Assessment of the impact of the planetary scale on the decay of blocking and the use of phase diagrams and enstrophy as a diagnostic

It was shown that abrupt changes in the large-scale structure of atmospheric flows may lead to the rapid decay of blocking. Analysis of phase diagrams made it possible to identify when sharp changes occurred in the dynamics of the system. The connection of these changes to the decay of blocking was estimated for three blocking events in the Southern Hemisphere. In addition to phase diagrams, enstrophy was used as a diagnostic tool for the analysis of blocking events. From the results of this analysis, four scenarios for the decay mechanisms were determined: (i) decay with a lack of synoptic-scale support, (ii) decay with an active role for synoptic processes, and (iii–iv) either of these mechanisms in the interaction with an abrupt change in the character of the planetary-scale flow.     

Estimation of hydraulic permeability considering the micro morphology of rocks of the borehole YAXCOPOIL-1 (Impact crater Chicxulub,Mexico)

Internal surface, formation factor, Nuclear Magnetic Resonance (NMR)-T2 relaxation times and pore radius distributions were measured on representative core samples for the estimation of hydraulic permeability. Permeability is estimated using various versions of the classic Kozeny–Carman-equation (K–C) and a further development of K–C, the fractal PaRiS-model, taking into account the internal surface. In addition to grain and pore size distribution, directly connected to permeability, internal surface reflects the internal structure (“micro morphology”). Lithologies could be grouped with respect to differences in internal surface. Most melt rich impact breccia lithologies exhibit large internal surfaces, while Tertiary post-impact sediments and Cretaceous lithologies in displaced megablocks display smaller internal surfaces. Investigations with scanning electron microscopy confirm the correlation between internal surface and micro morphology. In addition to different versions of K–C, estimations by means of NMR, pore radius distributions and some gas permeability measurements serve for cross-checking and calibration. In general, the different estimations from the independent methods and the measurements are in satisfactory accordance. For Tertiary limestones and Suevites bulk with very high porosities (up to 35%) permeabilites between 10⁻¹⁴ and 10⁻¹⁶ m² are found, whereas in lower Suevite, Cretaceous anhydrites and dolomites, bulk permeabilites are between 10⁻¹⁵ and 10⁻²³ m².     

Synthetic zeolites formed from expanded perlite: Type,formation conditions and properties

Summary The starting material used was expanded perlite with a grain size < 40 m (74.5 wt.% SiO₂; 12.5 wt.% Al₂O₃). This material is a waste product obtained during the production of expanded perlite. The experiments were carried out with KOH solutions, mixtures of KOH and NaOH solutions (1:1) as well as NaOH solutions in the concentration range 0.5 N to 6.0 N at temperatures of between 100° and 140°C and with reaction periods of 2 hours to 13 days in closed system. In the experiments with KOH containing solutions zeolite ZK-19 (phillipsite), W (merlinoite), G (chabazite) and F (edingtonite) formed. Without addition of aluminium high percentages of zeolite ZK-19 (80–100 wt.%) and zeolite W (90–100 wt.%) were obtained. The addition of aluminium rendered possibly the formation of 90 to 100 wt.% of zeolite G and 85 to 100 wt.% of zeolite F, respectively. In the experiments with NaOH solutions analcime, zeolite Na-Pc (gismondine), zeolite HS (sodalite hydrate) and zeolite A formed. High percentages of zeolite Na-Pc (90–100 wt.%), zeolite HS (up to 100 wt.%) and analcime (up to 100 wt.%) were synthesized without addition of aluminium. The formation of high percentages of zeolite A (95–100 wt.%), however, needs the addition of aluminium, NaCI and seed crystals. The temperature stability of the zeolites decreases in the following sequence: K-F > K-W K-ZK-19 (Na), K-W Na, K-F G_si-rich (Na), K-ZK-19 >> Na-Pc G_si-poor. Zeolite A has a very good temperature stability up to temperatures of } 550 °C similar to that of zeolite K-W. At higher temperatures, however, its stability is very poor. The NH₄ ⁺-exchange capacities (meq/g) of the different zeolites amount to the following values: ZK-19:2.8 - 3.2; W:3.0 - 3.2; G:2.3 - 3.6; A:3.1 - 3.2; Na-Pc:3.5 - 3.6; F : 3.9 - 4.8.

