Open sea berths for liquid bulk carriers

The transfer of liquid bulk through flexible transfer lines can be accomplished despite relatively large ship motions. For this reason, open sea berth terminals have replaced conventional harbors in many places. The thorough understanding of moored ships dynamics when subjected to waves, wind and currents, combined with the use of flexible dolphins, flexible fenders, asymmetric constant-tension winches and nylon tails permit us to design open sea berth terminals for relatively exposed areas. The design of an integrated system of marine sensors to continuously monitor all the critical elements-ship motion and mooring and fender forces-will enhance the operational procedure whilst insuring safe operations. A berth code can then be established for insuring the maximum efficiency of the terminal on the basis of the measurement of these critical elements.     

An experimental study on non-linear progressive wave-induced dynamic stresses in seabed

In this study, the dynamic stresses within the seabed induced by non-linear progressive waves were explored through a series of hydraulic model tests on a movable bed within a wave flume. By comparing Stokes’ 2nd-order wave theory with the theory of wave-induced dynamic stresses within the seabed as proposed by Yamamoto et al. [1978. On the response of a poro-elastic bed to water waves. Journal of Fluid Mechanics 87 (1), 193–206.] and Hsu and Jeng [1994. Wane-induced soil response in an unsaturated anisotropic seabed of finite thickness. International Journal for Numerical and Analytical Methods in Geomechanics 18, 785–807], the experimental results show that the pressure on the seabed surface, the pore water pressure within the seabed as well as the vertical and the horizontal stresses are all smaller than their theoretical values. If we were to obtain the characteristics of seabed soil, the analytical solution of Hsu and Jeng [1994. Wane-induced soil response in an unsaturated anisotropic seabed of finite thickness. International Journal for Numerical and Analytical Methods in Geomechanics 18, 785–807] might agree to the simulation of the wave-induced effective stresses and shear stress in the sandy seabed. A different phase shift exists among all the three soil stresses. Their influences on the three dynamic stresses within seabed soil are important for seabed stability, and can be used in the verification of numerical models. In the whole, the non-linear progressive waves and the naturally deposited seabed are found to have a strong interaction, and the behavior of the induced dynamic stresses within the seabed is very complicated, and should be investigated integrally.     

An Experi mental Study on Wave-Induced Dynamic Stresses in Seabed

1 .IntroductionEvery year ,Taiwanis subjectedtotwo or three typhoonintrusions in average which always causedisasters . Most of the disasters which occur around the coastal zone are due to seabed instability andcoastal structure destruction caused bytyphoo…     

Estimation of Water Particle Velocities by Empirical Transfer Function

-In previous and this studies it appears that the linear and nonlinear wave theory can notaccurately and easily predict the water particle velocities.Therefore,different from the theoretical consider-ations,in this study we have attempted to determine the transfer function empirically.Laboratory experi-ments were performed under various wave conditions.The empirical formulas of the transfer function ofthe wave height,angular frequency and water particle velocity were obtained on the basis of these test databy dimensional analysis and regression analysis.In intermediate and deep water depth conditions,thetransfer function was only a function of a nondimensional parameter which is composed of the angular fre-quency,the depth of the velocity gauge under the still water level,water depth and the acceleration of grav-ity.Finally,the empirical formulas were compared with experimental data and observational data formpresent and Cavaleri's(1978)studies.The empirical formulas were found to be in sufficient correl     

Estimating the orientation error of the Dahan Downhole Accelerometer using the maximum cross-correlation coefficient between the observed and synthetic waves

A new algorithm to correct the orientation error of the accelerometerat the Dahan Downhole Array, Hualien, Taiwan is developed. This algorithmconsists of three stages: (1) rotating two horizontal ground motions on thefree surface to the SH-SVdirection and SH axis offers a reference direction.(2) computing the synthetic downhole SH waves at a downhole station and (3)searching a rotation angle for downhole observation that yields a best waveformmatch between the synthetic and observed downhole seismograms. At this point, the rotated angle corresponding to the best waveform match can be considered as the orientation error. We selected five earthquakes with good data qualityfor analysis. Results show that this algorithm gives a more stable estimationthan a conventional method because it allows the selection of data from a wider time window for analyses. The estimated orientation error of the accelerometers at the Dahan Downhole Array after the 1999 reinstallation are40°, 114° and 285° at depths of 50, 100 and 200 m, respectively.     

Upper Mississippi embayment shallow seismic velocities measured in situ

Vertical seismic compressional- and shear-wave (P-and S-wave) profiles were collected from three shallow boreholes in sediment of the upper Mississippi embayment. The site of the 60-m hole at Shelby Forest, Tennessee, is on bluffs forming the eastern edge of the Mississippi alluvial plain. The bluffs are composed of Pleistocene loess, Pliocene-Pleistocene alluvial clay and sand deposits, and Tertiary deltaic-marine sediment. The 36-m hole at Marked Tree, Arkansas, and the 27-m hole at Risco, Missouri, are in Holocene Mississippi river floodplain sand, silt, and gravel deposits. At each site, impulsive P- and S-waves were generated by man-made sources at the surface while a three-component geophone was locked downhole at 0.91-m intervals.

