Removing vessels from the water for biofouling treatment has the potential to introduce mobile non-indigenous marine species

Vessels found contaminated with biofouling non-indigenous marine species are predominantly removed from the water and treated in vessel maintenance facilities (i.e., slipways, travel lifts and dry-docks). Using pre-fouled settlement plates to simulate a vessel’s removal from the water for treatment, we demonstrate that a range of mobile organisms (including non-indigenous marine species) may be lost to the marine environment as a consequence of this process. We also determined that different levels of biofouling (primary, secondary and tertiary) and emersion durations (0.5, 5 and 15 min) affected the abundance and composition of mobile taxa lost to the marine environment. Primary biofouling plates lost 3.2% of total animals, secondary plates lost 19.8% and tertiary plates lost 8.2%, while hanging duration had only minor effects. The results suggest that removing vessels contaminated with biofouling non-indigenous marine species from the water for treatment may not be as biosecure as is currently recognised.     

Laboratory tests as a basis for the control of sewage sludge dumping at sea

Toxicity and bioaccumulation studies were carried out on a number of UK sewage sludges to determine whether laboratory experiments could be used to regulate sludge dumping at sea. Whilst the acute toxicity of sewage sludges to adult marine organisms was generally low, shrimp larvae were found to be up to 500 times more sensitive than adults of the same species. No significant bioaccumulation of mercury or cadmium could be detected following up to 60 days exposure of fish, shrimps and mussels to the most heavily contaminated sludges available, although there was some uptake of lead, zinc and copper.     

International aspects of invasive species management: a research agenda

We propose a research agenda for studying six basic questions about the impacts of alternate international invasive species control mechanisms on economic agents in a nation such as the USA. The six questions are as follows. First, when can one justify a trade ban as an effective regulatory policy? Second, what are the properties of control rules that vary by port of entry and whether a shipment is viewed as a routine or as a first-time entry? Third, when should a port manager in the USA use information about the dollar value of the products being transported by ships from two exporting firms and the expected time it takes to inspect ships from these two firms to grant preferential treatment to one or the other firm? Fourth, what are some reasonable measures of the trade related risk from invasive species? Fifth, how useful is strategic trade policy as an invasive species management tool? Finally, when analyzing a biological invasion, is it more appropriate to focus on the likelihood of this event or, instead, on the magnitude of the event?     

Decadal record of sediment export to the deep sea via Eel Canyon

An active upper-canyon system, Eel Canyon, was studied to determine its role as a conduit and/or sink for terrigenous material over decadal timescales and to assess the sedimentary record preserved by transport processes. These data are used to (1) link seasonal fluctuations in sediment transport and deposition to preserved stratigraphic signatures, and (2) assess sediment storage and removal in the upper Eel Canyon (100–850 m water depth) over decadal timescales. Previous research has shown that upper thalwegs commonly experience gravity-driven flows during winter (November–March), due to increased sediment supply from Eel River flooding and intense storms that produce energetic wave/current conditions. Thick winter deposits composed of recently discharged fluvial sediment are formed in upper thalwegs, with distinct short- and long-lived radioisotopic and textural signatures (detectable ⁷Be and ²³⁴Th_xs, lowered ²¹⁰Pb activity, elevated clay content, and physical structures). Box and kasten cores were collected in the upper canyon (thalwegs and walls) to measure these signatures in recent and preserved winter deposits, and to calculate 100-yr accumulation rates. Non-bioturbated deposits (that have signatures indicative of rapid accretion by gravity-driven flows during the winter) are common in the upper canyon thalwegs. Short-lived radioisotopes (⁷Be and ²³⁴Th) show that sediment delivery to the upper thalweg varies temporally, sometimes beginning at the onset of river flooding, and at other times beginning during fall/early winter dry-storm events. In contrast, bioturbated deposits (which do not have signatures indicative of rapid deposition) are found on canyon walls.Non-bioturbated winter deposits are easily identified in the decadal record of thalwegs by decreases in ²¹⁰Pb activity and increases in clay content. Stacking of multiple years of winter deposits (∼10 cm preserved per winter) results in non-steady-state ²¹⁰Pb profiles and high decadal accumulation rates. However, down-core changes in ²¹⁰Pb profiles show that slope failures are actively redistributing these winter deposits. Partial or total removal of multiple winter deposits appears to happen periodically (every ∼13 yr), which will inhibit preservation of the longer decadal record. 100-yr accumulation rates were calculated in the thalwegs from the resulting ²¹⁰Pb profiles (i.e., the result of winter accretion and decadal removal by failures). Accumulation rates are much higher in thalwegs (1–6 cm/yr) than walls (0.1–0.8 cm/yr), which is likely the result of differing sediment delivery processes (via gravity-driven flows and nepheloid layers, respectively). At least 2.6±1.4% of the Eel River sediment budget is accumulating in the upper canyon over 100-yr timescales. However, this value greatly underestimates the total amount entering the canyon system because minimum accumulation rates were used in many areas (due to limited core length) and slope failures are moving sediment out of the budget area.     

