A seismic source zone model for the seismic hazard assessment of the Italian territory

We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.

We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.

The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.

ZS9 is made out of 36 zones where earthquakes with M_w > = 5 are expected. It also assumes that earthquakes with M_w up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.

Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates.     

Leaching mechanisms of oxyanionic metalloid and metal species in alkaline solid wastes: A review

An overview is presented on possible mechanisms that control the leaching behaviour of the oxyanion forming elements As, Cr, Mo, Sb, Se, V and W in cementituous systems and alkaline solid wastes, such as municipal solid waste incinerator bottom ash, fly ash and air pollution control residues, coal fly ash and metallurgical slags. Although the leachability of these elements generally depends on their redox state, speciation measurements are not common. Therefore, experimental observations available in the literature are combined with a summary of the thermal behaviour of these elements to assess possible redox states in freshly produced alkaline wastes, given their origin at high temperature. Possible redox reactions occurring at room temperature, on the other hand, are reviewed because these may alter the initial redox state in alkaline wastes and their leachates. In many cases, precipitation of oxyanions as a pure metalate cannot provide a satisfactory explanation for their leaching behaviour. It is therefore highly likely that adsorption and solid solution formation with common minerals in alkaline waste and cement reduce the leachate concentration of oxyanions below pure-phase solubility.     

Contribution of the SISCam Web-based GIS to the seismotectonic study of Campania (Southern Apennines): an example of application to the Sannio-area

In this article the implementation and potential of the Seismotectonic Information System of the Campania Region (SISCam) are described, in particular an application of this Web-based GIS system to the seismotectonic analysis of the Sannio area (Southern Apennines) is performed. WEB-GIS technologies greatly contribute to both the environmental monitoring and the disaster management of areas affected by high natural risks. Specifically the SISCam system has been developed with the aim of providing easy access and fast diffusion, through Internet technology, of the most significant geological, geophysical, and territorial data relative to the Campania Region. The Sannio area has been selected as our application example because it is among the most active seismic regions in Italy. This portion of the Southern Apennines which was hit by the June 5, 1688 strong earthquake (M _W = 6.7, CPTI 1999) and by some low- and moderate-energy seismic sequences (1990–1992, 1997), is characterized by a complex inherited tectonic setting and low-tectonic deformation rates that hide the seismogenic sources position. Since this case study turned out to be complicated, the use of the SIScam WEB-GIS has become indispensable because it allowed us to visualize, integrate and analyze all the data available, in order to obtain an accurate and direct picture of the seismotectonic setting of the area. Moreover, a different approach of data analysis was necessary, due to the lack of up-to-date neotectonic and structural data; therefore, the operation of this GIS system enabled us to process and generate some original informative layers, through image analysis, such as new structural lineaments represented on a map of the potential active faults of the area, which has been the final result of our application, as a contribution to new knowledge about the local seismic risk parameters.     

Seabed Morphology and Pollution Along the Bagnoli Coast (Naples, Italy): a Hypothesis for Environmental Restoration

Abstract. The interaction of coastal and submarine morphology with the hydrodynamic regimes exerts a control on coastal dynamic processes, conditioning the dispersion of sediments and potential pollutants existing in the area. Thus, the study of such parameters is useful in order to define environmental threats. Within the submerged sector of the Bagnoli coast and particularly in the southern part of the investigated area, there are sediment groups composed of very fine sands located in low-energy zones due to wave refraction and diffraction; they can also be found on the sea bottom and on the man-made structures typical of this zone. These areas show high pollutant levels of N, P, Cu, Fe, Mn, Ni, Pb, Zn, Cd, polyaromatic hydrocarbons (PAHs) and polychlorinated bi-phenyls (PCBs). The northern area, a place of high-energy hydrodynamic processes, also shows high concentration levels of pollutants due to the presence of secondary cell circulation.
Morphological research and analysis of textural characteristics of bottom sediments along the Bagnoli coast allowed the actual processes and their evolution in space and time to be defined. It has also been possible to correlate such processes to the seabed morphology system, the wave formations which affect the coast, the complex system of sediment transport, as well as to the man-made interventions in the area. The results of recent chemical analyses of beach sediments and bottom sediments off the Bagnoli coast were also incorporated. They prove the presence of heavy metals, PAHs and PCBs in high and sometimes very high concentrations. Finally, based on the results of research and analyses, a hypothesis for an intervention for environmental restoration has been formulated in order to renaturalise the coast through dredging and treatment of the sand, both on the seabed and on the emerged beach.     

Contribution of Sponge Spicules to the Composition of Biogenic Silica in the Ligurian Sea

Abstract. The importance of sponge spicules in the turnover of biogenic silica (BSi) in the detritic bottoms of the Eastern Ligurian Riviera was evaluated by studying sediment cores and the detrital matter collected by a trap over a one year period.
This study made evident that: i) Sponge spicules represent the main component of the BSi both in the sediments and in the trapped matter; ii) A correlation exists between the sponge biomass present on the overhanging cliff and the amount of sponge spicules found in the sediment below; iii) Inside the sediments, a superficial layer (10 cm deep) characterized by intensive silica dissolution processes can be observed; and iv) The amount of spicules collected using the trap is not constant throughout the year, but shows a characteristic trend with low values in spring and summer and high values in autumn and winter.     

