Spectral variations of DY Cen

Two high resolution spectra of the hot RCrB star DY Cen in the red region are compared. The photospheric absorption lines show a radial velocity variation of 12 kms-1 between 1989 July and 1992 May. Emission components to some CII lines present in 1989 are almost entirely absent in 1992. Nebular forbidden lines of [OI], [NII] and [SII] appear unchanged from 1989 to 1992     

Origin and evolution of the Steamboat Springs siliceous sinter deposit, Nevada, U.S.A.

Siliceous hot spring deposits from Steamboat Springs, Nevada, U.S.A., record a complex interplay of multiple, changing, primary environmental conditions, fluid overprinting and diagenesis. Consequently these deposits reflect dynamic geologic and geothermal processes. Two surface sinters were examined—the high terrace, and the distal apron-slope, as well as 13.11 m (43 ft) of core material from drill hole SNLG 87-29. The high terrace sinter consists of vitreous and massive-mottled silica horizons, while the distal deposit and core comprise dominantly porous, indurated fragmental sinters. Collectively, the three sinter deposits archive a complete sequence of silica phase diagenetic minerals from opal-A to quartz. X-ray powder diffraction analyses and infrared spectroscopy of the sinters indicate that the distal apron-slope consists of opal-A and opal-A/CT mineralogy; the core yielded opal-A/CT and opal-CT with minor opal-A; and the high terrace constitutes opal-C, moganite, and quartz. Mineralogical maturation of the deposit produced alternating nano–micro–nano-sized silica particle changes. Based on filament diameters of microbial fossils preserved within the sinter, discharging thermal outflows fluctuated between low-temperatures (< 35 °C, coarse filaments) and mid-temperatures ( 35–60 °C, fine filaments). Despite transformation to quartz, primary coarse and fine filaments were preserved in the high terrace sinter. AMS ¹⁴C dating of pollen from three horizons within core SNLG 87-29, from depths of 8.13 to 8.21 m (26′8″ to 26′11″), 10.13 to 10.21 m (33′3″ to 33′6″), and 14.81 to 14.88 m (48′7″ to 48′10″), yielded dates of 8684 ± 64 years, 11,493 ± 70 years and 6283 ±60 years, respectively. In the upper section of the core, the stratigraphically out-of-sequence age likely reflects physical mixing of younger sinter with quartzose sinter fragments derived from the high terrace. Within single horizons, mineralogical and morphological components of the sinter matrix were spatially patchy. Overall, the deposit was modified by sub-surface flow of alkali-chloride thermal fluids depositing a second generation of silica, and periodically, by acidic steam condensate formed during periods when the water table was low. Local faulting produced considerable fracturing of the sinter. Hence, the Steamboat Springs sinter experienced a complex history of primary and secondary hydrothermal, geologic and diagenetic events, and their inter-relationships and effects are locked within the physical, chemical and biological signatures of the deposit.     

Petrography and textural development of inorganic and biogenic lithotypes in a relict barite tufa deposit at Flybye Springs, NT, Canada

A relict mound of Holocene barite (BaSO₄) tufa underlies the Flybye Springs, a small, barium‐rich, cold sulphur spring system in the Northwest Territories of Canada. The tufa is composed of relatively pure barite with ≤0·34 wt% Ca²⁺ and ≤0·77 wt% Sr²⁺. The mound is made up of coated bubble, raft, undulatory sheet, stromatolitic, coated grain and detrital conglomerate barite tufa. Although previously unreported in barite, these lithotypes are akin to facies found in many carbonate spring deposits. Raft and ooid‐coated grain tufa was formed via ‘inorganic’ barite precipitation in spring water ponds and tributaries where rapid oxidation of sulphide to sulphate established barite supersaturation. Undulatory sheet tufa may have formed by the reaction of dissolved barium with sulphate derived from the oxidation of extracellular polysaccharide‐rich colloidal sulphur films floating in oxygenated, barite‐saturated spring water ponds. Coated bubble, oncoid‐coated grain and stromatolitic tufa with filamentous microfossils was formed in close association with sulphur‐tolerant microbes inhabiting dysoxic and oxygenated spring water tributaries and ponds. Adsorption of dissolved barium to microbial extracellular polysaccharide probably facilitated the development of these ‘biogenic’ lithotypes. Detrital conglomerate tufa was formed by barite cementation of microdetrital tufa, allochthonous lithoclasts and organic detritus, including caribou hair. Biogenic textures, organic artefacts and microfossils in the Flybye barite tufa have survived diagenetic aggradational recrystallization and precipitation of secondary cements, indicating the potential for palaeoecological information to be preserved in barite in the geological record. Similarities between the Flybye barite tufa and carbonate spring deposits demonstrate that analogous textures can develop in chemical sedimentary systems with distinct mineralogy, biology and physiochemistry.     

Occurrence and evolution of the Xiaotangshan hot spring in Beijing, China

Thermal groundwater occurs in bedrock aquifers consisting of the dolomite of the Wumishan Group of the Jixianin System and the Cambrian carbonate in the Xiaotangshan geothermal field near the northern margin of the North China Plain, China. The hot water in the geothermal field of basin-type discharges partly in the form of the Xiaotangshan hot spring under natural conditions. The hot water has TDS of less than 600 mg/L and is of Na·Ca-HCO₃ type. The geothermal water receives recharge from precipitation in the mountain area with elevation of about 500 m above sea level to the north of the spring. Thermal groundwater flows slowly south and southeast through a deep circulation with a residence time of 224 years estimated with the Ra–Rn method. The Xiaotangshan hot spring dried up in the middle of the 1980s owing to the increasing withdrawal of the hot water in the geothermal field in the past decades. The water level of the geothermal system still falls continually at an annual average rate of about 2 m, although water temperature changes very little, indicating that the recharge of such a geothermal system of basin-type is limited. Over-exploitation has a dramatic impact on the geothermal system, and reduction in exploitation and reinjection are required for the sustainable usage of the hot water.     

