The isotopic signature of monsoon conditions,cloud modes,and rainfall type

This work provides a comprehensive physically based framework for the interpretation of the north Australian rainfall stable isotope record (δ¹⁸O and δ²H). Until now, interpretations mainly relied on statistical relationships between rainfall amount and isotopic values on monthly timescales. Here, we use multiseason daily rainfall stable isotope and high resolution (10 min) ground‐based C‐band polarimetric radar data and show that the five weather types (monsoon regimes) that constitute the Australian wet season each have a characteristic isotope ratio. The data suggest that this is not only due to changes in regional rainfall amount during these regimes but, more importantly, is due to different rain and cloud types that are associated with the large scale circulation regimes. Negative (positive) isotope anomalies occurred when stratiform rainfall fractions were large (small) and the horizontal extent of raining areas were largest (smallest). Intense, yet isolated, convective conditions were associated with enriched isotope values whereas more depleted isotope values were observed when convection was widespread but less intense. This means that isotopic proxy records may record the frequency of which these typical wet season regimes occur. Positive anomalies in paleoclimatic records are most likely associated with periods where continental convection dominates and convection is sea‐breeze forced. Negative anomalies may be interpreted as periods when the monsoon trough is active, convection is of the oceanic type, less electric, and stratiform areas are wide spread. This connection between variability of rainfall isotope anomalies and the intrinsic properties of convection and its large‐scale environment has important implications for all fields of research that use rainfall stable isotopes.     

On model predictions of the power spectral density of radial solar p modes

We investigate the frequency dependence of the power spectral density of low-degree solar p modes by comparing measurements with the results of a stochastic-excitation model. In the past it was common practice to use the total power in such investigations. Using the maximum of the power spectral density instead provides a direct comparison with the measured mode heights in the observed power spectrum. This method permits a more careful calibration of the adjustable parameters in the excitation model, a model which we present here, for the first time, in a format that precisely and unambiguously relates the amplitudes of the modes of oscillation to the Reynolds stress in the equilibrium model. We find that errors in the theory of the linear mode damping rates, particularly at low frequency, have a dramatic impact on the predictions of the mode heights in the spectral density, whereas parameter changes in the stochastic excitation model, within a plausible domain of parameter space, have a comparatively small effect.     

Spatially intermittent fields in photospheric magnetoconvection

Motivated by recent high-resolution observations of the solar surface, we investigate the problem of non-linear magnetoconvection in a three-dimensional compressible layer. We present results from a set of numerical simulations which model the situation in which there is a weak imposed magnetic field. This weak-field regime is characterized by vigorous granular convection and spatially intermittent magnetic field structures. When the imposed field is very weak, magnetic flux tends to accumulate at the edges of the convective cells, where it forms compact, almost 'point-like' structures which are reminiscent of those observed in the quiet Sun. If the imposed field is slightly stronger, there is a tendency for magnetic flux to become concentrated into 'ribbon-like' structures which are comparable to those observed in solar plages. The dependence of these simulations upon the strength of the imposed magnetic field is analysed in detail, and the concept of the fractal dimension is used to make a further, more quantitative comparison between these simulations and photospheric observations.     

Slumping and shallow faulting related to the presence of salt on the Continental Slope and Rise off North Carolina

Seismic reflection profiles and long- and medium-range sidescan sonar were used to investigate a salt diapir complex and area of slope instability near the base of the Continental Slope off North Carolina. Within the area of investigation three diapirs are bounded on their upslope side by a scarp 60 m high and 50 km long. The slope above the scarp is characterized by a series of shallow rotational normal faults. The bottom below the scarp is furrowed by slide tracks, which were probably carved by large blocks that broke off the scarp face and slid downslope leaving rubble and scree lobes.Extensive slumping in this area appears to be a result of uplift and faulting associated with salt intrusion, which has fractured and oversteepened the slope leading to instability and failure. Sharply defined slide tracks suggest that slope failure above the breached diapir complex is a continuing process, in contrast to much of the surrounding slope area where few instability features were observed.     

Mass heterogeneities and convection in the earth's mantle inferred from gravity and core-mantle boundary irregularities

Mass heterogeneities in the earth's mantle are retrieved from the gravity data and the topography of the core-mantle boundary as well as the topography of the earth's surface. A mantle circulation induced by the heterogeneities is modelled by solving the Stokes problem for incompressible Newtonian fluid. The derived models of mantle motions correlate well with the plate tectonics and point at a close relation between the surface tectonic activity and the processes in the vicinity of the core-mantle boundary.     

