毛乌素沙区1961-2016年降水特征

基于毛乌素沙区10个气象站1961-2016年观测资料，应用Mann-Kendall方法和t检验法对各气象站年降水量进行了突变检验，借助小波分析讨论了各气象站年降水量的周期特征，根据降水量等值线划分结果对整个研究区分区分析了年、季、月和日尺度上的降水变化特征，并在两个时段上分析了季节性降水的差异。结果表明：毛乌素沙区年降水量空间特征差异明显，东部亚区呈上升趋势，中西部亚区呈下降趋势，但变化趋势不显著且无突变发生；降水年内分配不均，干湿季分明，降水集中在5-9月，夏秋季降水占全年降水比重大，季、月和日尺度降水量存在梯度递减变化；年降水量的年际变化过程存在多重时间尺度的自相似结构；近26年的冬春季降水增加显著，但降水波动幅度小于前30年。     

Study of the flood control scheduling scheme for the Three Gorges Reservoir in a catastrophic flood

The Three Gorges Project is the world's largest water conservancy project. According to the design standards for the 1,000‐year flood, flood diversion areas in the Jingjiang reach of the Yangtze River must be utilized to ensure the safety of the Jingjiang area and the city of Wuhan. However, once these areas are used, the economic and life loss in these areas may be very great. Therefore, it is vital to reduce this loss by developing a scheme that reduces the use of the flood diversion areas through flood regulation by the Three Gorges Reservoir (TGR), under the premise of ensuring the safety of the Three Gorges Dam. For a 1,000‐year flood on the basis of a highly destructive flood in 1954, this paper evaluates scheduling schemes in which flood diversion areas are or are not used. The schemes are simulated based on 2.5‐m resolution reservoir topography and an optimized model of dynamic capacity flood regulation. The simulation results show the following. (a) In accord with the normal flood‐control regulation discharge, the maximum water level above the dam should be not more than 175 m, which ensures the safety of the dam and reservoir area. However, it is necessary to utilize the flood diversion areas within the Jingjiang area, and flood discharge can reach 2.81 billion m³. (b) In the case of relying on the TGR to impound floodwaters independently rather than using the flood diversion areas, the maximum water level above the dam reaches 177.35 m, which is less than the flood check level of 180.4 m to ensure the safety of the Three Gorges Dam. The average increase of the TGR water level in the Chongqing area is not more than 0.11 m, which indicates no significant effect on the upstream reservoir area. Comparing the various scheduling schemes, when the flood diversion areas are not used, it is believed that the TGR can execute safe flood control for a 1,000‐year flood, thereby greatly reducing flood damage.     

Numerical modeling for analyzing thermal surface anomalies induced by underground coal fires

Coal seams burning underneath the surface are recognized all over the world and have drawn increasing public attention in the past years. Frequently, such fires are analyzed by detecting anomalies like increased exhaust gas concentrations and soil temperatures at the surface. A proper analysis presumes the understanding of involved processes, which determine the spatial distribution and dynamic behavior of the anomalies.In this paper, we explain the relevance of mechanical and energy transport processes with respect to the occurrence of temperature anomalies at the surface. Two approaches are presented, aiming to obtain insight into the underground coal fire situation: In-situ temperature mapping and numerical simulation. In 2000 to 2005, annual temperature mapping in the Wuda (Inner Mongolia, PR China) coal fire area showed that most thermal anomalies on the surface are closely related to fractures, where hot exhaust gases from the coal fire are released. Those fractures develop due to rock mechanical failure after volume reduction in the seams. The measured signals at the surface are therefore strongly affected by mechanical processes.More insight into causes and effects of involved energy transport processes is obtained by numerical simulation of the dynamic behavior of coal fires. Simulations show the inter-relation between release and transport of thermal energy in and around underground coal fires. Our simulation results show a time delay between the coal fire propagation and the observed appearance of the surface temperature signal. Additionally, the overall energy flux away from the burning coal seam into the surrounding bedrock is about 30-times higher than the flux through the surface. This is of particular importance for an estimation of the energy released based on surface temperature measurements. Finally, the simulation results also prove that a fire propagation rate estimated from the interpretation of surface anomalies can differ from the actual rate in the seam.     

Supercritical gas sorption on moist coals

The effect of moisture on the CO₂ and CH₄ sorption capacity of three bituminous coals from Australia and China was investigated at 55 °C and at pressures up to 20 MPa. A gravimetric apparatus was used to measure the gas adsorption isotherms of coal with moisture contents ranging from 0 to about 8%. A modified Dubinin–Radushkevich (DR) adsorption model was found to fit the experimental data under all conditions. Moisture adsorption isotherms of these coals were measured at 21 °C. The Guggenheim–Anderson–de Boer (GAB) model was capable of accurately representing the moisture isotherms over the full range of relative pressures.Moist coal had a significantly lower maximum sorption capacity for both CO₂ and CH₄ than dry coal. However, the extent to which the capacity was reduced was dependent upon the rank of the coal. Higher rank coals were less affected by the presence of moisture than low rank coals. All coals exhibited a certain moisture content beyond which further moisture did not affect the sorption capacity. This limiting moisture content was dependent on the rank of the coal and the sorbate gas and, for these coals, corresponded approximately to the equilibrium moisture content that would be attained by exposing the coal to about 40–80% relative humidity. The experimental results indicate that the loss of sorption capacity by the coal in the presence of water can be simply explained by volumetric displacement of the CO₂ and CH₄ by the water. Below the limiting moisture content, the CO₂ sorption capacity reduced by about 7.3 kg t^− 1 for each 1% increase in moisture. For CH₄, sorption capacity was reduced by about 1.8 kg t^− 1 for each 1% increase in moisture.The heat of sorption calculated from the DR model decreased slightly on addition of moisture. One explanation is that water is preferentially attracted to high energy adsorption sites (that have high energy by virtue of their electrostatic nature), expelling CO₂ and CH₄ molecules.     