Optimization of structural control via a smart NEURO‐FBG control system

This study improves a NEURO‐FBG active control system to mature the concept of a smart structure. Originally, a system similar to the human brain is created from FBG sensors and neural networks. The system comprises three parts, namely, a structural condition surveillance system, a NEURO‐FBG converter, and a NEURO‐FBG controller. To solve the inherent time‐consuming and reliability problem of the NEURO‐FBG converter, a new technology is first proposed, and the relationship between inter‐story drift and strain data is established. Global indices such as displacement and velocity of the structure are then reconstructed for searching the optimal control force of the actuator. Meanwhile, the soundness of a building with hydraulic actuators is also an important issue to be solved. To make the building sound, the characteristics of earthquakes are considered for enhancing the performance of the NEURO‐FBG controller. Theoretical analysis shows satisfactory improvement to the control efficiency of both displacement and acceleration. To verify the enhanced system, a series of shaking table tests was conducted. Experimental results demonstrated that the new NEURO‐FBG system can effectively manage the structure; and the controller, taking into consideration the ground acceleration effect, is more reliable and robust for practical application than a conventional controller. Copyright © 2007 John Wiley & Sons, Ltd.     

Thermal stability of soil organic carbon subjected to water erosion as a function of edaphic factors

The stability of soil organic carbon （SOC）,as it relates to resistance to decomposition,is important for greenhouse gas emission and climate change.However,the SOC stabilization and its related influencing factors subjected to water erosion remain uncertain.The objective of the current study was to determine the SOC stability under long-term water erosion and to investigate the link between SOC stability and edaphic factors.Soil samples from eroded,depositional,and control sites in a closed wate...     

Response of a harbour opened to a sea of variable depth

Wave-induced oscillations in a circular harbour with protruding breakwaters and narrow mouth are analytically investigated by using a variational method. The effects of the bottom topography of the contiguous external sea are studied, especially as far as Helmholtz resonance is concerned; it has been found that the amplitude of the resonance peak is quite sensitive to the depth variation, while the related resonance wavenumber is more stable.     

Eradication success down under: heat treatment of a sunken trawler to kill the invasive seaweed Undaria pinnatifida

Eradication of invasive species is difficult in the marine environment, and there have only been a few successes. We report the successful eradication of the invasive seaweed Undaria pinnatifida from a sunken trawler in the Chatham Islands, New Zealand. New heat-treatment methods were developed as the most cost effective and environmentally acceptable option to kill Undaria. Monitoring of the trawler for three years after it sank found no Undaria after the vessel was treated. Key factors in the success of the eradication programme included: early detection, a rapid response, pre-existing knowledge of Undaria, an adaptive management approach, targeting of multiple life history stages, and the cooperation of the vessel's insurer.     

等效力控制方法在拟动力试验中的应用

为了避免用复杂的迭代求解拟动力试验隐式逐步积分方法的非线性运动方程,作者提出了一种用反馈控制求解的方法—等效力控制方法。这篇文章首先介绍等效力控制方法的原理;然后通过数值模拟和试验验证此方法的有效性。数值模拟和试验的结果都表明,当选用合理的等效力控制器参数时,此方法可以取得非常好的稳定性和精度。数值模拟的结果还表明尽管等效力控制方法是以力作为反馈控制的对象,此方法能有效完成对具有负刚度试件的加载。     

Research on semi-active control method of a building structure based on non-smooth control

This study investigates the effectiveness of the non-smooth semi-active control algorithm on suppressing the vibration performance of a building structure subjected to seismic waves. According to the Lyapunov stability theory, it has bene proven that the non-smooth semi-active control algorithm can achieve a finite-time stability of the vibration relative to the isolation layer of a building structure. Through numerical simulation of two buildings with different parameters subjected to the input of a seismic wave, the vibration conditions of passive control, LQR semi-active control and non-smooth semiactive control are compared and analyzed. The simulation results show that the non-smooth semi-active control algorithm has a better robustness and effectiveness in restraining the impact of earthquakes on the structure.     

