Comparison of isotope pairing and N2:Ar methods for measuring sediment denitrification—Assumption, modifications, and implications

Denitrification has been measured during the last few years using two different methods in particular: isotope pairing measured on a triple-collector isotopic ratio mass spectrometer and N₂:Ar ratios measured on a membrane inlet mass spectrometer (MIMS). This study compares these two techniques in short-term batch experiments. Rates obtained using the original N₂∶Ar method were up to 3 to 4 times higher than rates obtained using the isotope pairing technique due to O₂ reacting with the N₂ during MIMS analysis. Oxygen combines with N₂ within the mass spectrometer ion source forming NO⁺ which reduces the N₂ concentration. The decrease in N₂ is least at lower O₂ concentrations and since oxygen is typically consumed during incubations of sediment cores, the result is often a pseudo-increase in N₂ concentration being interpreted as denitrification activity. The magnitude of this ocygen effect may be instrument specific. The reaction of O₂ with N₂ and the subsequent decrease in N₂ was only partly correctly using an O₂ correction curve for the relationship between N₂ and O₂ concentrations. The O₂ corrected N₂∶Ar denitrification rates were lower, but still did not match the isotope pairing rates and the variability between replicates was much higher. Using a copper reduction column heated to 600°C to remove all of the O₂ from the sample before MIMS analysis resulted in comparable rates (slightly lower), and comparable variability between replicates, to the isotope pairing technique. The N₂:Ar technique determines the net N₂ production as the difference between N₂ production by denitrification and N₂ consumption by N-fixation, while N-fixation has little effect on the isotope pairing technique which determines a rate very close to the gross N₂ production. When the two different techniques were applied on the same sediment, the small difference in rates obtained by the two methods seemed to reflect N-fixation as also supported from measurements of ethylene production in acetylene enriched sediment cores. The N₂:Ar and isotope pairing techniques may be combined to provide simultaneous measurements of denitrification and N-fixation. Both techniques have several assumptions that must be met to achieve accurate rates; a number of tests are outlined that can be applied to demonstrate that these assumptions are being meet.