Consistent with their very similar geology, the two floodplain locations have nearly identical S-wave velocity (V_S) profiles. The lowest V_S values are about 130 m s⁻¹, and the highest values are about 300 m s⁻¹ at these sites. The shear-wave velocity profile at Shelby Forest is very similar within the Pleistocene loess (12 m thick); in deeper, older material, V_S exceeds 400 m s⁻¹.

At Marked Tree, and at Risco, the compressional-wave velocity (V_P) values above the water table are as low as about 230 m s⁻¹, and rise to about 1.9 km s⁻¹ below the water table. At Shelby Forest, V_P values in the unsaturated loess are as low as 302 m s⁻¹. V_P values below the water table are about 1.8 km s⁻¹. For the two floodplain sites, the V_P/V_S ratio increases rapidly across the water table depth. For the Shelby Forest site, the largest increase in the V_P/V_S ratio occurs at 20-m depth, the boundary between the Pliocene-Pleistocene clay and sand deposits and the Eocene shallow-marine clay and silt deposits.

Until recently, seismic velocity data for the embayment basin came from eartquake studies, crustal-scale seismic refraction and reflection profiles, sonic logs, and from analysis of dispersed earthquake surface waves. Since 1991, seismic data for shallow sediment obtained from reflection, refraction, crosshole and downhole techniques have been obtained for sites at the northern end of the embayment basin. The present borehole data, however, are measured from sites representative of large areas in the Mississippi embayment. Therefore, they fill a gap in information needed for modeling the response of the embayment to destructive seismic shaking.     

Observed Evolution of Linear and Nonlinear Effects at the Dahan Downhole Array,Taiwan: Analysis of the September 21, 1999 M 7.3 Chi-Chi Earthquake Sequence

— In this paper, the site characteristics of the Dahan downhole array are studied by analyzing the September 21, 1999 M 7.3 Chi-Chi earthquake sequence including the main shock and some aftershocks. The four-level array (0 m, 50 m, 100 m and 200 m) is located to the north of Hualien City in eastern Taiwan. Polarization analysis is used to check the orientation errors of the seismometers at different levels of depth. If the surface instrument is chosen as reference, the angle between the major polarization axes of the surface and any downhole records is the orientation error that must be corrected for the downhole accelerographs. The orientation errors at depths of 50 m, 100 m and 200 m are 32°, 120° and –84°. After the corrections, the coherency between the surface and downhole records is substantially improved. Spectral ratio analysis shows that the predominant frequency of the Chi-Chi main shock shifts to a lower frequency. We also simulate ground motions at different depths by using the Haskell method with a linear velocity structure model. The record at surface is chosen as the input motion. Compared with the observed data, ground acceleration can be well reproduced for the aftershocks (weak-motion events) of the September 21, 1999 M 7.3 Chi-Chi earthquake. However, for the Chi-Chi main shock, the synthetic waveform cannot match well with the observation neither in amplitude nor in phase. This indicates that large ground shaking probably induced the nonlinear site effect at that time, and the model used cannot support it.Acknowledgement. The authors would like to express their thanks to Dr. L.F. Bonilla and one anonymous reviewer for their valuable suggestions. This research was supported by the National Science Council under grant number NSC 89-2921-M-194-007. The Institute of Earth Sciences, Academia Sinica supplied the strong-motion data. The support of these organizations is gratefully acknowledged.     

Age and Provenance Areas of Terrigenous Rocks of the Dzhida Terrane: Results of U—Th—Pb (LA-ICP-MS) Geochronological Study of Detrital Zircons

The results of U—Th—Pb (LA-ICP-MS) geochronological studies of detrital zircons from terrigenous rocks of the Dzhida terrane of the Central Asian Fold Belt (CAFB) are presented. The data obtained allow us to distinguish the following age maxima (Ma): 578 and 634 (Vendian); 720, 823, and 919 (Late Riphean); 1922, 2090, 2225, and 2321 (Early Proterozoic). A number of zircons have Late Archean age in the interval of 2670–2980 Ma. Taking into account Late Cambrian age (504–506 Ma) of intrusive rocks that intruded the Dzhida terrane, a possible sedimentation period of sequences of this terrane is estimated to be in the interval of 580–510 Ma (from Vendian to Late Cambrian). The possible provenance areas of terrigenous sediments are proposed and the previously proposed models of geodynamic evolution of the Dzhida terrane are correlated with new geochronological data.     

海产鱼类中异尖线虫酶消化检测技术的研究与应用

以3种海鱼(牙鲆、狭鳕、鲱鱼)为样本,针对海产品中主要的致病性寄生虫-异尖线虫,开展了酶消化检测技术的研究.根据鱼肉消化前后干物质的质量变化设计了胃蛋白酶消化效率的计算方法,并按照鱼肉:消化液＝1:10 (g/mL)的反应比例,分别确定了酶水解鱼肉的最佳条件为:初始pH值为1.1,温度为37 ℃,酶活力为8 U/mL左右;消化后所得的虫体采用多重PCR方法替代传统的形态学观察进行种属鉴定,从而初步建立了基于酶水解-多重PCR的异尖线虫的酶消化检测体系.实际样本检测表明,该技术可以较为准确、快速地用于海产鱼类中简单异尖线虫(Anisakis simplex)和伪地新线虫(Pseudoterranova decipiens)的确证性检测.