Seasonal variations in faunal distribution and activity across the continental slope of the goban spur area (NE Atlantic)

Density, biomass and community structure of macrofauna were estimated together with several sediment characteristics at seven stations ranging from 208 m to 4460 m water depth along the OMEX transect in the Goban Spur area (NE Atlantic) during three seasons (October 1993, May 1994, and August 1995). Median grain size decreased with increasing water depth and showed no differences between the seasons. The percentages of organic carbon and total nitrogen were highest at mid-slope depths (1000 to 1500 m), and were significantly higher in August at the upper part of the slope to a depth of 1500 m. The C:N ratio in the surface layer amounted to 7 to 8 in May, 10 to 12 in August and 14 to 17 in October at all stations (except the deepest at 4460 m, where it was 11 in May and August), indicating arrival of fresh phytodetritus in May, and therefore seasonality in food input to the benthos. Densities of macrofauna decreased exponentially with increasing water depth. Significantly higher densities of macrofauna were found in May at the upper part of the slope to a depth of 1500 m. These differences were mainly due to high numbers of postlarvae of echinoids at the shallowest station and ophiuroids at the deeper stations. Biomass values also decreased with increasing water depth, but biomass was relatively high at the 1000 m station and low at 1500 m, due to relatively high and low mean weights of the individual macrofaunal specimens. No significant differences in biomass were found between the seasons. Respiration was high (15 to 20 mgC·m⁻²·d⁻¹) in May at the upper part of the slope to a depth of 1000 m and low (1–3 mg C·m⁻²·d⁻¹) at the deeper part. At the shallowest stations to a depth of 1000 m respiration was highest in May, at the mid-slope stations (1400–2200 m) it was highest in August, whereas the deepest stations (3600 to 4500 m) did not show any differences in respiration rates. In conclusion; seasonal variation in organic input is reflected in denstiy, community structure and activity of the macrofauna along the continental slope in the NE Atlantic.     

Nir surface photometry of star-forming regions

We present a set of maps of the star-forming regions S140, Re 50, and Mon R2 in theJ, H, andK infrared bands (i.e., 1.2, 1.65, and 2.2 m), obtained with a resolution of 7 and 14 arc sec at the infrared 1.5 m TIRGO telescope, with the TIRGO InSb single channel photometer operating in a mapping mode.Paper presented at the 11th European Regional Astronomical Meetings of the IAU on New Windows to the Universe, held 3–8 July, 1989, Tenerife, Canary Islands, Spain.     

Geochemistry of silicic magmas in the Macolod Corridor, SW Luzon, Philippines: evidence of distinct, mantle-derived, crustal sources for silicic magmas

Silicic volcanic deposits (>65 wt% SiO₂), which occur as domes, lavas and pyroclastic deposits, are relatively abundant in the Macolod Corridor, SW Luzon, Philippines. At Makiling stratovolcano, silicic domes occur along the margins of the volcano and are chemically similar to the silicic lavas that comprise part of the volcano. Pyroclastic flows are associated with the Laguna de Bay Caldera and these are chemically distinct from the domes and lavas at Makiling stratovolcano. As a whole, samples from the Laguna de Bay Caldera contain lower concentrations of MgO and higher concentrations of Fe₂O_3(t) than the samples from domes and lavas. The Laguna de Bay samples are more enriched in incompatible trace elements. The silicic rocks from the domes, Makiling Volcano and Laguna de Bay Caldera all contain high alkalis and high K₂O/Na₂O ratios. Melting experiments of primitive basalts and andesites demonstrate that it is difficult to produce high K₂O/Na₂O silicic magmas by fractional crystallization or partial melting of a low K₂O/Na₂O source. However, recent melting experiments (Sisson et al., Contrib Mineral Petrol 148:635–661, 2005) demonstrate that extreme fractional crystallization or partial melting of K-rich basalts can produce these silicic magmas. Our model for the generation of the silicic magmas in the Macolod Corridor requires partial melting of mantle-derived, evolved, moderate to K-rich, crystallized calc-alkaline magmas that ponded and crystallized in the mid-crust. Major and trace element variations, along with oxygen isotopes and ages of the deposits, are consistent with this model. Electronic Supplementary Material Supplementary material is available for this article at     

Efficiency of base isolation systems in structural seismic protection and energetic assessment

This paper concerns the seismic response of structures isolated at the base by means of High Damping Rubber Bearings (HDRB). The analysis is performed by using a stochastic approach, and a Gaussian zero mean filtered non‐stationary stochastic process is used in order to model the seismic acceleration acting at the base of the structure. More precisely, the generalized Kanai–Tajimi model is adopted to describe the non‐stationary amplitude and frequency characteristics of the seismic motion. The hysteretic differential Bouc–Wen model (BWM) is adopted in order to take into account the non‐linear constitutive behaviour both of the base isolation device and of the structure. Moreover, the stochastic linearization method in the time domain is adopted to estimate the statistical moments of the non‐linear system response in the state space. The non‐linear differential equation of the response covariance matrix is then solved by using an iterative procedure which updates the coefficients of the equivalent linear system at each step and searches for the solution of the response covariance matrix equation. After the system response variance is estimated, a sensitivity analysis is carried out. The final aim of the research is to assess the real capacity of base isolation devices in order to protect the structures from seismic actions, by avoiding a non‐linear response, with associated large plastic displacements and, therefore, by limiting related damage phenomena in structural and non‐structural elements. In order to attain this objective the stochastic response of a non‐linear n‐dof shear‐type base‐isolated building is analysed; the constitutive law both of the structure and of the base devices is described, as previously reported, by adopting the BWM and by using appropriate parameters for this model, able to suitably characterize an ordinary building and the base isolators considered in the study. The protection level offered to the structure by the base isolators is then assessed by evaluating the reduction both of the displacement response and the hysteretic dissipated energy. Copyright © 2003 John Wiley & Sons, Ltd.