Ground‐based lidar measurements of aerosols during ACE‐2: instrument description, results, and comparisons with other ground‐based and airborne measurements

A micro‐pulse lidar system (MPL) was used to measure the vertical and horizontal distribution of aerosols during the Aerosol Characterization Experiment 2 (ACE‐2) in June and July of 1997. The MPL measurements were made at the Izaña observatory (IZO), a weather station located on a mountain ridge (28°18' N, 16°30' W, 2367 m asl) near the center of the island of Tenerife, Canary Islands. The MPL was used to acquire aerosol backscatter, extinction, and optical depth profiles for normal background periods and periods influenced by Saharan dust from North Africa. System tests and calibration procedures are discussed, and an analysis of aerosol optical profiles acquired during ACE‐2 is presented. MPL data taken during normal IZO conditions (no dust) showed that upslope aerosols appeared during the day and dissipated at night and that the layers were mostly confined to altitudes a few hundred meters above IZO. MPL data taken during a Saharan dust episode on 17 July showed that peak aerosol extinction values were an order of magnitude greater than molecular scattering over IZO, and that the dust layers extended to 5 km asl. The value of the dust backscatter–extinction ratio was determined to be 0.027±0.007 sr⁻¹. Comparisons of the MPL data with data from other co‐located instruments showed good agreement during the dust episode.     

Evolution of boundary‐layer aerosol particles due to in‐cloud chemical reactions during the 2nd Lagrangian experiment of ACE‐2

The second Aerosol Characterisation Experiment (ACE‐2) was aimed at investigating the physical, chemical and radiative properties of aerosol and their evolution in the North Atlantic region. In the 2nd "Lagrangian" experiment, an air mass was tracked over a 30‐h period during conditions of extensive stratocumulus cover. Boundary‐layer measurements of the aerosol size distribution obtained with a passive cavity aerosol spectrometer probe (PCASP) during the experiment show a gradual growth in size of particles in the 0.1–0.2 μm diameter mode. Simultaneously, SO₂ concentrations were found to decrease sharply from 800 to 20 ppt. The fraction of sulphate in aerosol ionic mass increased from 0.68±0.07 to 0.82±0.09 for small particles (diameter below 1.7 μm) and from 0.21±0.04 to 0.34±0.03 for large particles (diameter above 1.7 μm). The measurements were compared with a multicyclic parcel model of gas phase diffusion into cloud droplets and aqueous phase chemical reactions. The model was able to broadly reproduce the observed transformation in the aerosol spectra and the timescale for the transformation of SO₂ to sulphate aerosol. The modelled SO₂ concentration in the boundary layer fell to below half its initial value over a 6.5‐h time period due to a combination of the entrainment of cleaner tropospheric air and cloud chemical reactions. NH₃ and HCl gas were also found to play an important rôle in cloud processing in the model.     

Cloud condensation nuclei and cloud droplet measurements during ACE‐2

During the 2nd Aerosol Characterization Experiment (ACE‐2), relationships between stratocumulus cloud properties and aerosols were examined. Here, the relevant measurements including the cloud condensation nuclei (CCN) activation spectrum, updraft velocity, cloud microphysical and aerosol properties are presented. It is shown that calculations of droplet concentration based on updraft velocity and the CCN activation spectrum are consistent with direct observations. Also discussed is an apparent disparity among measurements of the CCN activation spectrum, the accumulation mode size distribution, and the composition of the submicrometric aerosol. The observed consistency between CCN, updraft and cloud droplets is a necessary refinement; however, extended analyses of the ACE‐2 data set are needed to guide improvements in model simulations of the interaction between aerosols and cloud microphysics. In particular, there is need for an examination of aerosol size spectra and chemical composition measurements with a view towards validating droplet activation schemes which relate the aerosol and cloud dynamical properties to cloud albedo.     

