Stability of sandy slopes under seepage conditions

Stability against shallow mass sliding in saturated sandy slopes under seepage depends on the flow direction and hydraulic gradient, particularly near the ground surface. Two modes of instability i.e., Coulomb sliding and liquefaction have been studied and the critical flow directions discussed. The utility of the numerical approach in solving complex flow problems with irregular boundaries and surface topography is demonstrated by means of two slope examples with different internal drainage conditions. The numerical results for the seepage gradients at different points are compared with those predicted by the simple expression derived in this study, and the corresponding effects on the stability are evaluated.     

黄河聊城段侧渗分析研究

黄河在山东境内属地上河,常年补给两侧地下水,是沿河地带地下水资源的重要组成部分.依据黄河聊城段东阿县境内的艾山侧渗断面1986～1994年地下水位资料,在分析水文地质条件和地下水流态的基础上,应用水均衡原理分析计算导水系数T,并通过同位素示踪试验得到了验证.利用达西公式计算单侧年侧渗量,建立艾山水位、年径流-侧渗量关系,并与应量平衡法和地下水非稳定流公式计算的成果作了对照分析.     

渗流场反分析及其在多孔介质中的应用

本文讨论了复杂地质环境中渗流场的反分析问题，利用地下水流数值模拟结合最优化技术，通过对地下渗流场的模拟和寻优，求得描述地下含水介质非稳定渗流场的重要参位──渗透系数和给水度的模型解，并应用于各向同性的多孔介质渗流场反分析实例中。     

Seepage driving effect on deformations of San Fernando dams

In the process of flow deformation of an earth dam, the seepage force inside the dam plays a role as a driving force. The seepage force acts just like the gravitational force in terms of pushing soils away from their original locations after liquefaction is triggered. This paper draws attention to this seepage driving effect by presenting a set of fully coupled finite element analyses on the well-known San Fernando dams, with the objective of evaluating the impact of this seepage effect. The results indicate that while this effect is always there, its practical significance depends on a number of factors. In the case of the upper San Fernando dam, which experienced a significant, but restricted, downstream movement during the 1971 earthquake, the seepage driving effect was indeed significant. On the contrary, for the lower dam, which failed and slid into the upstream reservoir during the same earthquake, this seepage effect was relatively less pronounced. The detailed results of the analyses reveal the likely mechanisms of failure and deformation of the two dams and the likely cause behind the difference between their responses during the earthquake.     

Large scale three-dimensional seepage analysis model test and numerical simulation research on undersea tunnel

During the construction process of Qingdao Jiaozhou Bay Undersea Tunnel, the faults and other unfavorable geological discontinuities were often encountered. To study the water inrush mechanism in the faults, both physical model test and numerical analysis were carried out. The results of crown displacement and hydraulic pressure of the monitoring sections in the physical model and numerical model were analyzed in this paper. It was found that the displacement and hydraulic pressure in the process of tunnel construction are often interacted as both cause and effect, and the lower of hydraulic pressure is often accompanied with the growth of its displacement. The changing of the excavation disturbed zone during the excavation in the undersea tunnel was also studied. The results show that the excavation disturbed zone in fault is larger than that in surrounding rock mass, and the excavation disturbance effects in the filling type fault are both transient and persistent. When the displacement and hydraulic pressure in the undersea tunnel change sharply during excavation, there are relatively slow and continuous change trend of the displacement and hydraulic pressure. For practical purposes, to prevent water inrush in the undersea tunnel, more attentions should also be paid to the undersea tunnel after excavation.     

Detection of seepage paths in earth dams using self-potential and electrical resistivity methods

Earth and rockfill dams are designed to operate under steady state seepage. Anomalous seepage may be a threat to the integrity of the structure. In spite of advances made in the fields of geotechnical engineering, it is not possible to have 100% leak-proof structure. Any excessive and unplanned seepage may lead to the failure of the dam, especially in unconsolidated or fractured terrains. Geophysical methods play an important role in mapping seepage paths and monitoring the changes of the seepage with time, enabling to plan technically and economically worthwhile remedial measures. In the present paper, utilisation of electrical methods for delineation of seepage zones at two of the four Saddle dams of the Som-Kamla-Amba project, Rajasthan State, India; which is founded on heterogeneous rock mass, is discussed. Electrical resistivity method was used to delineate zones favourable for seepage, whereas, self-potential (SP) method was used to delineate the seepage paths. SP measurements have shown negative anomaly of the order of 10–20 mV in amplitude, indicating low seepage, coinciding with the seepage measurements made by the project authorities.     

Seepage and consolidation of bentonite saturated with pure- or salt-water by the method of unified molecular dynamics and homogenization analysis

Bentonite clay is a micro-inhomogeneous material, which consists of clay minerals (mainly montmorillonite), macro-grains (mainly quartz), water, air and others. Properties of the saturated bentonite clay are essentially characterized by the montmorillonite and water (i.e. montmorillonite hydrate). We analyze the molecular behavior of sodium montmorillonite hydrate Na_1/3Al₂[Si_11/3Al_1/3]O₁₀(OH)₂·nH₂O by applying a molecular dynamics (MD) simulation method. And by using the MD results we calculate the swelling property of the montmorillonite hydrate, and compare with an experimental result. Next, by using the same MD procedure we treat a montmorillonite mineral with a large number of external water molecules to check the properties of the water. Here we treat pure- and salt-water. Then we calculate the diffusivity and viscosity of water molecules and Na⁺ and Cl⁻ ions.

For extending the microscopic characteristics of constituent materials to a macroscopic seepage behavior of the micro-inhomogeneous material we apply a homogenization analysis (HA). That is, starting with the Navier–Stokes equation with distributed viscosity that is calculated by the former MD procedure we determine macroscopic permeability characteristics of bentonite for both cases of pure- and salt-water. Then, by using the permeability property we calculate long-term consolidation behavior of buffering clay, which is planed to be used for high-level radioactive waste (HLRW) management. Here the deformation is treated under the well-defined Cam clay model.     

Evaluation and treatment of seepage problems at Chapar-Abad Dam, Iran

Engineering geological properties of the ground at the Chapar-Abad Dam were investigated in order to evaluate seepage problems and to select a proper method of water-proofing prior to construction. The dam is located to the northwest of Iran and is undergoing construction phase. The geology of the site consists of a series of Early Cambrian limestones and shales that crop out on the abutments and a valley that is filled by 60 m of alluvium deposits. The presence of thick alluvium deposits with various coefficients of permeability along the foundation demonstrates a possible seepage problem after water impoundment in the reservoir. The potential of water seepage was evaluated by the study of joint systems of the rock units, the use of numerical analysis to simulate water flow in the ground, and by conducting in-situ tests to estimate the permeability's values. Based on the obtained results and by reviewing many types of water-proofing methods regarding cost, feasibility and safety factors, the installation of a grout curtain is suggested.     

A rational approach to seepage flow effects on bottom friction beneath random waves

The bottom friction beneath random waves is predicted taking into account the effect of seepage flow. This is achieved by using wave friction factors for rough turbulent, smooth turbulent and laminar flow valid for regular waves together with a modified Shields parameter which includes the effect of seepage flow. Examples using data typical to field conditions are included to illustrate the approach. The analytical results can be used to make assessment of seepage effects on the bottom friction based on available wave statistics. Generally, it is recommended that a stochastic approach should be used rather than using the rms values in an otherwise deterministic approach.