Annual variation of methane in seawater in Funka bay,Japan

The concentration of methane in seawater was determined approximately once a month for one year from August 1990 to July 1991 at a station close to the center of Funka bay (92 m depth) and some supplementary observations were also carried out. The concentration of methane was usually increased with increasing depth, suggesting that methane was emitted from the bottom of the bay. While highly variable both spatially and temporally, the emission was intense in March and April, a period immediately after the spring bloom of phytoplankton. The maximum of methane found in the intermediate water suggests its source from the slope of the bay. The concentration of methane in the surface water changed seasonally and also interannually. The annually averaged flux of methane transferred to the atmosphere in the bay was estimated to be 6×10^–3 gCH₄m²/day. The coastal zone in the world may be a significant source of the atmospheric methane, although its source strength has yet to be accurately estimated from more data in different coastal seas.     

Vertical mixing in the bottom mixed layer near the continental shelf break in the East China Sea

The strength of the vertical mixing in the bottom mixed layer near the continental shelf break in the East China Sea was directly measured with the Micro-Scale Profiler (MSP). It has been shown that there is no significant statistical relation between the turbulent energy dissipation and the degree of the stratificationN ². It seems that the vigorous turbulence occurs not constantly but intermittently in the bottom mixed layer so that a large variation of is found depending on the time. In contrast to , the coefficient of the vertical eddy diffusivityK _z is mostly determined byN such thatK _z is large in the bottom mixed layer and small in the thermocline. Large value ofK _z in the bottom mixed layer is also found in the time series ofK _z estimated in terms of Richardson number calculated from the data obtained with electromagnetic current meters. The value ofK _z more than 10 cm²s^–1 frequently occur in the layer of 20–25 m thick just above the bottom.     

Influence of Mesoscale Eddies on Variations of the Kuroshio Path South of Japan

The influences of mesoscale eddies on variations of the Kuroshio path south of Japan have been investigated using time series of the Kuroshio axis location and altimeter-derived sea surface height maps for a period of seven years from 1993 to 1999, when the Kuroshio followed its non-large meander path. It was found that both the cyclonic and anticyclonic eddies may interact with the Kuroshio and trigger short-term meanders of the Kuroshio path, although not all eddies that approached or collided with the Kuroshio formed meanders. An anticyclonic eddy that revolves clockwise in a region south of Shikoku and Cape Shionomisaki with a period of about 5–6 months was found to propagate westward along about 30°N and collide with the Kuroshio in the east of Kyushu or south of Shikoku. This collision sometimes triggers meanders which propagate over the whole region south of Japan. The eddy was advected downstream, generating a meander on the downstream side to the east of Cape Shionomisaki. After the eddy passed Cape Shionomisaki, it detached from the Kuroshio and started to move westward again. Sometimes the eddy merges with other anticyclonic eddies traveling from the east. Coalescence of cyclonic eddies, which are also generated in the Kuroshio Extension region and propagate westward in the Kuroshio recirculation region south of Japan, into the Kuroshio in the east of Kyushu, also triggers meanders which mainly propagate only in a region west of Cape Shionomisaki. This revised version was published online in July 2006 with corrections to the Cover Date.     

Seasonal and interannual variations in the East Sakhalin current revealed by TOPEX/POSEIDON altimeter data

Seasonal and interannual variations in the East Sakhalin Current (ESC) are investigated using ten-year records of the sea level anomaly (SLA) observed by the TOPEX/POSEIDON (T/P) altimeter. The T/P SLA clearly documents seasonal and interannual variations in the ESC along the east coast of Sakhalin Island, although sea ice masks the region from January to April. Estimates of surface current velocity anomaly derived from T/P SLA are in good agreement with drifting buoy observations. The ESC is strong in winter, with a typical current velocity of 30–40 cm s⁻¹ in December, and almost disappears in summer. Southward flow of the ESC is confined to the shelf and slope region and consists of two velocity cores. These features of the ESC are consistent with short-term observations reported in previous studies. Analysis of the ten-year records of T/P SLA confirms that the structure of the ESC is maintained each winter and the seasonal cycle is repeated every year, although the strength of the ESC shows large interannual variations. Seasonal and interannual variations in the ESC are discussed in relation to wind-driven circulation in the Sea of Okhotsk, using wind stress and wind stress curl fields derived from European Centre for Medium Range Weather Forecasts (ECMWF) reanalysis data and a scatterometer-derived wind product. Seasonal and interannual variations of the anticyclonic eddy in the Kuril Basin are also revealed using T/P SLA.     

A laboratory experiment to monitor the contact state of a fault by transmission waves

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.     