Phosphorus transport in shallow groundwater in peri-urban Kampala, Uganda: results from field and laboratory measurements

To understand Phosphorus (P) sources and transport processes in the subsurface in Bwaise III Parish, Kampala, P attenuation and adsorption capacities of soils were studied in situ and from laboratory measurements. Relationships between sorption parameters and soil matrix properties, rates and mechanism of the adsorption process and soil P fractions were also investigated. P was generally higher in the wet than the dry season, but for both seasons, the maximum was 5 mgP/l. P transport mechanisms appeared to be a combination of adsorption, precipitation, leaching from the soil media and by colloids with the latter two playing an important role in the wet season. The sorption process comprised two phases with the first stage rate constants being about fourfold those of the second stage. The Langmuir isotherm described the sorption data well (R ² ≥ 0.95) with the second soil layer exhibiting the highest sorption maximum (C _max) (average value 0.6 ± 0.17 mgP/gDW). The best prediction of C _max had organic carbon, Ca, available P and soil pH. Residual P consisting mostly of organics was the main fraction in all the layers followed by inorganic HCl-P and NaOH-P in the top and middle layers, respectively. Loosely bound P (NH₄Cl-P) was the least fraction (<0.4% of total P) in all layers indicating the high binding capacity of P by the soils. The study results suggest that P dynamics is related to Ca, Fe and organic carbon content of the soils.     

Numerical modeling of rainstorm-induced shallow landslides in saturated and unsaturated soils

For the assessment of shallow landslides triggered by rainfall, the physically based model coupling the infinite slope stability analysis with the hydrological modeling in nearly saturated soil has commonly been used due to its simplicity. However, in that model the rainfall infiltration in unsaturated soil could not be reliably simulated because a linear diffusion-type Richards’ equation rather than the complete Richards’ equation was used. In addition, the effect of matric suction on the shear strength of soil was not actually considered. Therefore, except the shallow landslide in saturated soil due to groundwater table rise, the shallow landslide induced by the loss in unsaturated shear strength due to the dissipation of matric suction could not be reliably assessed. In this study, a physically based model capable of assessing shallow landslides in variably saturated soils is developed by adopting the complete Richards’ equation with the effect of slope angle in the rainfall infiltration modeling and using the extended Mohr–Coulomb failure criterion to describe the unsaturated shear strength in the soil failure modeling. The influence of rainfall intensity and duration on shallow landslide is investigated using the developed model. The result shows that the rainfall intensity and duration seem to have similar influence on shallow landslides respectively triggered by the increase of positive pore water pressure in saturated soil and induced by the dissipation of matric suction in unsaturated soil. The rainfall duration threshold decreases with the increase in rainfall intensity, but remains constant for large rainfall intensity.     

Design of shallow foundations under tensile loading for transmission line towers: An overview

Tensioned foundations are common in civil engineering applications such as transmission towers, harbors, offshore structures, basement slabs under pressure, industrial equipment, etc. Procedures for the design of tensioned foundations are discussed in this paper, including specific recommendations for more common transmission tower foundations. Starting from a distinction between shallow and deep modes of failure, the paper presents the most common failure mechanisms for shallow failure in tension, including procedures for calculation of foundation tensile capacity under vertical and inclined loading. Emphasis is given to the influence of the strength of the compacted backfill compared to the strength of the natural soil, including presentation of results of full-scale loading tests.     

Global Correlations of Ocean Ridge Basalt Chemistry with Axial Depth: a New Perspective