Size‐segregated chemical, gravimetric and number distribution‐derived mass closure of the aerosol in Sagres, Portugal during ACE‐2

During the ACE‐2 field campaign in the summer of 1997 an intensive, ground‐based physical and chemical characterisation of the clean marine and continentally polluted aerosol was performed at Sagres, Portugal. Number size distributions of the dry aerosol in the size range 3–10 000 nm were continuously measured using DMPS and APS systems. Impactor samples were regularly taken at 60% relative humidity (RH) to obtain mass size distributions by weighing the impactor foils, and to derive a chemical mass balance by ion and carbon analysis. Hygroscopic growth factors of the metastable aerosol at 60% RH were determined to estimate the number size distribution at a relative humidity of 60%. A size segregated 3‐way mass closure study was performed in this investigation for the first time. Mass size distributions at 60% RH derived from number size distribution measurements and impactors samples (weighing and chemical analysis) are compared. A good agreement was found for the comparison of total gravimetrically‐determined mass with both number distribution‐derived (slope=1.23/1.09; R²>0.97; depending on the parameters humidity growth and density) and chemical mass concentration (slope=1.02; R²= 0.79) for particles smaller than 3 μm in diameter. Except for the smallest impactor size range relatively good correlations (slope=0.86–1.42) with small deviations (R²=0.76–0.98) for the different size fractions were found. Since uncertainties in each of the 3 methods are about 20% the observed differences in the size‐segregated mass fractions can be explained by the measurement uncertainties. However, the number distribution‐derived mass is mostly higher than the chemically and gravimetrically determined mass, which can be explained by sampling losses of the impactor, but as well with measurement uncertainties as, e.g., the sizing of the DMPS/APS.     

Regional aerosol optical depth characteristics from satellite observations: ACE‐1, TARFOX and ACE‐2 results

Analysis of the aerosol properties during 3 recent international field campaigns (ACE‐1, TARFOX and ACE‐2) are described using satellite retrievals from NOAA AVHRR data. Validation of the satellite retrieval procedure is performed with airborne, shipboard, and land‐based sunphotometry during ACE‐2. The intercomparison between satellite and surface optical depths has a correlation coefficient of 0.93 for 630 nm wavelength and 0.92 for 860 nm wavelength. The standard error of estimate is 0.025 for 630 nm wavelength and 0.023 for 860 nm wavelength. Regional aerosol properties are examined in composite analysis of aerosol optical properties from the ACE‐1, TARFOX and ACE‐2 regions. ACE‐1 and ACE‐2 regions have strong modes in the distribution of optical depth around 0.1, but the ACE‐2 tails toward higher values yielding an average of 0.16 consistent with pollution and dust aerosol intrusions. The TARFOX region has a noticeable mode of 0.2, but has significant spread of aerosol optical depth values consistent with the varied continental aerosol constituents off the eastern North American Coast.     

Boundary layer and aerosol evolution during the 3rd Lagrangian experiment of ACE‐2

Aircraft measurements are presented of the Lagrangian evolution of a marine boundary layer over a 30‐h period during the ACE‐2 field campaign. At the start of the observational period, a 500‐m deep polluted marine internal boundary layer (MIBL) was overlain by the remnants of a polluted continental boundary layer extending to around 2 km below a clean, dry free troposphere. The MIBL grew rapidly to a thickness of 900–1000 m in response to increasing sea surface temperatures. No significant aerosol spectral evolution was observed in the boundary layer. Low concentrations of SO₂ were observed in the MIBL suggesting that the air mass contained relatively aged aerosol. Aerosol spectra show a broad mode with a modal diameter of around 0.1μm. The polluted layer between the MIBL and the unpolluted free troposphere was only weakly and intermittently turbulent which prevented significant entrainment of clean air into the polluted layer from aloft. The polluted layer depth was thus controlled mainly by subsidence which as a result becomes shallower, decreasing from over 2000 m to around 1200 m during the observational period. The aerosol characteristics of the polluted layer were similar to those in the MIBL and so although the MIBL entrained considerable amounts of air from above the MIBL the aerosol characteristics underwent no significant change. This has important implications for the rate at which a polluted continental air mass is converted to a clean marine one. The dataset should prove useful in the validation of the modelling of continental pollution outbreaks.     