Application of a data assimilation method via an ensemble Kalman filter to reactive urea hydrolysis transport modeling

With growing importance of water resources in the world, remediations of anthropogenic contaminations due to reactive solute transport become even more important. A good understanding of reactive rate parameters such as kinetic parameters is the key to accurately predicting reactive solute transport processes and designing corresponding remediation schemes. For modeling reactive solute transport, it is very difficult to estimate chemical reaction rate parameters due to complex processes of chemical reactions and limited available data. To find a method to get the reactive rate parameters for the reactive urea hydrolysis transport modeling and obtain more accurate prediction for the chemical concentrations, we developed a data assimilation method based on an ensemble Kalman filter (EnKF) method to calibrate reactive rate parameters for modeling urea hydrolysis transport in a synthetic one-dimensional column at laboratory scale and to update modeling prediction. We applied a constrained EnKF method to pose constraints to the updated reactive rate parameters and the predicted solute concentrations based on their physical meanings after the data assimilation calibration. From the study results we concluded that we could efficiently improve the chemical reactive rate parameters with the data assimilation method via the EnKF, and at the same time we could improve solute concentration prediction. The more data we assimilated, the more accurate the reactive rate parameters and concentration prediction. The filter divergence problem was also solved in this study.     

Stack unit mapping of coastal aquifer to predict and control sea water intrusion using remote sensing and a geographical information system

Aquifers are inherently susceptible to contamination and coastal aquifers in specific are highly vulnerable to sea water intrusion. For efficient planning and management of coastal aquifers in Kayalpattu and Tiruchopuram villages, which extend over 4·05 km², it is essential to delineate and predict the extent of intrusion into the shallow aquifer. Management of ground water in coastal aquifers is composed of major elements that should be properly evaluated, and special attention is given to the sea water intrusion problem. Different data, like hydro‐geomorphological and depth‐wise iso‐apparent resistivity, are integrated spatially using a geographical information system. The stack‐unit mapping approach is used to delineate the zones with iso‐apparent resistivity of less than 10 Ω m have been found to be increasing in areal extent with reference to depth. Copyright © 2003 John Wiley & Sons, Ltd.     

Sensitivity of sea ice and ocean simulations to sea ice salinity in a coupled global climate model

The impacts of the spatiotemporal variations of sea ice salinity on sea ice and ocean characteristics have not been studied in detail, as the existing climate models neglect or misrepresent this process. To address this issue, this paper formulated a parameterization with more realistic sea ice salinity budget, and examined the sensitivity of sea ice and ocean simulations to the ice salinity variations and associated salt flux into the ocean using a coupled global climate model. Results show that the inclus...     

Thermal enhancement of natural magnetism as a tool for tracing eroded soil

Determining sources, quantities and travel distances of eroding soil is of increasing importance given its impact on‐ and off‐site, the sediment‐associated transport of nutrients, metals and micro‐organisms and the ongoing need to provide data for soil erosion model development and validation. Many soil tracers have been developed; however, most comprise foreign materials, such as fluorescent beads and rare earth oxides, which cast doubts on the validity of tracing results given their different physical characteristics. To avoid these problems, we have investigated the potential of soil, which has been heated under reducing conditions to enhance its ferrimagnetic content, as a soil erosion tracer; while the technique has been used successfully to trace river sediment it has not been successfully applied to soil erosion studies. For a suite of 16 magnetic concentration‐dependent properties, values were found to be significantly greater, by at least one order of magnitude, after heating, both for the bulk soil and nine individual particle size fractions. Individual size fractions could be differentiated using two different magnetic properties, thus illustrating the technique's potential to provide information on particle size‐specific erosion. Soil box experiments demonstrated the potential for both in situ measurement of magnetic susceptibility and laboratory measurement of the magnetic properties of eroded sediment, to trace and quantify soil erosion. Thus, heated soil, with artificially‐enhanced ferrimagnetic properties, is successfully demonstrated to have great potential as a size‐specific, cost‐effective and representative soil erosion tracer. Copyright © 2012 John Wiley & Sons, Ltd.