Numerical modeling for analyzing thermal surface anomalies induced by underground coal fires

Coal seams burning underneath the surface are recognized all over the world and have drawn increasing public attention in the past years. Frequently, such fires are analyzed by detecting anomalies like increased exhaust gas concentrations and soil temperatures at the surface. A proper analysis presumes the understanding of involved processes, which determine the spatial distribution and dynamic behavior of the anomalies.In this paper, we explain the relevance of mechanical and energy transport processes with respect to the occurrence of temperature anomalies at the surface. Two approaches are presented, aiming to obtain insight into the underground coal fire situation: In-situ temperature mapping and numerical simulation. In 2000 to 2005, annual temperature mapping in the Wuda (Inner Mongolia, PR China) coal fire area showed that most thermal anomalies on the surface are closely related to fractures, where hot exhaust gases from the coal fire are released. Those fractures develop due to rock mechanical failure after volume reduction in the seams. The measured signals at the surface are therefore strongly affected by mechanical processes.More insight into causes and effects of involved energy transport processes is obtained by numerical simulation of the dynamic behavior of coal fires. Simulations show the inter-relation between release and transport of thermal energy in and around underground coal fires. Our simulation results show a time delay between the coal fire propagation and the observed appearance of the surface temperature signal. Additionally, the overall energy flux away from the burning coal seam into the surrounding bedrock is about 30-times higher than the flux through the surface. This is of particular importance for an estimation of the energy released based on surface temperature measurements. Finally, the simulation results also prove that a fire propagation rate estimated from the interpretation of surface anomalies can differ from the actual rate in the seam.     

Supercritical gas sorption on moist coals

The effect of moisture on the CO₂ and CH₄ sorption capacity of three bituminous coals from Australia and China was investigated at 55 °C and at pressures up to 20 MPa. A gravimetric apparatus was used to measure the gas adsorption isotherms of coal with moisture contents ranging from 0 to about 8%. A modified Dubinin–Radushkevich (DR) adsorption model was found to fit the experimental data under all conditions. Moisture adsorption isotherms of these coals were measured at 21 °C. The Guggenheim–Anderson–de Boer (GAB) model was capable of accurately representing the moisture isotherms over the full range of relative pressures.Moist coal had a significantly lower maximum sorption capacity for both CO₂ and CH₄ than dry coal. However, the extent to which the capacity was reduced was dependent upon the rank of the coal. Higher rank coals were less affected by the presence of moisture than low rank coals. All coals exhibited a certain moisture content beyond which further moisture did not affect the sorption capacity. This limiting moisture content was dependent on the rank of the coal and the sorbate gas and, for these coals, corresponded approximately to the equilibrium moisture content that would be attained by exposing the coal to about 40–80% relative humidity. The experimental results indicate that the loss of sorption capacity by the coal in the presence of water can be simply explained by volumetric displacement of the CO₂ and CH₄ by the water. Below the limiting moisture content, the CO₂ sorption capacity reduced by about 7.3 kg t^− 1 for each 1% increase in moisture. For CH₄, sorption capacity was reduced by about 1.8 kg t^− 1 for each 1% increase in moisture.The heat of sorption calculated from the DR model decreased slightly on addition of moisture. One explanation is that water is preferentially attracted to high energy adsorption sites (that have high energy by virtue of their electrostatic nature), expelling CO₂ and CH₄ molecules.     

Composition and quality of coals in the Huaibei Coalfield, Anhui, China

The Huaibei Coalfield, Anhui Province, China, is one of the largest coalfields in China. The coals of Permian age are used mainly for power generation. Coal compositions and 47 trace elements of the No. 10 Coal of the Shanxi Formation, the No. 7, 5, and 4 Coals of the Lower Shihezi Formation, and the No. 3 Coal of the Upper Shihezi Formation from the Huaibei Coalfield were studied. The results indicate that the Huaibei coals have low ash, moisture, and sulfur contents, but high volatile matter and calorific value. The ash yield increases stratigraphically upwards, but the volatile matter and total sulfur contents show a slight decrease from the lower to upper seams. Magmatic intrusion into the No. 5 Coal resulted in high ash, volatile matter, and calorific value, but low moisture value in the coal. Among the studied 47 trace elements, Ba, Co, Cr, Cu, Hg, Mo, Ni, Pb, Sb, Th, U, V, and Zn are of environmental concerns. Four elements Hg, Mo, Zn, and Sb are clearly enriched in the coals as compared with the upper continental crust.     

