资源三号和天绘一号卫星影像无控联合平差精度分析

近年来国产卫星传感器类型日益丰富，使用自主可控的国产卫星影像进行生产和研究的需求越来越大，多源国产卫星影像联合平差的精度分析显得尤为重要。本文针对在立体测图生产中，资源三号卫星影像在时相较旧、噪声较大、云覆盖和摄影漏洞等特殊困难的条件下，利用天绘一号卫星影像进行补漏生产的情况，最终分析并验证了两者无控联合平差的可行性和成果精度。     

A new stereo‐analytical method for determination of removal blocks in discontinuous rock masses

The paper provides a new stereo‐analytical method, which is a combination of the stereographic method and analytical methods, to separate finite removable blocks from the infinite and tapered blocks in discontinuous rock masses. The methodology has applicability to both convex and concave blocks. Application of the methodology is illustrated through examples. Addition of this method to the existing block theory procedures available in the literature improves the capability of block theory in solving practical problems in rock engineering. Copyright © 2003 John Wiley & Sons, Ltd.     

Rate constants for the reactions of the NO3 radical with HCOOH/HCOO− and CH3COOH/CH3COO− in aqueous solution between 278 and 328 K

The kinetics of the aqueous phase reactions of NO₃ radicals with HCOOH/HCOO^– and CH₃COOH/CH₃COO^– have been investigated using a laser photolysis/long-path laser absorption technique. NO₃ was produced via excimer laser photolysis of peroxodisulfate anions (S₂O ₈ ^2– ) at 351 nm followed by the reactions of sulfate radicals (SO ₄ ^– ) with excess nitrate. The time-resolved detection of NO₃ was achieved by long-path laser absorption at 632.8 nm. For the reactions of NO₃ with formic acid (1) and formate (2) rate coefficients ofk ₁=(3.3±1.0)×10⁵ l mol^–1 s^–1 andk ₂=(5.0±0.4)×10⁷ l mol^–1 s^–1 were found atT=298 K andI=0.19 mol/l. The following Arrhenius expressions were derived:k ₁(T)=(3.4±0.3)×10¹⁰ exp[–(3400±600)/T] l mol^–1 s^–1 andk ₂(T)=(8.2±0.8)×10¹⁰ exp[–(2200±700)/T] l mol^–1 s^–1. The rate coefficients for the reactions of NO₃ with acetic acid (3) and acetate (4) atT=298 K andI=0.19 mol/l were determined as:k ₃=(1.3±0.3)×10⁴ l mol^–1 s^–1 andk ₄=(2.3±0.4)×10⁶ l mol^–1 s^–1. The temperature dependences for these reactions are described by:k ₃(T)=(4.9±0.5)×10⁹ exp[–(3800±700)/T] l mol^–1 s^–1 andk ₄(T)=(1.0±0.2)×10¹² exp[–(3800±1200)/T] l mol^–1 s^–1. The differences in reactivity of the anions HCOO^– and CH₃COO^– compared to their corresponding acids HCOOH and CH₃COOH are explained by the higher reactivity of NO₃ in charge transfer processes compared to H atom abstraction. From a comparison of NO₃ reactions with various droplets constituents it is concluded that the reaction of NO₃ with HCOO^– may present a dominant loss reaction of NO₃ in atmospheric droplets.     

基于立体补偿的遥感立体像对压缩方法

提出研究遥感立体像对的压缩问题。主要讨论了左右影像的视差补偿和辐射补偿。针对遥感立体像对视差分布不均以及左右影像存在辐射差的特点,提出了一种基于立体补偿的遥感立体像对压缩算法。该算法以左片为基准图像,采用自适应视差估计计算出右片的视差矢量,结合辐射校正和重叠块视差补偿技术得到平滑的右片的预测图像,以右片减去预测图像得到残差图像,然后采用小波压缩算法对残差图像进行压缩。实验结果表明,该算法能显著提高遥感立体像对的压缩性能。     

充电激发极化法在金属矿上的应用

充电激发极化法是矿山物探的一种主要方法，其兼有充电法与激发极化法的特点，可利用已有的工程，最大限度地了解地下三度空间地球物理场的分布情况，解决地质问题。概述了其理论基础和方法技术，并列举了该方法在多个金属矿上的应用实例。     

激光测高数据辅助卫星成像几何模型精化处理

资源三号02星搭载了中国首个对地观测试验性激光测高载荷。借鉴目前较成熟的卫星影像区域网平差理论的基础上,结合近年来激光测高数据精度的大幅提升以及资源三号02星激光测高数据的特点,首次提出了激光测高数据辅助卫星立体影像进行成像几何模型精化处理的通用理论。首先,利用传统的区域网平差算法对所处理影像进行高精度连接点匹配处理,并对其进行无约束的自由网平差处理,获得高精度相对精度及不亚于原始成像几何模型的绝对精度;其次,根据激光测高数据3维坐标和精化后参考影像成像几何模型获取激光数据参考影像坐标;而后将参考影像坐标通过几何模型映射获取目标影像上待匹配影像坐标,通过连接点匹配算法,对待匹配目标影像坐标进行精化获取高精度像方同名点;最后,以同名点作为高程控制进行区域网平差计算,对影像成像几何模型进一步处理,获取高精度补偿参数。通过湖北、青海两测区的试验,以激光测高数据辅助卫星影像几何模型精化精度可分别达到1.97 m、3.23 m,结果表明本文提出的方法可有效提高卫星立体数据测图精度。     

以SRTM-DEM为控制的光学卫星遥感立体影像正射纠正

针对全球测图缺少统一的控制基准的问题,提出了利用SRTM-DEM作为控制基准,对光学卫星遥感影像进行正射纠正的方法。首先,对光学卫星影像构建的立体影像对进行自由网平差并制作DEM;然后,以SRTM-DEM作为控制,将DEM作为单元模型,进行独立模型法DEM区域网平差,获得单元模型的定向参数;最后,改正立体影像的成像几何模型参数,进行正射纠正。选取湖北咸宁和江西某地两个测区的资源三号数据进行试验,试验结果表明,资源三号正视全色影像的平面定向精度由12.93像素提高到6.85像素。     

PC－1500机配合坐标仪的地形数据采集程序

本文描述ＰＣ－１５００计算机与ＨＣＺ－１立体坐标量测仪相配合的地形点数据采集程序，并对该程序的结构、有关的数据模型以及使用等作了说明。