2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。     

A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.     

高精度直升机机载LiDAR在高速公路改扩建勘测中的应用可行性研究

机载LiDAR在公路勘测方面的用途日益广泛。该文对直升机机载LiDAR在高速公路改扩建中的应用技术路线可行性进行了研究论证,从地面控制测量、点云数据获取、点云数据处理、成果应用等多个方面进行了阐述,通过分析LiDAR点云数据在5种不同地面控制点布设方案校正下的点云数据精度,论证了利用地面控制点对直升机机载LiDAR点云数据进行平面和高程校正的可行性。     

不同排列方式和间隙比下双圆柱流致振动特性研究

采用基于ALE的流固耦合分析方法,将圆柱体振动模型简化为平面双自由度质量-弹簧-阻尼系统,进行了计算参数无关性分析。对不同θ角和间隙比T下的双圆柱流致振动进行数值模拟,并与单圆柱振动计算结果进行比较,得到了不同θ角和间隙比T下中心圆柱的升阻力系数、流场分布和运动轨迹变化情况。通过分析发现小间隙比下由于两圆柱间的相互干扰,改变了中心圆柱的尾涡结构,导致了升力和阻力系数随不同θ角而发生变化;小间隙比下由于两圆柱间的相互干扰影响,均使中心圆柱的轨迹在不同θ角下发生了较大的变化,顺流向的振动频率与单圆柱振动时相比出现了多倍频,导致其运动轨迹发生了变化。     

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。     

Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.     

对青藏东北缘现今块体划分、运动及变形的初步研究

利用2维非连续变形分析方法（DDA），以位移代替围压作为边界约束力，研究青藏东北缘现今块体划分及其运动变形。根据该地区地质构造及地震活动，以GPS点测量位移作为模拟结果约束点，得出了较合理的块体划分模型和随时间演化的主应变分布图，并把应变高值区与近几年来发生的5级以上地震作对比，得出了研究区内地震危险性可能较大的区域。另外，对模拟的甘青块体与阿拉善块体的边缘带断裂左旋运动做了大概计算。     

平凉隐伏岩溶水环境同位素研究

地下水资源可持续利用的一个急待解决的重要问题,是对地下水补给和更新能力的评价.利用环境同位素技术研究地下水的补给和可更新性是当前较为新颖的方法之一.在西北干旱、半干旱的隐伏岩溶地区,地下水埋藏条件复杂,常规的地质勘探方法所能提供的水文地质信息有限,环境同位素方法在研究地下水的补给及可更新能力方面发挥了优势,可对传统方法进行补充和验证.其结果表明,研究区隐伏岩溶水形成较早,且有大量现代水的混入,平均混入量为54%.说明区内隐伏岩溶水的补给和更新能力较好.环境同位素分析结果还显示,大岔河隐伏岩溶水为一相对独立、半开放的水文地质单元,其补给来源部分为流域内大气降水、地表水的补给,部分为东南部三道沟岩溶地下水的补给;根据环境同位素EPM模型计算,地下水的滞留时间为36 a.地下水储存量为1.314×108 m3; 储水系数为7.29×10-3.这一结果与传统勘探方法的计算结果基本吻合,说明环境同位素方法的实用性.     

Smeared crack approach: back to the original track

This paper briefly reviews the formulations used over the last 40 years for the solution of problems involving tensile cracking, with both the discrete and the smeared crack approaches. The paper focuses on the smeared approach, identifying as its main drawbacks the observed mesh‐size and mesh‐bias spurious dependence when the method is applied ‘straightly’. A simple isotropic local damage constitutive model is considered, and the (exponential) softening modulus is regularized according to the material fracture energy and the element size. The continuum and discrete mechanical problems corresponding to both the weak discontinuity (smeared cracks) and the strong discontinuity (discrete cracks) approaches are analysed and the question of propagation of the strain localization band (crack) is identified as the main difficulty to be overcome in the numerical procedure. A tracking technique is used to ensure stability of the solution, attaining the necessary convergence properties of the corresponding discrete finite element formulation. Numerical examples show that the formulation derived is stable and remarkably robust. As a consequence, the results obtained do not suffer from spurious mesh‐size or mesh‐bias dependence, comparing very favourably with those obtained with other fracture and continuum mechanics approaches. Copyright © 2006 John Wiley & Sons, Ltd.     

昆仑山8.1级地震前中国大陆的构造应变背景

利用“网络工程”1998～2001年累积的1181个测站的GPS重复观测资料，采用双三次样条函数模型建立中国大陆水平运动模型速度场，用大地坐标在椭球面上计算各类应变场，详细分析了2001年昆仑山8．1级地震前中国大陆水平构造应变场空间分布特征。各类构造应变场的最高值都出现在喜马拉雅构造带与昆仑山地块内(地震断裂带南侧)，鲜水河—安宁河断裂带次之。分析表明，昆仑山8．1级地震正好发生在张性面膨胀应变率的高值区，第一、第二和最大剪应变率高值区边缘的突变区和最大、最小主应变率的高值区。