put forward. Compared with the unstiffened joint, an additional bulge plate is utilized to connect the chord and braces. Based on the finite element (FE) and experimental method, stress concentration factors (SCFs) were investigated for both a bulge formed K-joints and the corresponding unstiffened joint. By the verification of experimental data, the FE models were used to investigate the SCFs of the bulge formed joints. The maximum SCF of the bulge formed K-joint under balanced axial loads is located at the position φ = 105°, which is close to but not exactly the saddle. The SCFs around the intersection weld can decrease remarkably compared with the unstiffened joint by the change of geometrical parameters of the bulge plate. Then 2117 FE analyses were conducted to investigate the geometrical effects on SCFs of the bulge formed joint. These dimensionless geometrical parameters include τ_s, η₁, η₂, θ, β, γ, τ, among which, the first three parameters are typical of the bulge formed joints, while the others are same as the definitions in the unstiffened joints. Finally, a set of SCF parametric formulas were obtained by nonlinear regression analyses.     

Regression Formulations for the Stress at Hot Spot of Multiplanar Tubular DT Joints

- Stress concentration analysis of multiplanar tubular DT joints plays an important role in the fatigue design of offshore platforms. A semi-analytic method for stress analysis under the condition of any loads is briefly introduced in the paper. Nineteen multiplanar tubular DT joints with one of two braces of the same dimension subjected to axial loads and out- of- plane bending moments are computed for parametric stress analysis by using the present method. The influence of geometrical parameters on the stresses of multiplanar tubular DT joints is discussed and compared with corresponding uniplanar T joints. The regression formulae for the stress at hot spot of multiplanar DT joints are found by modification of SCF of corresponding uniplanar T joints. The parametric formulae for the maximum stress by superposition. Finally, the influences of stiffening effect and load-interaction effect on the maximum stress of DT joints are discussed.