不同盐度对文蛤(Meretrix meretrix)呼吸代谢及体内酶活性的影响

为研究不同盐度对文蛤呼吸代谢的影响,本实验设置5个盐度(‰)梯度(11、18、25、32、39),检测不同盐度对文蛤(Meretrixmeretrix)耗氧和排氨的影响,以及文蛤的外套膜、鳃、肝胰腺三种组织中乳酸脱氢酶和Na+/K+-ATP酶活性的变化。结果表明:随着盐度的不断升高,文蛤耗氧率先升后降再升,在盐度18时达到最大值;排氨率先升后降,在盐度32时达到最大值。随着盐度不断升高和胁迫时间延长,文蛤的肝胰腺中乳酸脱氢酶活力总体呈先升高后下降再升高的趋势(P0.05),酶活力在盐度39时为最高;随着盐度不断升高和胁迫时间延长,文蛤的外套膜中Na+/K+-ATP酶活力总体呈先下降再升高后下降的趋势(P0.05),在盐度32时为最高;文蛤的外套膜和鳃中乳酸脱氢酶活力以及鳃和肝胰腺中Na+/K+-ATP酶活力受盐度影响不显著(P0.05),酶活力变化也多呈现"W"形的变化趋势。研究结果为文蛤的人工养殖提供参考。     

Beaver dam analogues drive heterogeneous groundwater–surface water interactions

Beaver dam analogues (BDAs) are a cost-effective stream restoration approach that leverages the recognized environmental benefits of natural beaver dams on channel stability and local hydrology. Although natural beaver dams are known to exert considerable influence on the hydrologic conditions of a stream system by mediating geomorphic processes, nutrient cycling, and groundwater–surface water interactions, the impacts of beaver-derived restoration methods on groundwater–surface water exchange are poorly characterized. To address this deficit, we monitored hyporheic exchange fluxes and streambed porewater biogeochemistry across a sequence of BDAs installed along a central Wyoming stream during the summer of 2019. Streambed fluxes were quantified by heat tracing methods and vertical hydraulic gradients. Biogeochemical activity was evaluated using major ion porewater chemistry and principal component analysis. Vertical fluxes of approximately 1.0 m/day were observed around the BDAs, as was the development of spatially heterogeneous zones of nitrate production, groundwater upwelling, and anaerobic reduction. Strong contrasts in hyporheic zone processes were observed across BDAs of differing sizes. This suggests that structures may function with size-dependent behaviour, only altering groundwater–surface water interactions after a threshold hydraulic step height is exceeded. Patterns of hyporheic exchange and biogeochemical cycling around the studied BDAs resemble those around natural beaver dams, suggesting that BDAs may provide comparable benefits to channel complexity and near-stream function over a 1-year period.     

复杂地形景区三维导览图的设计与实现

为满足复杂地形景区对三维地图导览的需求,构建更为清晰的三维地图模型,提供良好的三维导览地图设计方案显得尤为重要。为了更好地与卫星影像进行贴合,DEM数据的采样密度要与卫星影像的分辨率一致。本文通过对比当下常用的四种空间插值方法的适用范围与运用特点,设置相关阈值及权重,直观比较了四种插值方法产生的插值结果,选择更适合复杂景区DEM插值的插值方法并对其进行精度提升,以此得到符合精度要求的DEM数据。最后利用相应地区的卫星影像进行地图投影及影像贴图,两种数据结合构建复杂景区的三维地图模型,给游客带来更为精确直观的定位信息和空间要素信息。     

连续台风时期香港区域的水汽变化分析

利用香港卫星定位参考站网GNSS观测数据,提取强热带风暴"塔拉斯"与热带风暴"洛克"影响期间各测站天顶方向对流层延迟,反演香港区域大气可降水量;根据香港区域49个天文台气象站提供的实测降雨量数据,分析大气可降水量与实际降雨量的相关性,以及两次台风对香港区域水汽时空分布的不同影响。结果表明,大气可降水量在台风影响前期均上升,在大量降雨后回落,但在连续台风的间歇期间,仍高于台风来临前的水平;水汽累积是大量降雨的前提条件,当水汽累积量相近时,水汽累积时长与累积降雨量呈正相关;台风期间大气可降水量值超过65 mm的区域面积与台风等级相关,台风路径对局部水汽分布有一定的影响。     

长江经济带城市土地利用效率的影响因素及其空间溢出效应研究

在人多地少的基本国情下,提高城市土地利用效率是促进区域可持续发展和建设生态文明的内在要求。本文在对2009-2016年长江经济带108个地级及以上城市土地利用效率的研究基础上,采用空间相关性研究方法分析了时空分布格局,通过构建空间杜宾模型(SDM)对其空间溢出效应进行分析。研究结果表明:1)2009-2016年长江经济带城市土地利用效率整体呈现稳定上升趋势;基本呈现以上海、南京、武汉等不同城市群中心城市向外逐步降低的“中心-外围”的分布格局。2)通过构建空间杜宾模型分析发现,经济发展水平、产业结构有显著为正的直接效应和溢出效应;土地市场化水平有显著为正的溢出效应;城市固定资产投资对城市土地利用效率具有正的直接效应和负的溢出效应;政府财政支出水平则对城市土地利用效率的直接效应和溢出效应均不明显。3)不同影响因素对经济带上中下游城市土地利用效率的空间效应存在一定差异性。     

