Heat island and oasis effects of vegetative canopies: Micro-meteorological field-measurements

Dry-bulb temperature, dew-point, wind speed, and wind direction were measured in and around an isolated vegetative canopy in Davis CA from 12 to 25 October 1986. These meteorological variables were measured 1.5 m above ground along a transect of 7 weather stations set up across the canopy and the upwind/downwind open fields. These variables were averaged every 15 minutes for a period of two weeks so we could analyze their diurnal cycles as well as their spatial variability. The results indicate significant nocturnal heat islands and daytime oases within the vegetation stand, especially in clear weather. Inside the canopy within 5 m of its upwind edge, daytime temperature fell by as much as 4.5 °C, whereas the nighttime temperature rose by 1 °C. Deeper into the canopy and downwind, the daytime drop in temperature reached 6 °C, and the nighttime increase reached 2 °C. Wind speed was reduced by ~ 2 ms^–1 in mild conditions and by as much as 6.7 ms^–1 during cyclonic weather when open-field wind speed was in the neighborhood of 8 ms^–1. Data from this project were used to construct correlations between temperature and wind speed within the canopy and their corresponding ambient, open-field values.With 10 Figures     

Estimation of aquifer hydraulic parameters from surface geophysical measurements: a case study of the Upper Cretaceous aquifer, central Sinai, Egypt

The integration of geophysical data with direct hydrogeological measurements can provide a minimally invasive approach to characterize the subsurface at a variety of resolutions and over many spatial scales. The field of hydrogeophysics has attracted much attention during the last two decades. In this domain, the geophysical data inverted to geophysical models are interpreted in terms of the hydrogeology to serve as a basis for the definition of hydraulic models in the areas of interest. The hydraulic conductivity (K) value measured in a reference borehole has been combined with the electrical conductivity obtained from nearby geo-electromagnetic sounding data in the Cenomanian (Upper Cretaceous) aquifer, central Sinai, Egypt. The resulting relation was interpreted with Dar Zarrouk parameters to infer the transmissivity variations at other vertical electrical sounding locations, where K values are unknown. Coincident transient electromagnetic data have been adopted to increase accuracy while interpreting the aquifer geoelectrical properties. The results indicate that the transmissivity values in the aquifer of interest vary from 2,446 to 9,694 m²/day, and K varies from 12.9 to 57.0 m/day throughout the studied area.     

An elastoplastic model based on the shakedown concept for flexible pavements unbound granular materials

Nowadays, the problem of rutting of flexible pavements linked to permanent deformations occurring in the unbound layers is taken into account only by mechanistic empirical formulas. Finite element modelling of realistic boundary value problems with incremental rheological models will lead to unrealistic calculation time for large cycle numbers. The objective of the authors is to present a simplified model which can be used to model the flexible pavements rutting with the finite elements framework. This method is based on the shakedown theory developed by Zarka which is usually associated to materials like steels. It has been adapted for granular materials by introducing a yield surface taking into account the mean stress influence on the mechanical behaviour and a dependency of the hardening modulus with the stress state. The Drucker–Prager yield surface has been used with a non‐associated flow rule. Comparisons with repeated load triaxial tests carried out on a subgrade soil have been done. These comparisons underline the capabilities of the model to take into account the cyclic behaviour of unbound materials for roads. Finally, a discussion, dealing with the use of the simplified method within a finite element modelling of a full‐scale experiment, is presented. Copyright © 2005 John Wiley & Sons, Ltd.     

Impact of future climatic changes on high ozone levels in European suburban areas

The gradual increase in temperature is one of the most pronounced trends of climatic changes in the atmosphere. The pollution levels depend essentially on the emissions (both on the human-made emissions and on the biogenic emissions) as well as on the chemical reactions which take place during the transport of pollutants in the atmosphere. Since both the chemical reactions and the biogenic emissions depend on the temperature, it is obvious that the gradual increase of the temperature will have some effect on pollution levels. The impact of climatic changes on high ozone levels, which may have damaging effects on human health, is studied in this paper. Eight European suburban areas were selected. These areas are densely populated and, therefore, increased ozone pollution levels may cause harm to a great number of human beings living there. All experiments indicate that, although the changes of the ozone concentrations are relatively small, some critical levels, which are related to ozone concentrations and which may have damaging effects, will be significantly exceeded as a result of the warming trend in the future climate.     

Nonextensive collisioneless dust-acoustic shock waves in a charge varying dusty plasma

Nonlinear dust-acoustic (DA) shock waves are addressed in a nonextensive dusty plasma exhibiting self-consistent nonadiabatic charge variation. Our results reveal that the amplitude, strength and nature of the DA shock waves are extremely sensitive to the degree of ion nonextensivity. Significant differences in the potential function occur for very small changes in the value of the nonextensive parameter. Stronger is the ions correlation, more important is the charge variation induced nonlinear wave damping.     

Landau damping of dust acoustic waves in the presence of hybrid nonthermal nonextensive electrons

Based on the kinetic theory, Landau damping of dust acoustic waves (DAWs) propagating in a dusty plasma composed of hybrid nonthermal nonextensive distributed electrons, Maxwellian distributed ions and negatively charged dust grains is investigated using Vlasov-Poisson’s equations. The characteristics of the DAWs Landau damping are discussed. It is found that the wave frequency increases by decreasing (increasing) the value of nonextensive (nonthermal) parameter, \(q\) (\(\alpha \)). It is recognized that \(\alpha \) plays a significant role in observing damping or growing DAW oscillations. For small values of \(\alpha \), damping modes have been observed until reaching a certain value of \(\alpha \) at which \(\omega _{i}\) vanishes, then a growing mode appears in the case of superextensive electrons. However, only damping DAW modes are observed in case of subextensive electrons. The present study is useful in the space situations where such distribution exists.     

