共查询到20条相似文献,搜索用时 171 毫秒
1.
波浪谱形对不规则波数值模拟的影响 总被引:1,自引:0,他引:1
通过数值模拟分析了波浪谱形对不规则波浪数值模拟结果的影响.采用不同参数的JONSWAP谱模拟入射波要素,基于抛物型缓坡方程模拟不规则波浪的传播,分析了波浪谱形状对波浪数值模拟结果的影响.结果表明,采用抛物型缓坡方程模拟不规则波浪时,入射波浪谱形对模拟结果影响不明显;但由于模型中非线性项的影响,采用不规则波模拟的波高分布和采用规则波模拟的结果略有差别. 相似文献
2.
3.
4.
5.
为研究人工岛尺度变化和波浪方向分布对人工岛绕射波浪的影响,基于MIKE21-BW模型应用数值方法模拟人工岛波浪绕射过程。数值结果与Briggs等的物理试验结果的对比表明两者吻合较好,验证了模型的适用性。在规则波条件时,圆形人工岛绕射波浪的数值结果与线性波浪绕射理论解基本一致;采用该模型分别模拟了6种尺度的圆形人工岛、单向不规则波和9种方向分布θ_(max)、4种谱峰周期条件时绕射波浪分布情况。分析结果表明,圆形人工岛绕射系数随着尺度的增加,掩护区绕射系数随之减小;θ_(max)在10°~45°范围内,随着θmax的增大,绕射系数随之增大,θ_(max)在45°~75°内绕射系数变化较小;随着谱峰周期的增加,绕射系数随之增大。研究成果既为相关规范的完善提供了基础,也为相关工程设计提供了参考。 相似文献
6.
基于势流理论和时域高阶边界元方法,建立了三维完全非线性数值波浪水槽模型.利用源造波法产生入射波浪,应用五阶斯托克斯波理论给定波浪速度;采用混合欧拉-拉格朗日方法追踪流体瞬时水面,将二阶泰勒级数展开法应用于更新下一时间步的波面和速度势;通过加速势的方法准确计算自由水面速度的法向导数和物面速度势的时间导数.对完全非线性波浪进行了模拟,得到了稳定的波形.当波浪非线性较小时,与四阶Runge- Kutta法(RK4)计算结果和五阶斯托克斯波理论解均吻合良好;随着波浪非线性的增大,计算结果误差逐渐增大.通过数值试验分析,在满足精度要求的基础上,本方法计算时间略大于四阶Runge- Kutta法的四分之一,大大减少了计算量. 相似文献
7.
本文基于线性绕射理论,提出了采用波源分布法计算矩形人工岛上波浪爬高的数值模型.在三种入射波向(α=0°、45°、90°)下进行数值计算,所得到的结果与整体模型试验的实测结果进行了比较,二者吻合较好.表明波源分布法是确定波浪爬高的一个有效方法,可为人工岛工程设计提供可靠的高度参数. 相似文献
8.
非线性波浪时域计算的三维耦合模型 总被引:3,自引:1,他引:2
将计算区域Ω划分为内域Ω1和外域Ω2(Ω2=Ω-Ω1),外域控制方程采用改进线性频散特性的二维Boussinesq方程,用预报一校正法数值求解;结构物附近的内域控制方程为三维Navier-Stokes方程,由VOF方法数值求解。通过在外域和内域相匹配的交界面上设置合适的速度和波面边界条件,建立了三维非线性波浪时域计算的耦合模型。模拟试验表明:(1)耦合模型数值波浪水池可以产生稳定的、重复性较好的波动过程;(2)用耦合模型数值波浪水池求解较大浅水区域上的非线性波浪数值计算问题可以取得较高的计算效率,同时又能得出结构物附近的复杂流场。 相似文献
9.
10.
