非线性波消波及波场分布研究

本文基于雷诺平均N-S方程,并结合RNG k-e方程建立了粘性数值波浪水槽,对不同波陡、不同相对水深、不同相对波高的非线性规则波的阻尼消波问题和波场分布进行研究。文中提出了两种描述消波区内部阻尼变化的阻尼函数,分别适用于小波陡情形和高波陡情形。研究结果表明,小波陡组消波区可设为一个波长,阻尼系数取10~4～10~5即可满足消波要求,计算结果与实验结果及造波理论吻合良好;高波陡组消波区可设为两个波长,阻尼系数取10~4～10~5亦可满足消波要求,计算结果与实验结果吻合良好。此外,当波陡较小时,波场内反射情况的小幅改变即可对整个波场造成影响,特别是当水深较浅时这种影响极为明显,需谨慎考虑。当波陡较大时,水波能量较高,整个波场沿水波传播方向可观测到明显的衰减现象,在具体试验中需进行考虑。     

Overview of In - Situ Biodegradation and Enhancement

Microbial degradation technologies have been developed to restore ground water quality in aquifers polluted by organic contaminants effectively in recent years. However, in course of the degradation, the formation of biofilms in ground water remediation technology can be detrimental to the effectiveness of a ground water remediation project. Several alternatives are available to a remedial design engineer, such as Permeable Reactive Barriers (PRBs) and in -situ bioremediation, Hydrogen Releasing Compounds (HRCs) barrier, Oxygen Releasing Compounds (ORCs) barrier etc. which are efficient and cost- effective technologies. Excessive biomass formation renders a barrier ineffective in degrading the contaminants, Efforts are made to develop kinetics models which accurately determine bio - fouling and bio - filn formation and to control excessive biomass formation.     

CORROSION RESISTANCE OF INTERFERENCE FILM ON STAINLESS STEEL

IwrRODUcrlONStainlessstalhasbeenusedwidelyasbuildingrnateria1,especiallyasdecoratingrnate-rialinbuildings.Ordinarystainlesssteehasonlyonemonot0noussilverywhitCcolourwhichsomeimesdoesnotrnatchwithitSsurmundingenvironment.lnordert0improveitSdereratingperfonnaneeandexpanditsuse,muchresearchhasbeenconductedsincethe4O'st0trytoformabright,uniform,highcorrosi0nandwearresistantco1ourfilmonastainlesssteesurface.Duringtheeariystage,anirnmersionedhodwasused,i.e.inimrs-ingthestainlesssteelinahots0luti…     

Three dimensional simulation of fluid flow in X‐ray CT images of porous media

A numerical scheme is developed in order to simulate fluid flow in three dimensional (3‐D) microstructures. The governing equations for steady incompressible flow are solved using the semi‐implicit method for pressure‐linked equations (SIMPLE) finite difference scheme within a non‐staggered grid system that represents the 3‐D microstructure. This system allows solving the governing equations using only one computational cell. The numerical scheme is verified through simulating fluid flow in idealized 3‐D microstructures with known closed form solutions for permeability. The numerical factors affecting the solution in terms of convergence and accuracy are also discussed. These factors include the resolution of the analysed microstructure and the truncation criterion. Fluid flow in 2‐D X‐ray computed tomography (CT) images of real porous media microstructure is also simulated using this numerical model. These real microstructures include field cores of asphalt mixes, laboratory linear kneading compactor (LKC) specimens, and laboratory Superpave gyratory compactor (SGC) specimens. The numerical results for the permeability of the real microstructures are compared with the results from closed form solutions. Copyright © 2004 John Wiley & Sons, Ltd.     