顾及地类转换差异的城市空间扩展元胞自动机模型及应用研究

元胞自动机模型已经成为城市空间扩展模拟研究的重要方法之一,并得到广泛应用。然而,现有的城市扩展元胞自动机模型仍存在不足。由于元胞状态设置较为简单,从而使模型转换规则中对不同用地类型向城市用地转换的差异与强度考虑不够。基于此本文在元胞自动机模型的框架下,设计了多元结构的元胞状态及转换规则,提出了顾及地类转换差异与强度的城市扩展元胞自动机模型。在计算非城市用地向城市用地转换的转换概率时,该模型考虑了3个方面的概率：① 地形地貌、经济发展等城市发展的驱动因素对城市用地扩展的影响概率,该概率采用logistics方法进行计算;② 邻域元胞的用地类型对中心元胞转换概率的影响,该概率采用扩展摩尔型方法进行计算;③ 不同类型的非城市用地（本研究中包括耕地、林地和裸地3种类型）向城市用地转换的强度,该概率由模拟基期土地利用数据与目标年份土地利用数据的叠加,得出不同类型的非城市用地在此时间段内向城市用地转换的规模,进而确定不同类型的非城市用地向城市用地转换的强度。最后,将以上3种概率的乘积作为元胞转换的概率。通过转换概率与转换阈值的对比判断中心元胞是否在下一个阶段转换为城市用地。经过迭代计算,不断增加城市用地元胞的数量。当模拟城市用地的结果与目标年份的城市用地规模差值在一定的范围内时停止模拟,得出最终结果。模型构建完成后,本文以长株潭城市群核心区为例进行了模拟实验。以2001年该地区的土地利用数据为基期数据,模拟2010年该地区的城市用地规模和空间分布。研究结果表明,根据本文提出的模型模拟的城市扩展结果与真实数据相比具有较高的一致性。模拟结果正确率达到68.66%,比基于传统logistics回归的元胞自动机模型的模拟精度提高了4.25%,Kappa系数为0.675。该模型较好地模拟了长株潭城市群核心区城市扩展,在城市空间扩展模拟中具有较好的适应性与有效性。     

Peaks of People: Using Topographic Prominence as a Method for Determining the Ranked Significance of Population Centers

This article borrows a statistical method from physical geography—topographical prominence—to suggest a new technique for measuring the relative significance or rank of population centers. Unlike raw population measures, prominence gives consideration to both the spatial intensity of concentrated population areas as well as the spatial dependence or independence of neighboring settlement clusters in relation to one another. We explain how to apply the topographic prominence calculation method to gridded population data and examine its practical utility through case studies of several U.S. states. We then discuss some ways in which parametric choices about point-to-surface transformations can result in considerably different outcomes and offer further suggestions for conceptualizing and measuring population center significance.     

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.     

Wetland hydroperiod classification in the western prairies using multitemporal synthetic aperture radar

Wetlands represent one of the world's most biodiverse and threatened ecosystem types and were diminished globally by about two‐thirds in the 20th century. There is continuing decline in wetland quantity and function due to infilling and other human activities. In addition, with climate change, warmer temperatures and changes in precipitation and evapotranspiration are reducing wetland surface and groundwater supplies, further altering wetland hydrology and vegetation. There is a need to automate inventory and monitoring of wetlands, and as a study system, we investigated the Shepard Slough wetlands complex, which includes numerous wetlands in urban, suburban, and agricultural zones in the prairie pothole region of southern Alberta, Canada. Here, wetlands are generally confined to depressions in the undulating terrain, challenging wetlands inventory and monitoring. This study applied threshold and frequency analysis routines for high‐resolution, single‐polarization (HH) RADARSAT‐2, synthetic aperture radar mapping. This enabled a growing season surface water extent hyroperiod‐based wetland classification, which can support water and wetland resource monitoring. This 3‐year study demonstrated synthetic aperture radar‐derived multitemporal open‐water masks provided an effective index of wetland permanence class, with overall accuracies of 89% to 95% compared with optical validation data, and RMSE between 0.2 and 0.7 m between model and field validation data. This allowed for characterizing the distribution and dynamics of 4 marsh wetlands hydroperiod classes, temporary, seasonal, semipermanent, and permanent, and mapping of the sequential vegetation bands that included emergent, obligate wetland, facultative wetland, and upland plant communities. Hydroperiod variation and surface water extent were found to be influenced by short‐term rainfall events in both wet and dry years. Seasonal hydroperiods in wetlands were particularly variable if there was a decrease in the temporary or semipermanent hydroperiod classes. In years with extreme rain events, the temporary wetlands especially increased relative to longer lasting wetlands (84% in 2015 with significant rainfall events, compared with 42% otherwise).