中国甘肃省酒泉地区公婆泉盆地早白垩世恐龙化石

中国甘肃省酒泉地区公婆泉盆地下白垩统新民堡群的恐龙化石主要由1992年中日丝绸之路恐龙考察计划和1997~2000年中美马鬃山恐龙考察计划发掘和研究。先后发现的恐龙包括兽脚类、蜥脚类、禽龙类和新角龙类等。这一新的公婆泉恐龙组合的主要特征是同时包含了在晚白垩世占主导地位的几类恐龙的基干分子,如戈壁巨龙(Gobititan)是巨龙型类的基干分子,马鬃龙(Equijubus)是鸭嘴龙型类的基干分子,而古角龙(Archaeoceratops)和黎明角龙(Auroraceratops)是新角龙类的基干分子。公婆泉恐龙组合的另一特征是其某些成员的体型较大,如似鸟龙类和镰刀龙类恐龙是同期同类中最大的。比较研究发现,公婆泉盆地新民堡群的恐龙和辽西热河群的恐龙关系密切,但前者的整体来说要比后者进步。考虑到公婆泉盆地新民堡群的时代(Albian)较辽西热河群(Hauterivian晚期-Aptian早期)晚,公婆泉恐龙组合似应代表中国北方早白垩纪鹦鹉嘴龙恐龙动物群进化过程中较进步的一个阶段。     

Case history of controlling a landslide at Panluo open-pit mine in China

Controlling of landsides safely and economically is a great challenge to mine operators because landslides are major geological problems especially in open-pit mines. In this paper, a case history at Panluo open-pit mine is presented in detail to share the experiences and lessons with mine operators. Panluo open-pit mine is located in the southwestern Fujian province of China. It is the largest open-pit iron mine in the Fujian province and was planned in 1965 and is in full operation from 1978. In July 1990, an earthquake of magnitude 5.3 in Taiwan Strait and big rainstorms impacted the mine slope, causing tension cracks and rather large-scale failures, and forming a U-shaped landslide. Total potential volume was estimated to be up to 1.0 × 10⁶ m³. This directly threatened the mine production. In order to protect the mine production and the dwellers’ safety around, a dynamic comprehensive method was implemented including geotechnical investigations, in-situ testing and monitoring, stability analysis, and many mitigation and preventive measures. These measures slowed down the development and further occurrence of the landslide. The results showed that the landslides were still active, it was slowed with the control measures and moved rapidly with rainfall and mining down. However, no catastrophic accidents occurred and the pit mining was continued till it was closed at the elevation of 887 m in 2000. As a successful case of landslide control at an open-pit mine for 10 years, this paper reports the controlling measures in details. These experiences of landslide control may be beneficial to other similar mines for landslide control.     

Georadiochemical evidence to weathering of mining residues of the Mansfeld mining district,Germany

Mining heaps are used as archives for the investigation of weathering processes. Aim of this work was to investigate the different weathering behavior of heap materials derived from Kupferschiefer mining with respect to environmental hazard. For this purpose, Kupferschiefer and slag material of two heaps of different age were examined regarding to the radionuclide distribution and geochemical composition. By measuring of the local dose rate, performing digital autoradiography and gamma spectrometry the radiological load of the heaps and the heap materials was determined. The geochemical characterization of the samples was performed by XRF, ICP–OES and ICP–MS. The results show a clear higher radionuclide load of the younger slag heap. A depletion of chalcophile and lithophile elements in the older slag was determined. Apart from a homogeneous radionuclide distribution, considerable radionuclide enrichments in fossil fragments could be proven. The results reveal a different weathering behavior of slag material in comparison to the Kupferschiefer depending on the chemical binding of the elements on organic and inorganic species. Natural organic matter as well as apatite in Kupferschiefer act as retention barrier for some metals.     

Composition and quality of coals in the Huaibei Coalfield, Anhui, China

The Huaibei Coalfield, Anhui Province, China, is one of the largest coalfields in China. The coals of Permian age are used mainly for power generation. Coal compositions and 47 trace elements of the No. 10 Coal of the Shanxi Formation, the No. 7, 5, and 4 Coals of the Lower Shihezi Formation, and the No. 3 Coal of the Upper Shihezi Formation from the Huaibei Coalfield were studied. The results indicate that the Huaibei coals have low ash, moisture, and sulfur contents, but high volatile matter and calorific value. The ash yield increases stratigraphically upwards, but the volatile matter and total sulfur contents show a slight decrease from the lower to upper seams. Magmatic intrusion into the No. 5 Coal resulted in high ash, volatile matter, and calorific value, but low moisture value in the coal. Among the studied 47 trace elements, Ba, Co, Cr, Cu, Hg, Mo, Ni, Pb, Sb, Th, U, V, and Zn are of environmental concerns. Four elements Hg, Mo, Zn, and Sb are clearly enriched in the coals as compared with the upper continental crust.