Numerical manifold method for dynamic nonlinear analysis of saturated porous media

It is well known that the Babuska–Brezzi stability criterion or the Zienkiewicz–Taylor patch test precludes the use of the finite elements with the same low order of interpolation for displacement and pore pressure in the nearly incompressible and undrained cases, unless some stabilization techniques are introduced for dynamic analysis of saturated porous medium where coupling occurs between the displacement of solid skeleton and pore pressure. The numerical manifold method (NMM), where the interpolation of displacement and pressure can be determined independently in an element for the solution of u–p formulation, is derived based on triangular mesh for the requirement of high accurate calculations from practical applications in the dynamic analysis of saturated porous materials. The matrices of equilibrium equations for the second‐order displacement and the first‐order pressure manifold method are given in detail for program coding. By close comparison with widely used finite element method, the NMM presents good stability for the coupling problems, particularly in the nearly incompressible and undrained cases. Numerical examples are given to illustrate the validity and stability of the manifold element developed. Copyright © 2006 John Wiley & Sons, Ltd.     

About Darcy's law in non-Galilean frame

This paper is aimed towards investigating the filtration law of an incompressible viscous Newtonian fluid through a rigid non-inertial porous medium (e.g. a porous medium placed in a centrifuge basket). The filtration law is obtained by upscaling the flow equations at the pore scale. The upscaling technique is the homogenization method of multiple scale expansions which rigorously gives the macroscopic behaviour and the effective properties without any prerequisite on the form of the macroscopic equations. The derived filtration law is similar to Darcy's law, but the tensor of permeability presents the following remarkable properties: it depends upon the angular velocity of the porous matrix, it verifies Hall–Onsager's relationship and it is a non-symmetric tensor. We thus deduce that, under rotation, an isotropic porous medium leads to a non-isotropic effective permeability. In this paper, we present the results of numerical simulations of the flow through rotating porous media. This allows us to highlight the deviations of the flow due to Coriolis effects at both the microscopic scale (i.e. the pore scale), and the macroscopic scale (i.e. the sample scale). The above results confirm that for an isotropic medium, phenomenological laws already proposed in the literature fails at reproducing three-dimensional Coriolis effects in all types of pores geometry. We show that Coriolis effects may lead to significant variations of the permeability measured during centrifuge tests when the inverse Ekman number Ek⁻¹ is 𝒪(1). These variations are estimated to be less than 5% if Ek⁻¹<0.2, which is the case of classical geotechnical centrifuge tests. We finally conclude by showing that available experimental data from tests carried out in centrifuges are not sufficient to determining the effective tensor of permeability of rotating porous media. Copyright © 2004 John Wiley & Sons, Ltd.     

Origin of Fe-Ti Oxide Ores in Mafic Intrusions: Evidence from the Panzhihua Intrusion, SW China

Economic concentrations of Fe–Ti oxides occur as massive,conformable lenses or layers in the lower part of the Panzhihuaintrusion, Emeishan Large Igneous Province, SW China. Mineralchemistry, textures and QUILF equilibria indicate that oxidesin rocks of the intrusion were subjected to extensive subsolidusre-equilibration and exsolution. The primary oxide, reconstructedfrom compositions of titanomagnetite in the ores and associatedintergrowths, is an aluminous titanomagnetite (Usp₄₀) with 40wt % FeO, 34 wt % Fe₂O₃, 16·5 wt % TiO₂, 5·3 wt% Al₂O₃, 3·5 wt % MgO and 0·5 wt % MnO. This compositionis similar to the bulk composition of the oxide ore, as inferredfrom whole-rock data. This similarity strongly suggests thatthe ores formed from accumulation of titanomagnetite crystals,not from immiscible oxide melt as proposed in earlier studies.The occurrence of oxide ores in the lower parts of the Panzhihuaintrusion is best explained by settling and sorting of densetitanomagnetite in the ferrogabbroic parental magma. This magmamust have crystallized Fe–Ti oxides relatively early andabundantly, and is likely to have been enriched in Fe and Tibut poor in SiO₂. These features are consistent with fractionationof mantle-derived melts under relatively high pressures (10kbar), followed by emplacement of the residual magma at 5 kbar.This study provides definitive field and geochemical evidencethat Fe–Ti oxide ores can form by accumulation in ferrogabbro.We suggest that many other massive Fe–Ti oxide depositsmay have formed in a similar fashion and that high concentrationsof phosphorus or carbon, or periodic fluctuation of fO₂ in themagma, are of secondary importance in ore formation. KEY WORDS: ELIP; Fe–Ti oxide ore; layered intrusion; Panzhihua; QUILF     