Shipboard measurements of concentrations and properties of carbonaceous aerosols during ACE‐2

Mass concentrations of total, organic and black carbon were derived by analyzing the supermicron and submicron aerosol fractions of shipboard collected samples in the easternAtlantic Ocean as part of the second Aerosol Characterization Experiment (ACE‐2). These analyses were complemented by experiments intended to estimate the water‐soluble fraction of the submicron carbonaceous material. Our results can be summarized as follows. Depending on the sample, between 35% and 80% of total aerosol carbon is associated with the submicron fraction. Total submicron carbon was well correlated with black carbon, a unique tracer for incomplete combustion. These correlations and the approximately constant total to black carbon ratios, suggest that the majority of submicron total carbon is of primary combustion derived origin. No systematic relationship between total submicron aerosol carbon and sulfate concentrations was found. Sulfate concentrations were, with a few exceptions, significantly higher than total carbon. Our experiments have demonstrated that water exposure removed between 36% and 72% of total carbon from the front filter, suggesting that a substantial fraction of the total submicron aerosol organic carbon is water‐soluble. An unexpected result of this study is that water exposure of filter samples caused substantial removal of, nominally insoluble, submicron black carbon. Possible reasons for this observation are discussed.     

Observations of the evolution of the aerosol, cloud and boundary‐layer characteristics during the 1st ACE‐2 Lagrangian experiment

During the 1st Lagrangian experiment of the North Atlantic Regional Aerosol Characterisation Experiment (ACE‐2), a parcel of air was tagged by releasing a smart, constant level balloon into it from the Research Vessel Vodyanitskiy . The Meteorological Research Flight's C‐130 aircraft then followed this parcel over a period of 30 h characterising the marine boundary layer (MBL), the cloud and the physical and chemical aerosol evolution. The air mass had originated over the northern North Atlantic and thus was clean and had low aerosol concentrations. At the beginning of the experiment the MBL was over 1500 m deep and made up of a surface mixed layer (SML) underlying a layer containing cloud beneath a subsidence inversion. Subsidence in the free troposphere caused the depth of the MBL to almost halve during the experiment and, after 26 h, the MBL became well mixed throughout its whole depth. Salt particle mass in the MBL increased as the surface wind speed increased from 8 m s⁻¹ to 16 m s⁻¹ and the accumulation mode (0.1μm to 3.0 μm) aerosol concentrations quadrupled from 50 cm⁻³ to 200 cm⁻³. However, at the same time the total condensation nuclei (>3 nm) decreased from over 1000 cm⁻³ to 750 cm⁻³. The changes in the accumulation mode aerosol concentrations had a significant effect on the observed cloud microphysics. Observational evidence suggests that the important processes in controlling the Aitken mode concentration which, dominated the total CN concentration, included, scavenging of interstitial aerosol by cloud droplets, enhanced coagulation of Aitken mode aerosol and accumulation mode aerosol due to the increased sea salt aerosol surface area, and dilution of the MBL by free tropospheric air.     

Cloud optical thickness and albedo retrievals from bidirectional reflectance measurements of POLDER instruments during ACE‐2

The POLDER instrument is devoted to global observations of the solar radiation reflected by the Earth–atmosphere system. The airborne version of the instrument was operated during the ACE‐2 experiment, more particularly as a component of the CLOUDYCOLUMN project of ACE‐2 that was conducted in summer 1997 over the subtropical northeastern Atlantic ocean. CLOUDYCOLUMN is a coordinated project specifically dedicated to the study of the indirect effect of aerosols. In this context, the airborne POLDER was assigned to remote measurements of the cloud optical and radiative properties, namely the cloud optical thickness and the cloud albedo. This paper presents the retrievals of those 2 cloud parameters for 2 golden days of the campaign 26 June and 9 July 1997. Coincident spaceborne ADEOS‐POLDER data from 2 orbits over the ACE‐2 area on 26 June are also analyzed. 26 June corresponds to a pure air marine case and 9 July is a polluted air case. The multidirectional viewing capability of airborne POLDER is here demonstrated to be very useful to estimate the effective radius of cloud droplet that characterizes the observed stratocumulus clouds. A 12 μm cloud droplet size distribution appears to be a suitable cloud droplet model in the pure marine cloud case study. For the polluted case the mean retrieved effective droplet radius is of the order of 6–10 μm. This only preliminary result can be interpreted as a confirmation of the indirect effect of aerosols. It is consistent with the significant increase in droplet concentration measured in polluted marine clouds compared to clean marine ones. Further investigations and comparisons to in‐situ microphysical measurements are now needed.