辽东湾凝析气田超压成因及侧向传递机制初探

位于辽东湾西部低凸起北端的JZ20-2超压凝析气田,离供烃中心较远,压力系数却达到1.56~1.7,这在我国东部裂谷盆地比较少见。经过综合分析,作者认为JZ20-2凝析气田异常高压的形成与其所处的特殊地质背景紧密相关,辽中凹陷沙河街组三段超压凝析油气沿不整合面、砂体输导通道向辽东湾西部低凸起的运移、充注和能量的侧向传递是JZ20-2凝析气田异常高压形成的根本原因,而上覆东营组二段下亚段-东营组三段巨厚的强超压泥岩封盖和辽西3号边界断层侧向遮挡共同构成的优越封闭环境是超压保存的必要条件。本文分析了该气田超压特征及其远距离超压侧向传递的成因机制,不仅有助于揭示辽东湾西部低凸起超压流体运移聚集的规律和成藏作用,而且可能提供了一个超压远距离侧向传递的典型实例。     

Monitoring Large-Scale Tests for Nuclear Waste Disposal

Two large-scale “in situ” demonstration experiments and their instrumentation are described. The first test (FEBEX Experiment) involves the hydration of a compacted bentonite barrier under the combined effect of an inner source of heat and an outer water flow from the confining saturated granite rock. In the second case, the progressive de-saturation of Opalinus clay induced by maintained ventilation of an unlined tunnel is analyzed. The paper shows the performance of different sensors (capacitive cells, psychrometers, TDR’s) and a comparison of fill behaviour with modelling results. The long term performance of some instruments could also be evaluated specially in the case of FEBEX test. Capacitive sensors provide relative humidity data during long transient periods characterised by very large variations of suction within the bentonite.     

Field Measurement of Suction, Water Content, and Water Permeability

This paper presents a review of techniques for field measurement of suction, water content, and water hydraulic conductivity (permeability). Main problems in the use of field tensiometers are addressed and hints on how to improve tensiometer performance are given. Advantages and limitations of instruments for indirect measurement of suction including electrical conductivity sensors, thermal conductivity sensors, dielectric permittivity sensors, filter paper, and psychrometer are discussed. Techniques for water content measurement based on dielectric methods are then presented. These include time and amplitude domain reflectometry and capacitance. Finally, a brief overview of methods for measurement of water permeability in the field is presented.     

The characteristics and sources of natural gases from Ordovician weathered crust reservoirs in the Central Gas Field in the Ordos Basin

The Central Gas Field is a famous large-sized gas field in the Ordos Basin of China. However, identification of main gas sources of the Ordovician reservoirs in this gas field remains puzzling. On the basis of a lot of geochemical data and geological research on natural gases, the characteristics and sources of natural gases from Ordovician weathered crust reservoirs in the Central Gas Field in the Ordos Basin were studied. The results indicated that natural gases from Ordovician weathered crust reservoirs in the Central Gas Field in the Ordos Basin have similar chemical and isotopic compositions to highly mature and over-mature dry gases. Both coal-derived gases and oil-type gases coexist in the Central Gas Field in the Ordos Basin. The former was derived mainly from Carboniferous-Permian coal measures and the latter from Lower Paleozoic marine carbonates. It is suggested that coal-derived gases occur in the eastern part of the Central Gas Field while oil-type gases may be produced mainly in the northern, western and southern parts of the Central Gas Field in the Ordos Basin.     

地下矿产开采对天然气管道工程的安全影响评价

西气东输天然气管道工程途经兖州市,穿越杨庄、杨村、兴隆庄等煤矿矿区,压覆煤层埋深变化较大。该文采用预测法对各煤矿在不同开采条件下分煤层对管道运营安全的危害程度进行了评价分析。通过计算表明,煤矿开采埋深越浅,煤层越厚,对管道危害越严重。兴隆庄煤矿3煤层、杨村煤矿煤16t、煤17开采对管道影响强烈,杨庄煤矿煤16t、煤17开采对管道影响中等,兴隆庄煤矿煤16t、煤17开采对管道运营影响小。     

渤海湾盆地埕岛油田缝洞型潜山油气藏构造及储层特征

埕岛油田古潜山油气藏为典型的缝洞型碳酸盐岩油气藏。埕岛地区经历了多期次的构造运动,并经受了多期次的断裂与剥蚀作用,为油气成藏创造了良好条件。埕岛油田古潜山可以划分为三个构造单元,即埕北20断层下降盘的西排山,上升盘的中排山和东排山,三个潜山带成帚状敛于凸起最南端,为几个二级构造单元交汇处,构造应力较发育。埕岛油田有三种储集空间类型:晶间孔隙、溶蚀孔洞和裂缝。     

鄂尔多斯盆地靖边气田马五_(1+2)气藏储集单元研究

综合地震、地质、测井等信息,考虑沉积、成岩、地貌、生产动态等多因素,在沟槽识别和致密带研究基础上,通过井间干扰、油层压力变化和试井边界响应分析,按照局部、就近原则对靖边气田马五1+2气藏进行了储集单元划分。共划分出111个储集单元,其中独立型69个,复合型42个。这些储集单元的面积多介于10～50km2之间,单个储集单元的井数一般少于6口。在对气藏储层特征综合认识的基础上,确定流动单元划分思路与流程,并认为关键环节包括古沟槽识别、致密带研究、动静结合确定储集单元等3个方面。储集单元一方面受控于被致密岩相包围的有利成岩相带,宏观上与弱—中等充填泥粉晶白云岩相对应性好;另一方面又受各级古沟槽夹持,在两个一级古沟槽之间往往共生多个储集单元,而这些储集单元边界又严格地受二级或三级沟槽切割控制。