Beaver dam analogues drive heterogeneous groundwater–surface water interactions

Beaver dam analogues (BDAs) are a cost-effective stream restoration approach that leverages the recognized environmental benefits of natural beaver dams on channel stability and local hydrology. Although natural beaver dams are known to exert considerable influence on the hydrologic conditions of a stream system by mediating geomorphic processes, nutrient cycling, and groundwater–surface water interactions, the impacts of beaver-derived restoration methods on groundwater–surface water exchange are poorly characterized. To address this deficit, we monitored hyporheic exchange fluxes and streambed porewater biogeochemistry across a sequence of BDAs installed along a central Wyoming stream during the summer of 2019. Streambed fluxes were quantified by heat tracing methods and vertical hydraulic gradients. Biogeochemical activity was evaluated using major ion porewater chemistry and principal component analysis. Vertical fluxes of approximately 1.0 m/day were observed around the BDAs, as was the development of spatially heterogeneous zones of nitrate production, groundwater upwelling, and anaerobic reduction. Strong contrasts in hyporheic zone processes were observed across BDAs of differing sizes. This suggests that structures may function with size-dependent behaviour, only altering groundwater–surface water interactions after a threshold hydraulic step height is exceeded. Patterns of hyporheic exchange and biogeochemical cycling around the studied BDAs resemble those around natural beaver dams, suggesting that BDAs may provide comparable benefits to channel complexity and near-stream function over a 1-year period.     

Local ice caps in Finderup Land,North Greenland,survived the Holocene Thermal Maximum

Local glaciers and ice caps (GICs) comprise only ~5.4% of the total ice volume, but account for ~14–20% of the current ice loss in Greenland. The glacial history of GICs is not well constrained, however, and little is known about how they reacted to Holocene climate changes. Specifically, in North Greenland, there is limited knowledge about past GIC fluctuations and whether they survived the Holocene Thermal Maximum (HTM, ~8 to 5 ka). In this study, we use proglacial lake records to constrain the ice‐marginal fluctuations of three local ice caps in North Greenland including Flade Isblink, the largest ice cap in Greenland. Additionally, we have radiocarbon dated reworked marine molluscs in Little Ice Age (LIA) moraines adjacent to the Flade Isblink, which reveal when the ice cap was smaller than present. We found that outlet glaciers from Flade Isblink retreated inland of their present extent from ~9.4 to 0.2 cal. ka BP. The proglacial lake records, however, demonstrate that the lakes continued to receive glacial meltwater throughout the entire Holocene. This implies that GICs in Finderup Land survived the HTM. Our results are consistent with other observations from North Greenland but differ from locations in southern Greenland where all records show that the local ice caps at low and intermediate elevations disappeared completely during the HTM. We explain the north–south gradient in glacier response as a result of sensitivity to increased temperature and precipitation. While the increased temperatures during the HTM led to a complete melting of GICs in southern Greenland, GICs remained in North Greenland probably because the melting was counterbalanced by increased precipitation due to a reduction in Arctic sea‐ice extent and/or increased poleward moisture transport.     

Remote sensing of Mercury's magnetospheric plasma environment via energetic neutral atoms imaging

The potentiality of exploring the plasma dynamical behavior of Mercury via energetic neutral atom (ENA) analysis is briefly discussed. The analysis of the Hermean ENA would give clues to the global magnetospheric configuration, clarifying crucial issues like the existence of radiation belts. In order to demonstrate the feasibility of ENA imaging in the Hermean environment, an empirical model of the equatorial proton distributions, originally developed for the Earth's magnetosphere, is here modified in order to be applicable to the expected conditions, according to the present knowledge of the planet. Simulations of the ENA radiation are then presented and discussed. It is shown that the simulated radiation is significantly high, especially when pointing the field of view towards the Hermean surface. The way of determining the proton flux distributions and the cross-tail electric field characteristics by using the ENA signal is discussed. Finally, a preliminary design of an ENA detector suitable for the ESA mission to Mercury ‘BepiColombo’ is proposed and discussed.     

