两株南极枝孢霉属真菌Cladosporium sp.NJF4和NJF6的次级代谢产物研究

南极因其独特的自然环境成为潜在、重要的微生物资源库,是产生新型生物活性物质和先导化合物菌株的潜在种源地,南极微生物正在成为创新药物研究新的重要资源。虽然近年来对南极微生物次级代谢产物的研究逐渐增加,但与温带和热带微生物研究相比仍处于初级阶段。对从南极普里兹湾海洋沉积物中获得的两株枝孢霉属真菌Cladosporium sp. NJF4和NJF6进行次级代谢产物分离及结构鉴定,获得20个化合物。化合物结构类型包括甾醇(1)、倍半萜类(7—8)、生物碱类(9—14)、二酮哌嗪(2—5、15—17)、芳香酸(6、18—19)等,其中倍半萜类(7—8)为首次从枝孢霉属真菌中分离得到,以上研究将为丰富南极微生物次级代谢产物库奠定一定的研究基础。     

Late Holocene relative sea level rise and the Neoglacial history of the Greenland ice sheet

In West Greenland, early and mid Holocene relative sea level (RSL) fall was replaced by late Holocene RSL rise during the Neoglacial, after 4–3 cal. ka BP (thousand calibrated years before present). Here we present the results of an isolation basin RSL study completed near to the coastal town of Sisimiut, in central West Greenland. RSL fell from 14 m above sea level at 5.7 cal. ka BP to reach a lowstand of ?4.0 m at 2.3–1.2 cal. ka BP, before rising by an equivalent amount to present. Differences in the timing and magnitude of the RSL lowstand between this and other sites in West and South Greenland record the varied interplay of local and non‐Greenland RSL processes, notably the reloading of the Earth's crust caused by a Neoglacial expansion of the Greenland Ice Sheet (GIS) and the subsidence associated with the collapse of the Laurentide Ice Sheet forebulge. This means that the timing of the sea level lowstand cannot be used to infer directly when the GIS advanced during the Neoglacial. The rise in Late Holocene RSL is contrary to recently reported bedrock uplift in the Sisimiut area, based on repeat GPS surveys. This indicates that a belt of peripheral subsidence around the current ice sheet margin was more extensive in the late Holocene, and that there has been a switch from subsidence to uplift at some point in the last thousand years or so. Copyright © 2008 John Wiley & Sons, Ltd.     

长牡蛎碱性磷酸酶的分离纯化及部分性质研究

本文以长牡蛎为酶源提取材料,用正丁醇抽提,硫酸铵分级分离,DEAE-52和Sephadex G-100柱层析,得到一定纯度的碱性磷酸酶,提纯倍数为61.96,比活力达1.326U/mg.该酶的最适pH值9.6,最适温度38℃,初速度6.8μmol/(dm~3·min),米氏常数Km值为1.30mmol/dm~3.实验结果表明,Mg~(2+)对该酶有明显的激活作用;Zn~(2+)、Cu~(2+)、Hg~(2+)对该酶有明显的抑制作用.     

高压技术在深海沉积物兼性嗜压菌的筛选和鉴定中的应用

通过自行改进的高压培养罐及高压设备,对深海沉积物进行可培养微生物的筛选,获得6株具有较强耐受压力的细菌.16SrDNA的测序结果表明这些细菌分别属于6个不同的菌属.压力生长试验的结果表明这6株细菌在40MPa的条件下仍然具有较强的生长能力,属于兼性嗜压菌.对不同压力下生长的细菌做显微镜检,结果显示,除了一株芽孢杆菌在40MPa下的菌体形态发生了明显的变化外,其它5株细菌在压力条件下的菌体的分裂均没有受到明显的影响.     

组织培养板在获取微藻种质中的应用

报道一种基于选择演替和及时显微跟踪的原理获取一次野外水样中多种微藻的方法。利用组织培养板方便的显微观测条件和适宜容积提供微藻存活的空间,在不同培养条件下,进行微藻群落演替、及时显微跟踪检测和优势种分离,可以使野外水样初期低生物量种类优势化,以利于纯系种质的获得。并通过不同演替条件获得其中出现的未鉴定或初期样品中未检出的种质,提供进一步研究的基础。该方法在获取微藻种质和种质库建设上不失为一可行技术手段。论文以一次野外采集海水样品在不同营养条件下的主要优势种类演替跟踪检测、低生物量种质优势化过程和纯系种质分离为例,说明该方法在获取微藻种质中的应用。     

A mathematical hysteretic model for elastomeric isolation bearings

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.     

Selective controlled base isolation system with magnetorheological dampers

A base isolation system composed of low‐damping isolation bearings and magnetorheological (MR) fluid dampers is described. The MR fluid changes its properties under the influence of a magnetic field resulting in a damper with characteristics that may be modified in real time. This feature enables optimal control under changing excitations in a stable and cost‐effective manner. The voltage is applied according to a selective control strategy. According to the proposed approach the dampers are activated only within a given range of the base displacements. The selective control improves the efficiency of the system and significantly reduces the control forces required for an optimal structural behaviour. Models of five‐ and eight‐storey buildings are used to study the efficiency of the proposed system. Copyright © 2002 John Wiley & Sons, Ltd.     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

Approximate analysis methods for asymmetric plan base‐isolated buildings

An approximate method for linear analysis of asymmetric‐plan, multistorey buildings is specialized for a single‐storey, base‐isolated structure. To find the mode shapes of the torsionally coupled system, the Rayleigh–Ritz procedure is applied using the torsionally uncoupled modes as Ritz vectors. This approach reduces to analysis of two single‐storey systems, each with vibration properties and eccentricities (labelled ‘effective eccentricities’) similar to corresponding properties of the isolation system or the fixed‐base structure. With certain assumptions, the vibration properties of the coupled system can be expressed explicitly in terms of these single‐storey system properties. Three different methods are developed: the first is a direct application of the Rayleigh–Ritz procedure; the second and third use simplifications for the effective eccentricities, assuming a relatively stiff superstructure. The accuracy of these proposed methods and the rigid structure method in determining responses are assessed for a range of system parameters including eccentricity and structure flexibility. For a subset of systems with equal isolation and structural eccentricities, two of the methods are exact and the third is sufficiently accurate; all three are preferred to the rigid structure method. For systems with zero isolation eccentricity, however, all approximate methods considered are inconsistent and should be applied with caution, only to systems with small structural eccentricities or stiff structures. Copyright © 2001 John Wiley & Sons, Ltd.