Hybrid vibration experiments with a bridge foundation system model

In order to improve seismic design technology of bridges, it is necessary to evaluate the vibration characteristics of a bridge–soil system that consists of soil, foundation structure, pier and superstructure. However, there have been few experimental studies on seismic behavior of bridge–soil system. In this paper, we conducted the hybrid vibration experiment on seismic behavior of bridge–soil system, and examined the applicability of hybrid vibration experiment to study seismic response of bridge–soil system. Based on the experiment results, seismic response of bridge was quantitatively studied.     

Interactive behavior of soil–pile-superstructure system in transient state to liquefaction by means of large shake table tests

Shaking table tests were conducted by means of a large-scale laminar box with 4 m in length, 2 m in width and 2 m in height in order to investigate behavior of a soil-pile-superstructure system in liquefiable ground. A model two-storey structure, supported by a pile group, was set in a saturated sand deposit, and subjected to a sinusoidal base motion with increasing amplitude. Discussions are focused on the transient behavior until soil liquefaction occurs. Main interests are characteristics of springs used in a sway-rocking model and a multi-freedom lumped mass (MFLM) model that are frequently used in soil–pile interaction analysis. The spring constant in the sway-rocking model is represented by restoring force characteristics at the pile head, and that in the MFLM system is represented by an interaction spring connecting the pile to the free field. The transient state prior to soil liquefaction is shown to be important in the design of a pile because dynamic earth pressure shows peak response in this state. The reduction of the stiffness due to excess porewater generation and strain dependent nonlinear behavior is evaluated.     

Small inflation sources producing seismic and infrasonic pulses during the 2000 eruptions of Miyake-jima, Japan

During the 2000 activity of Miyake-jima volcano, Japan, we detected long period seismic signals with initial pulse widths of 1-2 s, accompanied by infrasonic pulses with almost the same pulse widths. The seismic signals were observed from 13 July 2000, a day before the second summit eruption. The occurrences of the seismic signals were intermittent with a gradual increase in their magnitudes and numbers building toward a significant explosive eruption on 18 August. After the eruption, the seismic and infrasonic events ceased. The results of a waveform inversion show that the initial motions were excited by an isotropic inflation source beneath the south edge of the caldera at a depth of 1.4 km. On the other hand, the sources of the infrasonic pulses were located in the summit caldera area. The times at which the infrasonic pulses were emitted at the surface were delayed by about 3 s from the origin times of the seismic events. It is suggested that small isotropic inflations excited seismic waves in the crust and simultaneously caused acoustic waves that traveled in the conduit and produced infrasonic pulses at the crater bottom. Considering the observed time differences and gas temperatures emitted from the vent, the conduit should have been filled with vapor mixed with SO₂ gas and volcanic ash. The change of the time differences between the seismic and infrasonic signals suggests that the seismic source became shallower within half a day before the August 18 explosive eruption. We interpret the source process as a fragmentation process of magma in which gas bubbles burst and quickly released part of the pressure that had been sustained by the tensional strength of magma.     

Diamond in metasedimentary crustal rocks from Pohorje,Eastern Alps: a window to deep continental subduction

We report the first finding of diamond and moissanite in metasedimentary crustal rocks of Pohorje Mountains (Slovenia) in the Austroalpine ultrahigh‐pressure (UHP) metamorphic terrane of the Eastern Alps. Microscopic observations and Raman spectroscopy show that diamond occurs in situ as inclusions in garnet, being heterogeneously distributed. Under the optical microscope, diamond‐bearing inclusions are of cuboidal to rounded shape and of pinkish, yellow to brownish colour. The Raman spectra of the investigated diamond show a sharp, first order peak of sp³‐bonded carbon, in most cases centred between 1332 and 1330 cm^?1, with a full width at half maximum between 3 and 5 cm^?1. Several spectra show Raman bands typical for disordered graphitic (sp²‐bonded) carbon. Detailed observations show that diamond occurs either as a monomineralic, single‐crystal inclusion or it is associated with SiC (moissanite), CO₂ and CH₄ in polyphase inclusions_. This rare record of diamond occurring with moissanite as fluid‐inclusion daughter minerals implies the crystallization of diamond and moissanite from a supercritical fluid at reducing conditions. Thermodynamic modelling suggests that diamond‐bearing gneisses attained P–T conditions of ≥3.5 GPa and 800–850 °C, similar to eclogites and garnet peridotites. We argue that diamond formed when carbonaceous sediment underwent UHP metamorphism at mantle depth exceeding 100 km during continental subduction in the Late Cretaceous (c. 95–92 Ma). The finding of diamond confirms UHP metamorphism in the Pohorje Mountains, the most deeply subducted part of Austroalpine units.