Diagenesis, palaeoclimate and tectono-sedimentary influences on clay mineralogy and stable isotopes from Upper Cretaceous marine successions of the Basque-Cantabrian Basin (N Spain)

Clay mineralogy and whole-rock stable isotopes (δ¹⁸O and δ¹³C) of Upper Cretaceous marly sediments on the Basque-Cantabrian Basin have been integrated to determine the main effects of diagenesis, palaeoclimate and tectono-sedimentary factors in sections belonging to deep- (Barrika) and platform-marine (Isla de Castro, Villamartín and Olazagutía) settings.The mean values for the clay assemblages and δ¹⁸O exhibit notable differences among the sections, partially explainable by the influence of diagenesis. The Barrika sediments, with more diagenetically advanced illite-smectite (I-S) mixed-layer (R1, 70% illite), authigenic chlorite, and low δ¹⁸O (−4.05‰ PDB), experienced higher diagenetic grade than Isla de Castro and Olazagutía, which have R0 I-S (20% illite) and heavier δ¹⁸O. Villamartín was also affected by higher diagenesis than Isla de Castro and Olazagutía, given the occurrence of R1 I-S (60% illite) and low δ¹⁸O (−4.11‰ PDB). However, the absence of other clays in Villamartín (e.g. authigenic chlorite) is indicative of less diagenetic grade than Barrika. These results show the useful integration of clay mineralogy and stable isotopes to detect different diagenetic grades in distinct marine successions of the same basin.Despite being influenced by diagenesis, the clay mineralogy partially preserves its inherited signature. This allows detection of major contents of I-S and mica, and minor kaolinite, interpreted as indicative of warm palaeoclimatic conditions. High kaolinite content in Villamartín and absence of kaolinite in Isla de Castro, though, are considered to be a product of neither diagenesis nor palaeoclimatic influences. Instead, tectono-sedimentary causes, related to unsuitable conditions for clay formation and transport from the local source areas, contributed to original clay differences. The inferred effects of diagenesis, palaeoclimate and tectono-sedimentary factors make this work important to show the potentially great variety of controls on the clay mineralogy of marine sections, which are often uncritically treated in studies concerning the Late Cretaceous.     

Seal integrity and feasibility of CO<Subscript>2</Subscript> sequestration in the Teapot Dome EOR pilot: geomechanical site characterization

This paper reports a preliminary investigation of CO₂ sequestration and seal integrity at Teapot Dome oil field, Wyoming, USA, with the objective of predicting the potential risk of CO₂ leakage along reservoir-bounding faults. CO₂ injection into reservoirs creates anomalously high pore pressure at the top of the reservoir that could potentially hydraulically fracture the caprock or trigger slip on reservoir-bounding faults. The Tensleep Formation, a Pennsylvanian age eolian sandstone is evaluated as the target horizon for a pilot CO₂ EOR-carbon storage experiment, in a three-way closure trap against a bounding fault, termed the S1 fault. A preliminary geomechanical model of the Tensleep Formation has been developed to evaluate the potential for CO₂ injection inducing slip on the S1 fault and thus threatening seal integrity. Uncertainties in the stress tensor and fault geometry have been incorporated into the analysis using Monte Carlo simulation. The authors find that even the most pessimistic risk scenario would require ∼10 MPa of excess pressure to cause the S1 fault to reactivate and provide a potential leakage pathway. This would correspond to a CO₂ column height of ∼1,500 m, whereas the structural closure of the Tensleep Formation in the pilot injection area does not exceed 100 m. It is therefore apparent that CO₂ injection is not likely to compromise the S1 fault stability. Better constraint of the least principal stress is needed to establish a more reliable estimate of the maximum reservoir pressure required to hydrofracture the caprock.     

Experimental investigation of the effects of temperature and ionic strength on Mo isotope fractionation during adsorption to manganese oxides