洛川黄土-红粘土序列铁氧化物组成及其古气候指示

对洛川黄土、古土壤和红粘土中磁性矿物组成、成因和相关系进行了研究。结果表明:黄土磁性矿物以风尘磁铁矿为主,少量的成土赤铁矿和成土磁赤铁矿;古土壤磁性矿物以成土磁赤铁矿为主,成土赤铁矿次之,少量的风尘磁铁矿和赤铁矿;红粘土磁性矿物以成土赤铁矿为主,风尘磁铁矿和成土磁赤铁矿次之,少量风尘赤铁矿。黄土、古土壤和红粘土磁性矿物组成差异,反映了其形成期不同的古气候特性以及不同气候条件下生物地球化学作用强度的差异。干冷的冰期,黄土弱成土作用形成了以粗颗粒的风尘磁铁矿核 赤铁矿边的磁化率载体。间冰期的温暖湿润的古气候最有利于生物活动,强烈生物活动导致古土壤中大量纳米超细磁赤铁矿/磁铁矿产生,形成以磁赤铁矿为主,风尘磁铁矿核 赤铁矿边为辅的磁化率载体。红粘土成壤期,强降雨强蒸发的长干短湿的高温炎热的古气候使得红粘土化学风化强烈,生物地球化学活动较弱,形成以磁铁矿核 赤铁矿边和磁赤铁矿核 赤铁矿边的磁化率载体。黄土、古土壤和红粘土磁性矿物组成、磁性矿物相关系是其形成期独特的古气候指示。     

声波在水-多孔介质海底界面上的反射与透射

声波在海底界面的反射和透射是海底散射、海底混响、海底目标探测的重要问题。利用Biot多孔介质声传播理论对声波在水-多孔海底界面上的反射和透射进行了分析,具体给出反射声波的反射系数,3种透射声波的透射系数以及声能透射系数随入射波入射角和频率(10~40 kHz)的变化关系,分析了各种透射波对透射声能的贡献。多孔海底介质参数分别采用Stoll和Chotiros给出的2组参数进行理论计算。     

中国明对虾(Fenneropenaeus chinensis)血细胞中一氧化氮合成酶的鉴定及其在白斑综合症病毒感染过程中的变化

诱导型一氧化氮合成酶(iNOS)在生物机体免疫，特别在无脊椎动物免疫中的作用近来得到了广泛的关注，由其催化产生的一氧化氯(NO)除具有已知的神经传导、松弛平滑肌等功能外，还具有抗菌、抗病毒、抗寄生虫等作用。作者通过硝基四氯唑蓝(NBT)法和血细胞形态观察等方法，对中国明对虾(Fenneropenaeus chinensis)血细胞中存在的诱导型一氧化氮合成酶进行了初步鉴定。在此基础上，通过亚硝酸盐法和L-瓜氨酸法对比，研究了感染白斑综合症病毒(WSSV)后中国明对虾血细胞中一氧化氯合成酶的变化情况。结果显示，中国明对虾在感染WSSV后，iNOS活性在12h内有上升趋势，实验36h后酶活性显著下降，至60h后酶活性降至对照组的一半左右。同时，被脂多糖(LPS)诱导的一氧化氮合成酶活性与对照相比也有显著下降。与此对应的是，核酸探针斑点杂交法检测病毒的结果显示：实验36h后在对虾体内能够检测到白斑综合症病毒。对照组中国明对虾血细胞的iNOS在实验过程中基本保持稳定。这说明WSSV在感染中国明对虾初期可以诱导血细胞产生iNOS，但随着WSSV在中国明对虾体内的大量增殖及其对血细胞的破坏，使得iNOS活性显著降低，对虾也趋于死亡。因此，iNOS能够作为反映对虾在病毒感染过程中健康状况的有效指标。