Experimental Study of a Command Governor Adaptive Depth Controller for an Unmanned Underwater Vehicle

Unmanned Underwater Vehicles (UUVs) are increasingly being used in advanced applications that require them to operate in tandem with human divers and around underwater infrastructure and other vehicles. These applications require precise control of the UUVs which is challenging due to the non-linear and time varying nature of the hydrodynamic forces, presence of external disturbances, uncertainties and unexpected changes that can occur within the UUV’s operating environment. Adaptive control has been identified as a promising solution to achieve desired control within such dynamic environments. Nevertheless, adaptive control in its basic form, such as Model Reference Adaptive Control (MRAC) has a trade-off between the adaptation rate and transient performance. Even though, higher adaptation rates produce better performance they can lead to instabilities and actuator fatigue due to high frequency oscillations in the control signal. Command Governor Adaptive Control (CGAC) is a possible solution to achieve better transient performance at low adaptation rates. In this study CGAC has been experimentally validated for depth control of a UUV, which is a unique challenge due to the unavailability of full state measurement and a greater thrust requirement. These in turn leads to additional noise from state estimation, time-delays from input noise filters, higher energy expenditure and susceptibility to saturation. Experimental results show that CGAC is more robust against noise and time-delays and has lower energy expenditure and thruster saturation. In addition, CGAC offers better tracking, disturbance rejection and tolerance to partial thruster failure compared to the MRAC.     

基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

抽油机悬点投影测量仪

油田抽油机的抽油杆幌动幅度过大，是引起抽油杆断裂的一个重要因素，检测这种幌动幅度是防止抽油杆断裂的一种有效手段。设计了一种基于面阵CCD和普通半导体激光器（LD）测量这种幌动的悬点投影测量方法，通过数字卷积滤波，达到了范围为0－40mm，误差＜0.2mm的技术检测指标。     

亚毫米波射电天文用超导SIS接收机的研制(英文)

为了研制亚毫米波射电天文用超导SIS(超导 -绝缘体 -超导 )接收机 ,我们重点开展了如下研究 ,1 )Nb超导SIS结在其能隙频率附近的量子混频特性 ,及其结合高能隙超导薄膜 (NbTiN)和高电导率金属薄膜 (Al)分布结阵在 780 - 950GHz频率区间的量子混频特性 ;2 )亚毫米波超导混频器嵌入阻抗的数值和实验表征 ;3)高电流密度小面积Nb超导SIS结的制备和特性表征 ;4)一个 60 0 - 72 0GHz超导SIS混频器的研制和特性表征。本文详细介绍了相关的数值分析和实验测量结果。     

Optimal Filtering Algorithm for Stochastic 2-D FMM Ⅱ with Multiplicative Noise

1　Introduction　Inrecentyearstherehasbeengrowingresearchin terestinthetwo dimensional (2 D )systemtheory .The 2 Dsystemsmayfindapplicationsinareassuchasmarineseismicdataprocessingandimageprocessing .Althoughmoreandmorevaluableresultshavebeengained ,mos…     

CCD联合平差方法及其初步实例检验

在常规照相天体测量工作中 ,对暗天体的定位是采用逐级定标星过渡的方法实现的。由于星表系统差和局部差的存在 ,最终定位结果可能包含难以把握的误差积累。在CCD小视场观测情况下时常难以找到足够数量的定标星。鉴于此 ,推导了CCD观测联合平差方法的严格矢量表达式 ,以期通过共同星的过渡 ,实现大天区统一平差。原理上此方法可实现相对于河外天体的定位 ,以削弱星表系统差和局部差对定位结果的影响。讨论了CCD联合平差方法实现中的问题 ,包括底片常数模型选择、切点位置改正、共同星的较差改正和法方程解算方法等 ,并分析了具体的处理措施。用实例初步检验了CCD联合平差方法的效果 ,表明通过对多张CCD观测的联合平差 ,可以削弱单张CCD观测参考星数目过少、单张CCD观测参考星分布不均、个别参考星存在位置偏差和局部区域参考星存在系统性位置偏差等不利因素对归算结果的影响 ,进而达到扩大视场和提高归算精度的目的     

Readout Techniques for Drift and Low Frequency Noise Rejection in Infrared Arrays

Three different methods are presented to subtract thermal drifts and low-frequency noise from the signal of infrared array. The first is dead pixels with open Indium bumps, the second is reference output as implemented on the Hawaii2 multiplexer, and the third is dark pixels to emulate reference cells having a capacity connected to the gate of the unit cell field-effect transistor (FET). The third method is the most effective and yields a reduction in readout noise from15.4–9.4 erms. A novel method will be described to extend this readout technique to the Aladdin 1 K × 1 K InSb array. This revised version was published online in July 2006 with corrections to the Cover Date.     

天文(重力)水准的新手段及其计算方法

介绍当今确定天文大地垂偏差的新仪器－CCD自动天体测量仪和确定两点间高程异常差的新方法，该方法用单极坐标代替繁琐的双极坐标进行计算，讨论了天文重力水准的误差及垂线偏差非线性影响等问题，估计在不久的将来，用这一手段施测山区似大地水准面的精度可望达到厘米级。     

Design of a high update-rate star sensor for arcsec-level attitude determination from balloon-borne X/γ astronomy platforms

This paper describes the design of a star sensor based upon a high dynamic range CCD in order to reach an arcsec-level attitude determination in balloon-borne missions. A custom star identification software was developed and laboratory-tested on a prototype assembled using commercial components. A set of numerical simulations have been carried out to study the dependence on the pointing precision of the centroid position accuracy, the number of detected stars and the effect of the image focusing. Moreover, the role of the electronic noise and the discrete pixel structure on the light signals is identified by the analysis of numerical simulations. Laboratory tests confirm that the arcsec pointing accuracy with a 1 Hz update rate can be achieved with our combination of custom-developed software and selected hardware components.     

多传感器观测下带乘性噪声系统的逆向滤波与反褶积融合算法

针对多传感器观测环境下带乘性噪声系统的逆向最优滤波与反褶积融合估计问题 ,本文提出了 1种基于极大似然准则的最优融合算法。该算法中各单传感器间并行计算 ,并且融合中心与单传感器处理中心间无反向通讯 ,因而执行效率较高。仿真表明 ,该融合算法产生的逆向滤波与反褶积比单传感器处理结果有较明显提高