圆形数值波浪水池斜向和多向入射波浪模拟研究

为了研究斜向入射波浪,基于三维不可压缩两相流模型,开发了一套圆形数值波浪水池数值模型。在圆形波浪水池中,通过源项造波法成功生成了任意入射方向的波浪,并且利用人工摩擦项模拟阻尼区以数值耗散反射波浪。模型基于嵌入式多块网格体系,采用FVM法(finite volume method)离散Navier-Stokes方程,VOF法(volume of fluid)追踪自由水面。试验结果表明,斜向入射波浪的模拟结果与理论值基本一致,圆形波浪水池在模拟斜向入射波浪时,有效区域的面积较传统波浪水池显著增大,而且有效区域受波浪入射角度的影响也较小。同时,通过叠加多列斜向入射波浪,模拟出了多向交叉波列,并通过与理论结果对比,发现其具有较高的精度。     

长江中下游金属矿找矿前景与找矿方法

本文论述了长江中下游地区金属矿床的地质、地球物理和地球化学特点,提出今后深部找矿的主要对象是：找隐伏含矿岩体及有关的各类矿体,找岩体中的大型斑岩型矿床,找受岩体和五通砂岩联合控制的层状矿;讨论了地球物理和地球化学方法应用中要注意解决的几个主要问题,强调应发挥包括重力、磁法、激发极化法、电磁法、岩性探测仪及多种天然地震法和化探方法等综合方法的作用,并与地质矿床成矿规律研究密切结合;讨论了方法应用试验中要注意的几个问题。文章最后一部分是从本区大地构造的演化探讨了区域构造岩浆活动与成矿前景,认为这一地区是扬子板块与华北板块陆-陆碰撞挤压造山带及其前陆区,在岩石圈强烈挤压下形成地壳增厚和深部物质的挤出折返,使深部的高压和超高压变质岩层推到地壳浅部;深部生成的柯石英等高压超高压矿物及地幔熔融岩浆同时上侵;生成大量钙碱性岩浆并存储在中地壳部位,通过长期与中下地壳金属物质进行交换,形成矿液的集中优势,通过后期出现的张性断裂构造而进入地壳表层,再经过与围岩发生物理化学成矿作用后沉淀成矿。归纳出扬子板块与华北板块陆-陆碰撞造山带一种新的构造模式。     

斜向波对直立式防波堤堤头作用的试验研究

直立式防波堤堤头在斜向波浪作用下波浪力的计算在现行的技术规范中尚属空白。通过物理模型试验给出了堤头结构设计所需的波压分布图，指出了波浪入射方向和地形对堤头所受波浪力的贡献有时可以超过波高和波周期，根据现行规范按波浪正向入射计算堤头所受的波浪力偏于安全。     

南沙海域万安盆地地质构造特征

利用在南沙海域万安盆地所采集的地震、重磁资料及钻井、地质资料，对该盆地的地震反向特征，沉积特征、区域地质、构造特征及构造发展史进行了的简要的论述，本文以该区Ｔｇ深度资料为基础，并利用ＣＣＯＰ年刊发表的新生代基底深度资料，初步圈定了万安盆地的边界，并对盆地二级构造单元进行了划分，将盆地划分为５坳３隆、坳隆相间的构造格局。     

Fatigue Behavior of Plain Concrete Under Biaxial Compression: Experiments and Theoretical Model

The effects of different lateral confinement stress on the fatigue behavior of and cumulative damage to plain concrete are investigated experimentally. Eighty 100 mm x 100 mm x 100 mm specimens of ordinary strength concrete are tested under constant- or variable-amplitude fatigue loading and lateral confinement pressure in two orthogonal directions. A fatigue equation is developed by modifying the classical Aas-Jakobsen S-N equation for taking into account the effect of the confined stress on fatigue strength of plain concrete. The results of variable-amplitude fatigue tests indicate that the linear damage theory proposed by Palmgren and Miner is unreasonable in the biaxial stress state. A nonlinear cumulative damage model that could model the effects of the magnitude and sequence of variable-amplitude fatigue loading and lateral confinement pressure is proposed on the basis of the evolution laws of the residual strains in the longitudinal direction during fatigue tests. The residual fatigue life predic     

Three-dimensional numerical simulation of oblique wave action on vertical walls

1 Introduction A vertical wall is one of the typical maritime sheltering structures in the coastal region, which is mainly subjected to wave forces. It has been a com- mon engineering assumption adopted for design pur- poses that normally incident wave fo…     

关于修改港工钢筋混凝土规范小偏心受压构件正截面强度计算的建议

本文提出在小偏心受压构件正截面强度计算中，取消弯曲抗压强度ｆｃｍ（Ｒｗ），采用轴心抗压强度ｆｃ，这与构件的实际破坏形态相符。对小偏心受压构件正截面强度计算提出了设计建议。特别是对工程上大量应用的矩形截面对称配筋小偏压构件提示了简捷的设计方法，与以往的近似计算方法相比具有物理概念明确，精度高，方法简捷的特点。     

Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

Three-dimensional numerical simulation of obfique wave action on vertical walls

A three-dimensional numerical model based on the potential theory was developed to study the oblique wave action on vertical walls. A source term inside the domain was used to generate incident waves and outgoing waves were dissipated by sponge layers and transmitted by radiation boundaries. The finite difference method was used to solve the governing equations and boundary conditions in the regular transformed domain in σ-coordinate. Satisfactory agreements between the numerical predictions and experimental results of wave force were obtained. It is concluded that the maximum wave force acting on the vertical walls is induced by the obliquely incident waves rather than the normally incident waves.