基于实测波面的波浪力获取作为结构动力响应分析以及数字孪生模型建立的必备环节,对海上风电数字化运维至关重要。为了满足更大的装机容量需求,单桩式海上风电基础趋于大型化,其尺度因子D/L也随之增大;并且实际海域均为非规则波,以尺度因子划分波浪力计算理论的方法对非规则波的适用性尚不明确。通过建立数值水槽,依据实际工况对不规则波与桩基的作用进行数值模拟,得到入射波浪场与桩基所受波浪力,在此基础上,基于入射波浪场分别采用Morison方程以及绕射理论求解波浪力并将之与数值模拟结果进行对比,分析了不同波浪力计算理论关于尺度因子的适用性,同时探究了波浪要素对计算精度的影响。结果表明:Morison方程在波高较大时精度下降;相对于Morison方程,绕射理论在该尺度下的精度更高。最后,通过分析实测数据进一步探讨了典型工况下的波浪力特征,以期通过实测波面计算波浪力的方法为实际服役风机波浪力计算提供技术支持。 相似文献
11.
1 Introduction A vertical wall is one of the typical maritime sheltering structures in the coastal region, which is mainly subjected to wave forces. It has been a com- mon engineering assumption adopted for design pur- poses that normally incident wave fo… 相似文献
12.
A numerical solution is developed to investigate the generation and propagation of small-amplitude water waves in a semi-infinite rectangular wave basin. The three-dimensional wave field is produced by the prescribed “snake-like” motion of an array of segmented wave generators located along the wall at one end of the tank. The solution technique is based on the boundary element approach and uses an appropriate three-dimensional Green function which explicitly satisfies the tank-wall boundary conditions. The Green function and its derivatives which appear in the integral equation formulation can be shown to be slowly convergent when the source and field points are in close proximity. Therefore, when computing the velocity potentials on the wave generators, the source points are chosen outside the fluid domain, thereby ensuring the rapid convergence of these functions and rendering the integral equations non-singular. Numerical results are shown which illustrate the influence of the various wavemaker and basin parameters on the generated wave field. Finally, the complete wave field produced by the diffraction of oblique waves by a vertical circular cylinder in a basin is presented. 相似文献
13.
This paper presents an analytical solution for scattering of oblique incident, small amplitude, monochromatic wave trains by a stationary rigid multi-layered objects with rectangular cross-section. The object is infinite long and consists of multilayers, which can be either solid or permeable. This paper extends the previous work by Hu and Liu [1] from normal incident wave condition with a special object configuration to oblique incident waves with multi-layered object. The present model is validated with several existing solutions for normal/oblique waves interacting with a single object; excellent agreement is observed. New numerical results are presented to investigate the effects of incidence angle on reflection, transmission and energy loss coefficients for a combined floating and bottom-mounted permeable breakwater. A new floating board-cage breakwater is developed from the present model and its solutions are discussed in detail. A computer program, AWAS-P, has been updated so that it is applicable for both oblique and normal incident waves, while the object is multi-layered. 相似文献
14.
If the upstream boundary conditions are prescribed based on the incident wave only, the time-dependent numerical models cannot effectively simulate the wave field when the physical or spurious reflected waves become significant. This paper describes carefully an approach to specifying the incident wave boundary conditions combined with a set sponge layer to absorb the reflected waves towards the incident boundary. Incorporated into a time-dependent numerical model, whose governing equations are the Boussinesq-type ones, the effectiveness of the approach is studied in detail. The general boundary conditions, describing the down-wave boundary conditions are also generalized to the case of random waves. The numerical model is in detail examined. The test cases include both the normal one-dimensional incident regular or random waves and the two-dimensional oblique incident regular waves. The calculated results show that the present approach is effective on damping the reflected waves towards the incident wave boundary. 相似文献
15.
Due to their capability of correctly representing wave characteristics, the number of numerical models based on Navier–Stokes equation (NSE) models has recently increased remarkably. One of the key challenges of this type of wave model, however, is to minimize the wave re-reflection from the incident boundary. Many numerical techniques have been developed to deal with this problem, and previous studies have reported on internal wave makers that employ NSE. Research on generation and transformation of irregular waves using a three-dimensional NSE model, however, has begun very recently, and few studies have yet been reported. In this study, a three-dimensional numerical model was applied to generate irregular waves, and transformation of irregular waves was simulated in a numerical wave tank. The model was first verified by applying it to simple numerical tests in two dimensions. The model was then used to generate directional monochromatic and irregular waves in three dimensions. The numerical results were compared with the analytical solutions, and good agreement was observed. Finally, the model was applied to simulate the transformation of irregular waves over an uneven bottom geometry in a wave tank. 相似文献
16.