The petrological parameters Na₈ and Fe₈, which are Na₂O andFeO contents in mid-ocean ridge basalt (MORB) melts correctedfor fractionation effects to MgO = 8 wt%, have been widely usedas indicators of the extent and pressure of mantle melting beneathocean ridges. We find that these parameters are unreliable.Fe₈ is used to compute the mantle solidus depth (P_o) and temperature(T_o), and it is the values and range of Fe₈ that have led tothe notion that mantle potential temperature variation of T_P= 250 K is required to explain the global ocean ridge systematics.This interpreted T_P = 250 K range applies to ocean ridges awayfrom ‘hotspots’. We find no convincing evidencethat calculated values for P_o, T_o, and T_P using Fe₈ have anysignificance. We correct for fractionation effect to Mg^# = 0·72,which reveals mostly signals of mantle processes because meltswith Mg^# = 0·72 are in equilibrium with mantle olivineof Fo_89·6 (vs evolved olivine of Fo_{88·1–79·6}in equilibrium with melts of Fe₈). To reveal first-order MORBchemical systematics as a function of ridge axial depth, weaverage out possible effects of spreading rate variation, local-scalemantle source heterogeneity, melting region geometry variation,and dynamic topography on regional and segment scales by usingactual sample depths, regardless of geographical location, withineach of 22 ridge depth intervals of 250 m on a global scale.These depth-interval averages give Fe₇₂ = 7·5–8·5,which would give T_P = 41 K (vs 250 K based on Fe₈) beneathglobal ocean ridges. The lack of Fe₇₂–Si₇₂ and Si₇₂–ridgedepth correlations provides no evidence that MORB melts preservepressure signatures as a function of ridge axial depth. We thusfind no convincing evidence for T_P > 50 K beneath globalocean ridges. The averages have also revealed significantcorrelations of MORB chemistry (e.g. Ti₇₂, Al₇₂, Fe₇₂,Mg₇₂, Ca₇₂, Na₇₂ and Ca₇₂/Al₇₂) with ridge axial depth. Thechemistry–depth correlation points to an intrinsic linkbetween the two. That is, the 5 km global ridge axial reliefand MORB chemistry both result from a common cause: subsolidusmantle compositional variation (vs T_P), which determines themineralogy, lithology and density variations that (1) isostaticallycompensate the 5 km ocean ridge relief and (2) determine thefirst-order MORB compositional variation on a global scale.A progressively more enriched (or less depleted) fertileperidotite source (i.e. high Al₂O₃ and Na₂O, and low CaO/Al₂O₃)beneath deep ridges ensures a greater amount of modal garnet(high Al₂O₃) and higher jadeite/diopside ratios in clinopyroxene(high Na₂O and Al₂O₃, and lower CaO), making a denser mantle,and thus deeper ridges. The dense fertile mantle beneath deepridges retards the rate and restricts the amplitude of the upwelling,reduces the rate and extent of decompression melting, givesway to conductive cooling to a deep level, forces melting tostop at such a deep level, leads to a short melting column,and thus produces less melt and probably a thin magmatic crustrelative to the less dense (more refractory) fertile mantlebeneath shallow ridges. Compositions of primitive MORB meltsresult from the combination of two different, but geneticallyrelated processes: (1) mantle source inheritance and (2) meltingprocess enhancement. The subsolidus mantle compositional variationneeded to explain MORB chemistry and ridge axial depth variationrequires a deep isostatic compensation depth, probably in thetransition zone. Therefore, although ocean ridges are of shalloworigin, their working is largely controlled by deep processesas well as the effect of plate spreading rate variation at shallowlevels. KEY WORDS: mid-ocean ridges; mantle melting; magma differentiation; petrogenesis; MORB chemistry variation; ridge depth variation; global correlations; mantle compositional variation; mantle source density variation; mantle potential temperature variation; isostatic compensation     

Detection of free vertical convection and double-diffusion in groundwater monitoring wells with geophysical borehole measurements

Two algorithms for in-situ detection and identification of vertical free convective and double-diffusive flows in groundwater monitoring wells or boreholes are proposed. With one algorithm the causes (driving forces) and with the other one the effects (convection or double-diffusion) of vertical transport processes can be detected based on geophysical borehole measurements in the water column. Five density-driven flow processes are identified: thermal, solutal, and thermosolutal convection leading to an equalization, as well as saltfingers and diffusive layering leading to an intensification of a vertical density gradient. The occurrence of density-driven transport processes could be proven in many groundwater monitoring wells and boreholes; especially shallow sections of boreholes or groundwater monitoring wells are affected dramatically by such vertical flows. Deep sections are also impaired as the critical threshold for the onset of a density-driven flow is considerably low. In monitoring wells or boreholes, several sections with different types of density-driven vertical flows may exist at the same time. Results from experimental investigations in a medium-scale testing facility with high aspect ratio (height/radius = 19) and from numerical modeling of a water column agree well with paramters of in-situ detected convection cells.