Thermal history of the unsaturated zone at Yucca Mountain,Nevada, USA

Secondary calcite, silica and minor amounts of fluorite deposited in fractures and cavities record the chemistry, temperatures, and timing of past fluid movement in the unsaturated zone at Yucca Mountain, Nevada, the proposed site of a high-level radioactive waste repository. The distribution and geochemistry of these deposits are consistent with low-temperature precipitation from meteoric waters that infiltrated at the surface and percolated down through the unsaturated zone. However, the discovery of fluid inclusions in calcite with homogenization temperatures (T_h) up to ∼80 °C was construed by some scientists as strong evidence for hydrothermal deposition. This paper reports the results of investigations to test the hypothesis of hydrothermal deposition and to determine the temperature and timing of secondary mineral deposition. Mineral precipitation temperatures in the unsaturated zone are estimated from calcite- and fluorite-hosted fluid inclusions and calcite δ¹⁸O values, and depositional timing is constrained by the ²⁰⁷Pb/²³⁵U ages of chalcedony or opal in the deposits. Fluid inclusion T_h from 50 samples of calcite and four samples of fluorite range from ∼35 to ∼90 °C. Calcite δ¹⁸O values range from ∼0 to ∼22‰ (SMOW) but most fall between 12 and 20‰. The highest T_h and the lowest δ¹⁸O values are found in the older calcite. Calcite T_h and δ¹⁸O values indicate that most calcite precipitated from water with δ¹⁸O values between −13 and −7‰, similar to modern meteoric waters.     

Groundwater control of mangrove surface elevation: Shrink and swell varies with soil depth

We measured monthly soil surface elevation change and determined its relationship to groundwater changes at a mangrove forest site along Shark River, Everglades National Park, Florida. We combined the use of an original design, surface elevation table with new rod-surface elevation tables to separately track changes in the mid zone (0–4 m), the shallow root zone (0–0.35 m), and the full sediment profile (0–6 m) in response to site hydrology (daily river stage and daily groundwater piezometric pressure). We calculated expansion and contraction for each of the four constituent soil zones (surface [accretion and erosion; above 0 m], shallow zone [0–0.35 m], middle zone [0.35–4 m], and bottom zone [4–6]) that comprise the entire soil column. Changes in groundwater pressure correlated strongly, with changes in soil elevation for the entire profile (Adjusted R² = 0.90); this relationship was not proportional to the depth of the soil profile sampled. The change in thickness of the bottom soil zone accounted for the majority (R² = 0.63) of the entire soil profile expansion and contraction. The influence of hydrology on specific soil zones and absolute elevation change must be considered when evaluating the effect of disturbances, sea level rise, and water management decisions on coastal wetland systems.     

Experimental characterization of the impact of temperature and humidity on the breakdown of soil water repellency in sandy soils and composts

Soil water repellency is a widespread phenomenon with the capacity to alter hydrological and geomorphological processes. Water repellency decays with time, and the consequences are only of concern during the timescale at which the water repellency persists. This study aimed to characterize the influence of temperature and humidity on the breakdown of water repellency. Apparent contact angle measurements were carried out on samples consisting of sand treated with stearic acid as well as naturally repellent dune sands and composts. Temperature and humidity were controlled using a cooled incubator and a purpose designed enclosed box in which humidity could be raised or lowered. Results showed the contact angle of the stearic‐acid‐treated sands decayed with time and that there was a significant increase with stearic acid concentration. For all samples, the decay in apparent contact angle could be described with a continuous breakdown model. The stearic‐acid‐treated sands showed a significant increase in contact angle with relative humidity at a temperature of 10 and 20 °C. These differences diminished with increasing temperature. Similar results were seen for the dune sands and composts. Despite the influence of temperature and humidity on contact angles, there was no significant change in the rate at which the contact angle decayed in any sample. Absolute humidity was found to provide a more relevant indicator than relative humidity when assessing the influence of humidity on repellency over a range of temperatures. The contact angle initially increased with absolute humidity before plateauing owing to the confounding effect of temperature. Copyright © 2014 John Wiley & Sons, Ltd.     

New evidence on the hydrothermal system in Long Valley caldera, California, from wells, fluid sampling, electrical geophysics, and age determinations of hot-spring deposits

Data collected since 1985 from test drilling, fluid sampling, and geologic and geophysical investigations provide a clearer definition of the hydrothermal system in Long Valley caldera than was previously available. This information confirms the existence of high-temperature (> 200°C) reservoirs within the volcanic fill in parts of the west moat. These reservoirs contain fluids which are chemically similar to thermal fluids encountered in the central and eastern parts of the caldera. The roots of the present-day hydrothermal system (the source reservoir, principal zones of upflow, and the magmatic heat source) most likely occur within metamorphic basement rocks beneath the western part of the caldera. Geothermometer-temperature estimates for the source reservoir range from 214 to 248°C. Zones of upflow of hot water could exist beneath the plateau of moat rhyolite located west of the resurgent dome or beneath Mammoth Mountain. Lateral flow of thermal water away from such upflow zones through reservoirs in the Bishop Tuff and early rhyolite accounts for temperature reversals encountered in most existing wells. Dating of hot-spring deposits from active and inactive thermal areas confirms previous interpretations of the evolution of hydrothermal activity that suggest two periods of extensive hot-spring discharge, one peaking about 300 ka and another extending from about 40 ka to the present. The onset of hydrothermal activity around 40 ka coincides with the initiation of rhyolitic volcanism along the Mono-Inyo Craters volcanic chain that extends beneath the caldera's west moat.     