Electrical and electromagnetic surveys to locate possible causes of water seepage to ground surface at a quarry open pit near Helwan city,Egypt

Water seepage to ground surface at a limestone quarry located at Wadi Garawy about 20 km south-east of Helwan city in Egypt posed a real threat to the mining activity at the quarry. The quarry area is known to be very dry for decades and away from water utilities and infrastructures that may cause water leaks to the quarry. Geophysical investigation including 1D Vertical Electrical Sounding (VES), 2D Electrical Resistivity Tomography (ERT) and 1D Transient Electromagnetic (TEM) surveys were conducted to characterize the rock sequence and locate what could be a possible source of water seepage to the quarry. The resistivity profiles generated from the VES and TEM surveys mapped the rock units in the area down to depths exceeded 100 m. The ERT profiles acquired from the quarrying zone close to the water seepage spot have imaged the top of groundwater level at few meters below the ground surface at the quarry open pit. The spot of groundwater seepage seemed to occur at an area of limestone dissolution that were filled by finer sediments. The finer sediments acted as a hydrological conduit that allowed an upward seepage of groundwater to ground surface under the capillary action effect.     

Composition,radioactivity, and possible applications of kaolin deposits of Sinai,Egypt

This work discusses the composition, radioactivity, and possible utilization of the kaolin resources in Sinai which are hosted in thick sandstone sequences belonging to the Carboniferous (Wadi Khaboba) and Early Cretaceous (Wadi Iseila and Abansakar) ages. The characterization of kaolin was done by microscopic and SEM examination, supported by XRD and ICP-MS analyses. The studied kaolin resources consist of kaolinite, as the main constituent, associated with subsidiary dickite and halloysite, and minor contribution of smectite and illite. The most dominant non-clay mineral is quartz, besides minor gypsum, dolomite, and hematite. Ferrugination dominates, in most cases, at the upper boundaries of the kaolin lenses, suggesting possible supergene activity. The high Al₂O₃/SiO₂ ratio for the Cretaceous kaolin (0.54, in average) specifies its better grade relative to the Carboniferous kaolin (0.43, in average). The kaolin of the middle part of lens C in Wadi Iseila contains Si/Al molecular ratio of about unity, suggesting high-grade kaolin. The Carboniferous kaolin has enriched the radionuclides: U, Th, and Ra (at disequilibrium state due to leaching of eU relative to Ra) and the REE, relative to that of the Cretaceous age. The Carboniferous kaolin is characterized by a higher contribution of HREE (zircon signature), whereas LREE seems to be more influential for the Early Cretaceous kaolin (monazite signature). In spite of the very high CIA index (93 to 99), none of the analyzed kaolin deposits displays Ce abnormality. The high radioactivity of some Carboniferous kaolin can be a serious impediment for its utilization or its exportation. The kaolin of Sinai does not satisfy the international standards for paperwork industries and refractory manufacturing, but beneficiation may overcome this challenge. However, some lenses have high-grade kaolin with a low percentage of oxides of iron, magnesium, calcium, sodium, and potassium and a low radioactivity, hence nominated for the local refractory industry. The high-grade kaolin of Sinai fulfills the standards required for ceramics manufacturing in the global market. Grade 3 kaolin (< 30%, Al₂O₃) can be used in the manufacturing of white Portland cement and red glaze manufacturing on both local and global markets.     

Comparison of direct statistical and indirect statistical-deterministic frameworks in downscaling river low-flow indices

ABSTRACT

This work explores the ability of two methodologies in downscaling hydrological indices characterizing the low flow regime of three salmon rivers in Eastern Canada: Moisie, Romaine and Ouelle. The selected indices describe four aspects of the low flow regime of these rivers: amplitude, frequency, variability and timing. The first methodology (direct downscaling) ascertains a direct link between large-scale atmospheric variables (the predictors) and low flow indices (the predictands). The second (indirect downscaling) involves downscaling precipitation and air temperature (local climate variables) that are introduced into a hydrological model to simulate flows. Synthetic flow time series are subsequently used to calculate the low flow indices. The statistical models used for downscaling low flow hydrological indices and local climate variables are: Sparse Bayesian Learning and Multiple Linear Regression. The results showed that direct downscaling using Sparse Bayesian Learning surpassed the other approaches with respect to goodness of fit and generalization ability.

Editor D. Koutsoyiannis; Associate editor K. Hamed     

Delineation the active subsurface structures at Fayoum-Cairo district, Egypt, using magnetic and magnetotelluric tools

In this work, we present a reconnaissance study to elucidate and delineate subsurface fault structures for an active tectonics area that lies between Cairo and El Fayoum provinces and consider major sources of seismicity in Egypt. Well logging, aeromagnetic, land magnetic, and magnetotelluric data have been used. The well-logging data were used for several drilled wells along W–E direction. The magnetic data were analyzed using trend analysis, 3D magnetic modeling, and Werner deconvolution techniques. The magnetotelluric data were interpreted using 2D (TM–TE) modeling techniques. The results show that there are eight major fault structures having E–W, N–S, and NW–SE directions. These faults extend downward for about 20 km at the Dahshour and Qatrani areas. The epicenter sources of the earthquakes are clustering around the intersections of these structures. The Kattaniya horst structure has been interpreted as a regional structure that exceeds the limits previously determined by geologists. The depth to this horst reaches about 1.8 km at the NW and more than 4.3 km at the southern parts. The interpreted values of magnetic susceptibility at the horst zone indicate that they are ultrabasic/basic intrusion bodies.