The Goda's method of separating the frequency spectrum of the unidirectional incident and reflected waves is improved. The proposed method can be applied to the separation of oblique incident and reflected waves and the two wave gauges can be arranged in an arbitrary angle in front of a structure. When the projected distance of the two probes on the incident wave direction is the multiple ofthe half length of the incident waves, the singular problem will emerge by using the method. It is advised that when the projected distance of the two measured points on the incident wave direction is 0.05~0.45 times the wave length of peak frequency wave, good results can be obtained. The simulated resultant waves are separated by the method of numerical simulation and the separated wave spectra are basically corresponding to the target spectra input. The wave trains calculated by the separated incident and reflected wave frequency spectrum are approximated to the input wave trains and the reflected coefficient can be derived correctly. Therefore, the method proposed in this paper is reliable. 相似文献
17.
Application of desingularized approach to water wave propagation over three-dimensional topography 总被引:1,自引:0,他引:1
A numerical approach based on desingularized boundary element method and mixed Eulerian–Lagrangian formulation [Zhang et al., 2006. Wave propagation in a fully nonlinear numerical wave tank: a desingularized method. Ocean Engineering 33, 2310–2331] is extended to solve the water wave propagation over arbitrary topography in a three-dimensional wave tank. A robust damping layer applicable for regular and irregular incident waves is employed to minimize the outgoing wave reflection back into the wave tank. Numerical results on the propagation of regular and irregular incident waves over the flat bottom and linear incident waves over an elliptical shoal show good concurrence with the corresponding analytical solutions and experimental data. 相似文献
18.
Benchmark computations of wave run-up on single cylinder and four cylinders by naoe-FOAM-SJTU solver
The benchmark simulations of wave run-up on a fixed single truncated circular cylinder and four circular cylinders are presented in this paper. Our in-house CFD solver naoe-FOAM-SJTU is adopted which is an unsteady two-phase CFD code based on the open source package OpenFOAM. The Navier-Stokes equations are employed as the governing equations, and the volume of fluid (VOF) method is applied for capturing the free surface. Monochromatic incident waves with the specified wave period and wave height are simulated and wave run-up heights around the cylinder are computed and recorded with numerical virtual wave probes. The relationship between the wave run-up heights and the incident wave parameters are analyzed. The numerical results indicate that the presented naoe-FOAM-SJTU solver can provide accurate predictions for the wave run-up on one fixed cylinder and four cylinders, which has been proved by the comparison of simulated results with experimental data. 相似文献
19.
20.
The wave diffraction around an array of fixed vertical circular cylinders is simulated in a numerical wave tank by using a fully nonlinear model in the time domain. The emphasis of the paper lies in the insightful investigation of the nonlinear properties of the near-trapping phenomenon associated with the multiple cylinders. The numerical model is validated by analytical solutions as well as experimental data for waves propagating past two and four vertical cylinders in certain arrangements. An array of four identical circular cylinders at the corners of a square with an incident wave along the diagonal of the square is the main focus here for investigating the near-trapping phenomenon. When near-trapping occurs, the present study shows that an extremely high wave elevation near the cylinders can be observed. At the same time, the hydrodynamic forces on different cylinders are found to be either in phase or out of phase, leading to some characteristic force patterns acting on the whole structure. Due to the nature of the numerical model adopted, nonlinearity at different orders can be captured using a harmonic analysis. In addition to first- and second-order near-trapping, the third-order (triple-frequency) nonlinear component is presented for the first time. For the configuration selected, it is found that at one specific incident wave frequency and direction one trapped mode is excited by second-order effects, while a different trapped mode (having similar symmetries) is excited by the third harmonic of the incident wave frequency. 相似文献