脐带缆螺旋滑移分析及力学性能研究

针对脐带缆内部螺旋层,应用Darboux标架建立螺旋结构空间坐标系,推导弯曲载荷下螺旋结构的局部变形和滑移。考虑螺旋构件间的接触和摩擦作用,建立螺旋结构的受力平衡偏微分方程,并研究螺旋角和摩擦系数对螺旋结构滑移的影响。基于同层螺旋结构本构关系相同假设,将所有螺旋结构力学性能线性叠加,拟合脐带缆整体弯曲刚度。运用建立的理论解析方法,对某双层铠装脐带缆的力学性能进行研究,并与数值模拟结果进行对比验证。对比结果表明,理论解析得到的螺旋滑移结果与数值模拟结果一致,理论解析得到的脐带缆弯曲刚度与数值模拟结果在全滑动阶段比较接近。     

Evolutionary Processes in Low-Mass Binary Systems

We consider the evolution of certain low-mass binaries, incorporating models of (a) internal evolution, (b) tidal friction, (c) dynamo activity driven by an elementary α,Ω dynamo, (d) stellar wind driven by the activity, and (e) magnetic braking as a consequence of wind and poloidal dynamo-generated magnetic field. In some circumstances the stellar wind is found to remove mass on a nuclear timescale, as is necessary to explain some observed systems. We can hope that various uncertainties in the model may be clarified by a careful comparison of the models with such observed quantities as rotation periods. These are modified by processes (a), (b) and (e). Assuming that stellar evolution is slow, rotation rate should in some circumstances represent a balance between magnetic braking trying to slow the star down and tidal friction trying to spin it up. Preliminary attempts are promising, but indicate that some fine tuning is necessary. When there is a third body present, in an orbit which is inclined but not necessarily of short period, the eccentricity of a close binary can be strongly modified by ‘Kozai cycles’. We show that this may complicate attempts to account for spin rates of stars in close binaries.     

西安地区单桩桩土相互作用数值模拟分析

随着计算机技术和数值方法的不断发展和完善,使有限元法得到越来越多的应用。根据西安地区原型摩擦桩的地层特点和土性条件,运用有限元基础理论,利用相应的边界条件与假设条件,建立单桩数学模型。通过模型研究了单桩的沉降特性与土共同作用的影响因素,对西安地区单桩桩土相互作用机理进行了探讨。     

Electromagnetic signals associated with stick–slip of quartz-free rocks

We recorded clear transients in the electric and magnetic fields upon sudden slip in stick–slip experiments on dry, cylindrically shaped, quartz-free rock specimens of basalt and peridotite with a 30° saw-cut (representing a fault) at confining pressures of up to 120 MPa. The amplitudes of the measured electric field signals were always higher at the electrode pair oriented parallel to the strike of the fault than at the pair oriented perpendicular. This anisotropy suggests a preferred electric polarization normal to the slip surface. The transients in the electric and magnetic fields were observed only when the fault slip occurred by stick–slip mode, not by a stable mode of the sliding, and the amplitudes of the electric field signals increased with increasing stress drop. It is suggested that the generation process of the electromagnetic signals is closely related to the characteristic behavior of the fault at the time of the initiation of slip during stick–slip events, probably with respect to the intensity of the signals. We propose that one or both of the following two processes characteristic of the fault at the time of the initiation of slip during stick–slip events are essential for the generation of detectable electromagnetic signals: rapid slip along the simulated fault and separation of the rock masses across the fault.     

Biaxial test simulations using a packing of polygonal particles

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.     

渤海湾盆地新生界生油岩系底界面温度分布

依据渤海湾盆地2000余口测温井的地温梯度数据、地层岩性描述、分层数据以及钻井资料,计算了该盆地各生油岩系底界面的温度。统计结果表明:渤海湾盆地沙河街组大部分凹陷区地层底界面温度介于90℃至150℃,目前仍具有大量生油的温度条件,而在隆起或一些凸起地区,该地层组段温度普遍小于90℃,未能达到生油的温度指标。东营组和孔店组地层也仍具有一定的生油温度条件。研究还表明:地层温度与地层界面埋深密切相关,温度随界面埋深的增大而升高,沉积厚度大的凹陷区地层界面温度大于沉积厚度小的凸起区或斜坡地带,说明地层界面埋深是决定地温高低的主要控制因素,而地温梯度对地层界面温度的影响相对较小。     

高桩码头桩基负摩擦力现场试验研究 ——上海洋山深水港工程现场试验

高桩码头接岸结构中的桩基础,在抛石的作用下将产生负摩擦力。通过支撑桩及自由桩上负摩擦力的现场试验研究,获得抛石过程中基桩内力随深度变化的基本规律。抛石过程中基桩上的负摩擦力主要产生在抛石段。同时,抛石作为附加荷载,将引起下方软弱土层的固结沉降,桩土之间产生相对位移,从而在抛石段下方一定范围内也产生负摩擦力作用。承台荷载对负摩擦力的大小和分布有着重要的影响。提出的负摩擦力分布规律和采用有效应力法计算层状土负摩擦力的公式,可为桩基础的设计,尤其对水下单面抛石施工的设计及采取消减负摩擦力的措施提供依据。     

Influence of Current Width Variation on the Annual Mean Transport of the East Sakhalin Current: A Simple Model

Recent observations suggest that the annual mean southward transport of the East Sakhalin Current (ESC) is significantly larger than the annual mean Sverdrup transport. Motivated by this observational result, transport of a western boundary current has been investigated using a simple numerical model with a western slope. This transport is defined as the instantaneous barotropic transport integrated from the western boundary to the offshore point where the barotropic velocity vanishes. The model, forced by seasonally varying wind stress, exhibits an annual mean of the western boundary current transport that is larger than that of the Sverdrup transport, as observed. The southward transport from October to March in the model nearly equals the instantaneous Sverdrup transport, while the southward transport from April to September decreases slowly. Although the Sverdrup transport in July vanishes, the southward transport in summer nearly maintains the annual mean Sverdrup transport, because the barotropic Rossby wave cannot intrude on the western slope. This summer transport causes the larger annual mean. Although there are some uncertainties in the estimation of the Sverdrup transport in the Sea of Okhotsk, the seasonal variation of the southward transport in the model is qualitatively similar to the observations.     

Model Test of Sand Restraining Force on Pipeline

This paper describes the model tests for determining the axial friction and the lateral resistance of sand to pipeline by using fine sand and prototype pipeline, and the calculation method based on limit analysis theory is verified. The effect of cyclic loading is considered in the test.