基于连续帧间差分的抛弃式探头三维下沉运动处理方法研究

抛弃式探头由无人机装载,能够在较远目标区域和危险海域开展海洋水文环境剖面参数的测量。通过安装不同传感器,可以实现对温度、盐度的剖面测量,其深度的测量采用数学方法计算得到。针对双摄像机水箱实验获得的5个不同攻角实验结果,分析了常用的运动目标的检测方法,最终选择基于连续帧间差分法,确定探头的三维坐标位置,进而得到探头下沉运动的三维运动轨迹和速度曲线等信息。探头从水面释放后攻角在下沉过程中不断调整,改变运动姿态,同时伴随自身的旋转,抵消水平方向阻力作用,初始攻角产生的深度测量误差主要体现在加速过程,探头达到匀速运动后测量误差不变,在不考虑横流的情况下,探头最后以匀速垂直下落运动。     

规则池塘群的复杂直线模式识别

针对现有面要素直线模式识别方法难以解决规则池塘中破碎区域的问题,提出了一种规则池塘群的复杂直线模式识别方法。首先,分析了规则池塘群的空间特征和认知特点,提出了“主次关系→并列关系→直线模式→复杂直线模式”的多层次认知顺序;其次,设计了主次关系池塘组、并列关系池塘组、直线模式池塘群的识别方法;最后,构建了复杂直线模式池塘群的识别模型。试验表明:本文方法能够消除破碎区域对规则池塘群直线模式提取的不利影响,有效提升复杂直线模式识别的质量。     

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.     

Analytical study of ground motion caused by seismic wave propagation across faulted rock masses

Studying seismic wave propagation across rock masses and the induced ground motion is an important topic, which receives considerable attention in design and construction of underground cavern/tunnel constructions and mining activities. The current study investigates wave propagation across a rock mass with one fault and the induced ground motion using a recursive approach. The rocks beside the fault are assumed as viscoelastic media with seismic quality factors, Q_p and Q_s. Two kinds of interactions between stress waves and a discontinuity and between stress waves and a free surface are analyzed, respectively. As the result of the wave superposition, the mathematical expressions for induced ground vibration are deduced. The proposed approach is then compared with the existing analysis for special cases. Finally, parametric studies are carried out, which includes the influences of fault stiffness, incident angle, and frequency of incident waves on the peak particle velocities of the ground motions.     

大别山及其周边现今垂直形变研究

基于1980年、2005年和2015年3期区域精密水准网观测资料，利用线性动态平差模型计算获取大别山地区水准网长期垂直运动速度场图像。研究发现，淮河平原地表下沉较为严重，大别山呈现弱隆升趋势运动，长江谷地边缘地区较大别山区呈现明显的隆升运动。跨郯庐断裂带水准剖面结果显示，垂直运动与地形呈负相关和弱相关。     

Overview of In - Situ Biodegradation and Enhancement

Microbial degradation technologies have been developed to restore ground water quality in aquifers polluted by organic contaminants effectively in recent years. However, in course of the degradation, the formation of biofilms in ground water remediation technology can be detrimental to the effectiveness of a ground water remediation project. Several alternatives are available to a remedial design engineer, such as Permeable Reactive Barriers (PRBs) and in -situ bioremediation, Hydrogen Releasing Compounds (HRCs) barrier, Oxygen Releasing Compounds (ORCs) barrier etc. which are efficient and cost- effective technologies. Excessive biomass formation renders a barrier ineffective in degrading the contaminants, Efforts are made to develop kinetics models which accurately determine bio - fouling and bio - filn formation and to control excessive biomass formation.     

Discovery of 13 New Variable Stars in the Field of the Open Cluster NGC 2168 （M35）

A wide-field time-series CCD photometric survey of variable stars in the field of the open cluster NGC 2168 was carried out using the BATC Schmidt telescope. In total 13 new variable stars are discovered with three W UMa systems, one EA type and two EB type eclipsing binaries (one of them could be a W UMa system), and seven pulsating stars including three candidates of δScuti stars.     

Multi-wavelength Diagnostics of Bombardment by Non-thermal Particles in Solar Flares

Chromospheric lines, including Ha, Lyα, Lyβand CaⅡK, CaⅡ8542, are systemically and quantitatively investigated with respect to the non-thermal excitation and ionization due to particle beam bombardment for a series of solar semi-empirical atmospheric models. As a result we propose to use the contrast in the integrated intensity of hydrogen lines to estimate the total energy flux of the bombarding beam during the solar flare impulsive phase. Partial frequency redistribution is considered in the Lyαline calculation and a smaller intensity enhancement in the Ha line-centers is found than in the previous results of Fang et al.     

Influence of the Choice of Core-Envelope Transition Point on the Binary Merger of Two Main-sequence Components

We have studied the influence of different choices of core-envelope transition point on the final merger of contact binaries with two main-sequence components. A binary of 1.00 + 0.90M⊙ with an initial orbital period of 0.35d is examined. The mass fraction of the primary mixed with the matter of the secondary, qmix, determined by the chosen core-envelope transition point, ranges from 0.04 to 1.00 in our analysis. If as qmix< 0.8, none of the