Pore- and fracture-filling gas hydrate reservoirs in the Gulf of Mexico Gas Hydrate Joint Industry Project Leg II Green Canyon 955 H well

High-quality logging-while-drilling (LWD) downhole logs were acquired in seven wells drilled during the Gulf of Mexico Gas Hydrate Joint Industry Project Leg II in the spring of 2009. Well logs obtained in one of the wells, the Green Canyon Block 955 H well (GC955-H), indicate that a 27.4-m thick zone at the depth of 428 m below sea floor (mbsf; 1404 feet below sea floor (fbsf)) contains gas hydrate within sand with average gas hydrate saturations estimated at 60% from the compressional-wave (P-wave) velocity and 65% (locally more than 80%) from resistivity logs if the gas hydrate is assumed to be uniformly distributed in this mostly sand-rich section. Similar analysis, however, of log data from a shallow clay-rich interval between 183 and 366 mbsf (600 and 1200 fbsf) yielded average gas hydrate saturations of about 20% from the resistivity log (locally 50−60%) and negligible amounts of gas hydrate from the P-wave velocity logs. Differences in saturations estimated between resistivity and P-wave velocities within the upper clay-rich interval are caused by the nature of the gas hydrate occurrences. In the case of the shallow clay-rich interval, gas hydrate fills vertical (or high angle) fractures in rather than filling pore space in sands. In this study, isotropic and anisotropic resistivity and velocity models are used to analyze the occurrence of gas hydrate within both the clay-rich and sand dominated gas-hydrate-bearing reservoirs in the GC955-H well.     

Estimating saturation of gas hydrates using conventional 3D seismic data,Gulf of Mexico Joint Industry Project Leg II

We present a methodology for generating pre-drill estimations of hydrate saturations using conventional 3D seismic data. These seismic-based estimates will be compared with well log derived saturations from the subsequently drilled wells of the Gulf of Mexico Gas Hydrate Joint Industry Project Leg II (JIP Leg II) expedition.Predicting saturation of gas hydrates (S_h-seismic) combines pre-stack seismic inversion, rock physics modeling and stratigraphic interpretation. Before the wells were drilled, no nearby sonic and density logs were available to define and calibrate the elastic property trends for the shallow target interval containing the gas hydrate stability zone. Therefore, rock property trends were established by applying principles of rock physics and shallow sediment compaction, constrained by known regional geological parameters. S_h-seismic volumes were generated by inverting pre-stack data to acoustic impedance (PI) and shear impedance (SI) volumes, and then analyzing deviations from modeled impedance trends. To enhance the quality of the inversion, the signal-to-noise ratio of the offset data was maximized by conditioning the seismic prior to inversion. Seismic stratigraphic interpretation plays an important role by identifying the more promising strata and structures for the presence of gas hydrates.The pre-drill S_h-seismic results are compared with saturations calculated from log data, S_h-log, of the wells drilled in the JIP Leg II campaign. Due to weaker seismic reflections, predictions may be less accurate for low concentrations, such as saturations less than 40%, and for thin intervals below the vertical resolution of the seismic data (about 15 m). However, the integrated geophysical workflow is very effective for identifying and quantifying significant hydrate concentrations, making the method a promising prospecting technique.