The Mo stable isotope system is being applied to study changes in ocean redox. Such applications implicitly assume that Mo isotope fractionation in aqueous systems is relatively insensitive to frequently changing environmental variables such as temperature (T) and ionic strength (I). A major driver of fractionation is the adsorption of Mo to Mn oxyhydroxide surfaces [Barling J. and Anbar A. D. (2004) Molybdenum isotope fractionation during adsorption by manganese oxides. Earth Planet. Sci. Lett.217(3-4), 315-329]. Here, we report the results of experiments that determine the extent to which Mo isotope fractionation during adsorption of Mo to the Mn oxyhydroxide mineral birnessite is sensitive to T and I. The results are compared to new predictions from quantum chemical computations. We measured fractionation from 1 to 50 °C at I = 0.1 m and found that Δ^97/95Mo_{dissolved-adsorbed} varies from 1.9‰ to 1.6‰ over this temperature range. Experiments were also performed at 25 °C in synthetic seawater (I = 0.7); fractionation at this condition was the same within analytical error as in low ionic strength experiments. These findings confirm that the Mo isotope fractionation during adsorption to Mn oxyhydroxides is relatively insensitive to variations and T and I over environmentally relevant ranges. To relate these findings to potential mechanisms of Mo isotope fractionation, we also report results for density functional theory computations of the fractionation between and various possible structures of molybdic acid as a function of temperature. Because no plausible species fractionates from with a magnitude matching the experiments, we are left with three possibilities to explain the fractionation: (1) solvation effects on the vibrational frequencies of aqueous species considered thus far are significant, such that our calculations in vacuo yield inaccurate fractionations; (2) a trace aqueous species not yet considered fractionates from and then adsorbs to birnessite; or (3) a surface complex not present in solution forms on birnessite in which Mo is not tetrahedrally coordinated. Our findings help validate assumptions underlying paleoceanographic applications of the Mo isotope system and also lead us closer to understanding the mechanism of isotope fractionation during adsorption of Mo to Mn oxyhydroxides.     

Origins of high pH mineral waters from ultramafic rocks, Central Portugal

This paper reviews the geochemical, isotopic (²H, ¹⁸O, ¹³C, ³H and ¹⁴C) and numerical modelling approaches to evaluate possible geological sources of the high pH (11.5)/Na–Cl/Ca–OH mineral waters from the Cabeço de Vide region (Central-Portugal). Water–rock interaction studies have greatly contributed to a conceptual hydrogeological circulation model of the Cabeço de Vide mineral waters, which was corroborated by numerical modelling approaches. The local shallow groundwaters belong to the Mg–HCO₃ type, and are derived by interaction with the local serpentinized rocks. At depth, these type waters evolve into the high pH/Na–Cl/Ca–OH mineral waters of Cabeço de Vide spas, issuing from the intrusive contact between mafic/ultramafic rocks and an older carbonate sequence. The Cabeço de Vide mineral waters are supersaturated with respect to serpentine indicating that they may cause serpentinization. Magnesium silicate phases (brucite and serpentine) seem to control Mg concentrations in Cabeço de Vide mineral waters. Similar δ²H and δ¹⁸O suggest a common meteoric origin and that the Mg–HCO₃ type waters have evolved towards Cabeço de Vide mineral waters. The reaction path simulations show that the progressive evolution of the Ca–HCO₃ to Mg–HCO₃ waters can be attributed to the interaction of meteoric waters with serpentinites. The sequential dissolution at CO₂ (g) closed system conditions leads to the precipitation of calcite, magnesite, amorphous silica, chrysotile and brucite, indicating that the waters would be responsible for the serpentinization of fresh ultramafic rocks (dunites) present at depth. The apparent age of Cabeço de Vide mineral waters was determined as 2790 ± 40 a BP, on the basis of ¹⁴C and ¹³C values, which is in agreement with the ³H concentrations being below the detection limit.     

Methodology for preliminary assessment of Natech risk in urban areas

Concern for natural hazard-triggered technological disasters (Natech disasters) in densely populated and industrialized areas is growing. Residents living in urban areas subject to high natural hazard risk are often unaware of the potential for secondary disasters such as hazardous materials releases from neighboring industrial facilities, chemical storage warehouses or other establishments housing hazardous materials. Lessons from previous disasters, such as the Natech disaster during the Kocaeli earthquake in Turkey in 1999 call for the need to manage low frequency/high consequence events, particularly in today’s densely populated areas. However, there is little guidance available on how local governments and communities can assess Natech risk. To add to the problem, local governments often do not have the human or economic resources or expertise to carry out detailed risk assessments. In this article, we propose a methodology for preliminary assessment of Natech risk in urban areas. The proposed methodology is intended for use by local government officials in consultation with the public. The methodology considers possible interactions between the various systems in the urban environment: the physical infrastructure (e.g., industrial plants, lifeline systems, critical facilities), the community (e.g., population exposed), the natural environment (e.g., delicate ecosystems, river basins), and the risk and emergency management systems (e.g., structural and nonstructural measures). Factors related to vulnerability and hazard are analyzed and qualitative measures are recommended. Data from hazardous materials releases during the Kocaeli, Turkey earthquake of August 17, 1999 are used as a case study to demonstrate the applicability of the methodology. Limitations of the proposed methodology are discussed as well as future research needs.