Layer thicknesses and velocities of wave overtopping flow at seadikes

Seadikes often fail due to wave overtopping and a failure of the landward slope. Therefore, these aspects have to be taken into account for the design of seadikes. In present design, the calculation of the crest height of seadikes is essentially based on using a design water level and the corresponding wave run-up height. An average overtopping rate is generally considered for wave overtopping which can not account for the stresses and other effects due to extreme individual overtopping events. Landward slope design is more or less based on experience. It can be concluded from failure analysis that dike failures on the landward slope are rather initiated by individual overtopping events, in particular by the related overtopping flow velocities and layer thicknesses which are relevant for the prediction of erosion, infiltration and slip failure. Therefore, overtopping flow velocities and layer thicknesses are required in addition to average overtopping rates as hydraulic boundary conditions for the geotechnical stability analysis of seadikes.The objective of the present paper is the theoretical and experimental determination of overtopping flow velocities and layer thicknesses on the seaward slope, the dike crest and the landward slope of a seadike. Overtopping parameters are derived on the basis of small scale model tests which are required for the design of the landward slope and to avoid dike failures by wave overtopping in the future. For the prediction of the layer thicknesses and the velocities of the overtopping flow on the seaward slope, the dike crest and the landward slope, a set of theoretical formulas is derived and validated by hydraulic scale model tests.