Partitioning of manganese,iron, copper,zinc, lead,cobalt, and nickel in black coatings on stream boulders in the vicinity of the Magruder mine,Lincoln Co., Georgia

Sequential digestions of Fe-Mn oxide coated boulders collected upstream and downstream from the Magruder mine, Lincoln Co., Georgia, indicate probable partitioning relationships for Zn, Cu, Pb, Co, and Ni with respect to Mn and Fe. Initial digestion with 0.1M hydroxylamine hydrochloride (Hxl) in 0.01M HNO₃ selectively dissolyes Mn oxides, whereas subsequent digestion with 1:4 HCl dissolves remaining Fe oxides.The results indicate that partitioning is not constant, but varies systematically with respect to the location of metal-rich waters derived from sulfide mineralization. Upstream from the mineralized zone Zn and Ni are distinctly partitioned to the Fe oxide component and Co and Cu are partitioned to the Mn oxide component. Immediately downstream from the mineralized zone, Mn oxides become relatively more enriched in Zn, whereas Fe oxides are relatively more enriched in Cu, Co, and Ni. Analytical precision for Pb is poor, but available data suggests it is more closely associated with Fe oxides.For routine geochemical surveys utilizing coated surfaces, a one-step digestion method is probably adequate. Parameters useful for detecting sulfide mineralization are metal concentrations normalized to surface area or various ratios (e.g. Zn/(Mn + Fe), Cu/Mn, Pb/Fe). Ratios can be obtained much faster, and at lower analytical costs than conventional analysis of stream sediment.     

Biofouling confounds the uptake of trace organic contaminants by semi-permeable membrane devices (SPMDs)

The outer layers of layflat, low density polyethylene plastic tubing (the principal component of semi-permeable membrane devices, SPMDs) were biofouled at a clean site in Hong Kong coastal waters for periods of 1–4 weeks. Following pre-fouling, triolein was added to the SPMDs and, along with control (unfouled) devices, they were exposed to a range of organochlorine pesticides (-HCH, aldrin, p,p^′-DDT) and PAHs (anthracene, fluoranthene and benzo(a)pyrene) under laboratory conditions. Results showed that the uptake of contaminants by SPMDs was severely reduced by as much as 50% under fouling conditions in comparison to unfouled controls. The ultimate utility of SPMDs as passive monitors is thus reduced, although alternative measures, such as the use of permeability reference compounds may compensate, and allow for realistic evaluations of dissolved environmental concentrations in aquatic environments. However, due to the complexities involved in such procedures––especially as they need to be conducted on a case-by-case basis––the utility of SPMDs appears to be limited for estimates of bioavailability unless necessary calibrations are undertaken within each environment that the sampler is used.     

Comparison of 15 evaporation methods applied to a small mountain lake in the northeastern USA

Few detailed evaporation studies exist for small lakes or reservoirs in mountainous settings. A detailed evaporation study was conducted at Mirror Lake, a 0.15 km² lake in New Hampshire, northeastern USA, as part of a long-term investigation of lake hydrology. Evaporation was determined using 14 alternate evaporation methods during six open-water seasons and compared with values from the Bowen-ratio energy-budget (BREB) method, considered the standard. Values from the Priestley–Taylor, deBruin–Keijman, and Penman methods compared most favorably with BREB-determined values. Differences from BREB values averaged 0.19, 0.27, and 0.20 mm d⁻¹, respectively, and results were within 20% of BREB values during more than 90% of the 37 monthly comparison periods. All three methods require measurement of net radiation, air temperature, change in heat stored in the lake, and vapor pressure, making them relatively data intensive. Several of the methods had substantial bias when compared with BREB values and were subsequently modified to eliminate bias. Methods that rely only on measurement of air temperature, or air temperature and solar radiation, were relatively cost-effective options for measuring evaporation at this small New England lake, outperforming some methods that require measurement of a greater number of variables. It is likely that the atmosphere above Mirror Lake was affected by occasional formation of separation eddies on the lee side of nearby high terrain, although those influences do not appear to be significant to measured evaporation from the lake when averaged over monthly periods.     

Long-term chemical effects of petroleum in south Louisiana wetlands—I. Organic carbon in sediments and waters

The chemical effects of chronic petroleum input into a shallow water marsh were examined by measuring hydrocarbon levels and dissolved organic carbon content of sediments associated with two active oil fields in south Louisiana. Annual levels of total organic carbon in the surface waters of the oil fields were higher by 1 mg C/l. in the salt marsh and 5 mg C/l. in the fresh marsh than the respective controlsites. Average dissolved organic carbon concentrations in the interstitial waters of cores taken within the oil field environments were 105% higher than the control in the salt marsh and 43% higher than the control in the fresh marsh. Significantly lower ratios of C₁₇ to pristane occurred in both oil field sediments; however, average odd-even predominance values were not indicative of petroleum contaminated sediments. The results indicate that microbial processes are responsible for dissolution of petroleum into dissolved organic carbon and that dissolved organic carbon concentrations may be a more significant measure of chronic petroleum input than hydrocarbon distribution.