西藏搭格架热泉型铯矿床矿物学与矿石组构特征及地质意义

在查明搭格架铯矿床产出的地质背景、成矿阶段及其年龄、地球化学与同位素组成的基础上,本文较为系统地研究了硅华的矿物学与组构特征,加深了对硅华形成演化过程的认识.研究表明成矿早期,矿石中存在大量的石英,晚期全为蛋白石.粒状蛋白石自早到晚均有出现,胶状蛋白石主要出现于晚期.早期矿石出现脱水造成的菜花状、粗粒块状与粗大孔隙状构造及溶蚀结构.晚期出现细粒块状与细小孔隙状构造.在第3阶段存在硅藻Denticula属,体现出低温阶段的特征.由早到晚,矿石的SiO2呈降低趋势,而(Na2O Al2O3 K2O CaO)与Cs2O呈升高趋势,是随着矿石中SiO2有序度的降低而其它成分被保留在晶格中所致.     

First results from the North Iceland experiment

Between June 2004 and September 2004 a temporary seismic network was installed on the northern insular shelf of Iceland and onshore in north Iceland. The seismic setup aimed at resolving the subsurface structure and, thus, the geodynamical transition from Icelandic crust to typical oceanic crust along Kolbeinsey Ridge. The experiment recorded about 1,000 earthquakes. The region encloses the Tjörnes Fracture Zone containing the Husavik–Flatey strike-slip fault and the extensional seismic Grimsey Lineament. Most of the seismicity occurs in swarms offshore. Preliminary results reveal typical mid-ocean crust north of Grimsey and a heterogeneous structure with major velocity anomalies along the seismic lineaments and north–south trending subsurface features. Complementary bathymetric mapping highlight numerous extrusion features along the Grimsey Lineament and Kolbeinsey Ridge. The seismic dataset promises to deliver new insights into the tectonic framework for earthquakes in an extensional transform zone along the global mid-ocean ridge system.     

Springs of Great Britain

Predictably, in a country such as Britain, with its preponderance of consolidated, sedimentary, mainly fissure-flow aquifers, there is a very large number of springs, many of which are, or have been, used for public supply. Migratory springs are a feature of the British (Ur. Cretaceous) Chalk, the most important British aquifer. The Chalk's low specific yield and high capillary moisture retention together give rise to very considerable fluctuations (more than 33 m in some areas) of the unconfined water table. Along the gentle dip slopes of the Chalk (North and South Downs of southern and southeastern England) springs may migrate laterally for several miles, giving rise to seasonal streams locally known as bournes or lavants. However, springs such as at Duncton, West Sussex, at the base of the much steeper scarp slopes of the Chalk, form point sources, the flows from which tend to be relatively steady; such springs commonly supply and are the original reason for the existence of many of the small towns and villages which nestle along the bases of the chalk scarps of Sussex and Kent.Where the Chalk forms coastal cliffs, a number of springs break out at the base of the cliff between high and low tide levels; there are major chalk coastal springs, for instance, at St. Margaret's Bay (Kent) and at Arish Mells, east of Lulworth Cove, Dorset. Such springs are not used for direct supply (their salinity is usually too high) but are indicators of the presence of local reserves of groundwater for possible future development.     

Evidence for deep groundwater flow and convective heat transport in mountainous terrain, Delta County, Colorado, USA

The Tongue Creek watershed lies on the south flank of Grand Mesa in western Colorado, USA and is a site with 1.5 km of topographic relief, heat flow of 100 mW/m², thermal conductivity of 3.3 W m^–1 °C^–1, hydraulic conductivity of 10^-8 m/s, a water table that closely follows surface topography, and groundwater temperatures 3–15°C above mean surface temperatures. These data suggest that convective heat transport by groundwater flow has modified the thermal regime of the site. Steady state three-dimensional numerical simulations of heat flow, groundwater flow, and convective transport were used to model these thermal and hydrological data. The simulations provided estimates for the scale of hydraulic conductivity and bedrock base flow discharge within the watershed. The numerical models show that (1) complex three-dimensional flow systems develop with a range of scales from tens of meters to tens of kilometers; (2) mapped springs are frequently found at locations where contours of hydraulic head indicate strong vertical flow at the water table, and; (3) the distribution of groundwater temperatures in water wells as a function of surface elevation is predicted by the model.     

云南会泽铅锌矿喷流沉积成因研究

会泽铅锌矿床的成因认识各异,曾认为是沉积—改造层控型矿床。研究前人资料、结合亲历找矿实践,讨论该矿床另一种不同的成矿方式。研究矿床地质、地球化学、同位素组成、包裹体、方铅矿年龄测定和成矿温度测试等表明:会泽铅锌矿属海底热卤水喷流沉积—改造层控型矿床,与芒特—艾萨型热卤水喷流沉积层控矿床类似。