---

Zeolithsynthese aus Blähperlit—Art, Bildungsbedingungen und Eigenschaften

Zusammenfassung Ausgangsmaterial der experimentellen Untersuchungen war Blähperlit mit einer Korngröße < 40 ,m (74,5 Gew.-% SiO₂; 12,5 Gew.-% Al₂O₃). Dieses Material ist ein Abfallprodukt, das bei der Produktion von Blähperlit anfällt. Die Experimente wurden mit KOH-Lösungen, Lösungsgemischen aus KOH und NaOH (1:1) sowie mit NaOH-Losungen im Konzentrationsbereich 0,5 n-6,0 n bei Temperaturen von 100° – 140°C und über Reaktionszeiten von 2 Stunden bis zu 13 Tagen im geschlossenen System durchgeführt. In den Experimenten mit KOH-hältigen Lösungen bildeten sich die Zeolithe ZK-19 (Phillipsit), W (Merlinoit), G (Chabasit) und F (Edingtonit). Hohe Prozentgehalte an Zeolith ZK-19 (80 – 100 Gew.-%) und Zeolith W (90–100 Gew.-%) entstehen nur ohne Zugabe von Aluminium. Die Bildung von 90–100 Gew.-% Zeolith G bzw. 85–100 Gew. % Zeolith F ist dagegen durch die Zugabe von Aluminium möglich. In den Experimenten mit NaOH-Lösungen bildeten sich die Zeolithe Analcim, Na-Pc (Gismondin), HS (Sodalithhydrat) und Zeolith A. Hohe Prozentanteile an Zeolith Na-Pc (90–100 Gew.-%), HS (bis zu 100 Gew. %) und Analcim (bis zu 100 Gew.-%) wurden ohne Aluminium-Zugabe synthetisiert. Die Bildung von hohen Gehalten an Zeolith A (95–100 Gew. %) ist jedoch nur unter Zugabe von Aluminium, NaCl und Kristallkeimen möglich.Die Temperaturbeständigkeit der Zeolithe nimmt in der folgenden Reihenfolge ab: K-F > K-W - K-ZK-19 (Na), K-W Na, K-F G_si-reich (Na), K-ZK-19 >> Na-Pc G_si-am. Zeolith A weist bis zu Temperaturen von etwa 550°C eine gute Temperaturbeständigkeit auf, die in etwa der von Zeolith K-W entspricht. Bei höheren Temperaturen ist die Beständigkeit jedoch sehr gering.Die NH⁴⁺-Austauschkapazitäten (mÄqu/g) der verschiedenen Zeolithe erreichen folgende Werte: ZK-19:2,8 - 3,2; W:3,0 - 3,2; G:2,3 - 3,6; A:3,1 - 3,2; Na-Pc:3,5 -3,6; F:3,9 - 4,8.

---

---

With 2 Figures     

Combining ordination techniques and geostatistics to determine the patterns of diatom distributions at Lake Lama, Central Siberia

The patterns of spatial variation of diatom assemblages from surface sediments in Lake Lama were quantified using a combined approach of ordination and geostatistics. The aims were (i) to estimate the amount of variation between diatom assemblages within the lake, (ii) to model the spatial variability of the diatom assemblages and their diversity, and (iii) to map the diatom distributions in the lake. A correspondence analysis (CA) separated the diatom assemblages into a planktonic and a periphytic group. Rheophilic taxa were found within the periphytic group. Variogram analysis showed that only the sample scores of the first CA axis and the Shannon diversity index were spatially structured. The range of spatial correlation was estimated to be 55 km for both variables. The diversity and, to a lesser extent, the sample scores had considerable small-scale variability of about 20 and 3%, respectively. Estimates of the first component of the CA and the Shannon index were derived using block-kriging. The maps of the estimates provided a basis for partitioning Lake Lama according to the spatial structures into an eastern and a western basin, a north–south connection between the basins, and a north–south directed tip at the far eastern end. It was shown that variation in diatom assemblages is mainly spatially structured at the catchment scale and that there is a considerable amount of variation at smaller scales. According to the modeled spatial distribution, the assemblages are most likely affected by the lake size, morphology, and the water and nutrient input introduced by rivers. This has to be taken into account when paleolimnological interpretations are drawn from records of complex lake systems like Lake Lama.     

New palaeointensity results from Cretaceous basalt of Inner Mongolia, China

We present new Thellier-Thellier palaeointensity results from three cooling units (32 samples) of Inner Mongolia lava flows (91.7 Ma) emplaced during the Cretaceous Normal Superchron (CNS). Based on rock-magnetic and microscopy observations the magneto-mineralogy of all samples is determined to be primary and unaltered high-Ti titanomagnetite. Accepted palaeointensity determinations, obtained in the 80-200 °C temperature interval, are of good technical quality with positive standard partial thermoremanent magnetisation (pTRM) checks and pTRM-tail checks. Obtained palaeointensity estimates range from 14.7 to 28.0 μT, with virtual axial dipole moments (VADM) of 2.4 to 4.6 (× 10²² Am²). The data agree well with recently published results from the same region and, combining the two datasets, we obtain independent estimates from six different cooling units yielding a time-averaged VADM of 3.2 ± 1.6 (× 10²² Am²). These data suggest a relatively low dipole moment towards the end of the Cretaceous Normal Superchron.     

Bristen granite: a highly differentiated,fluorite-bearing A-type granite from the Aar massif,Central Alps,Switzerland

Bristen granite is a body of fine-grained leucogranite occurring in the Gotthard rail base tunnel in the Central Alps. During construction of the tunnel, Bristen granite (Brgr) has been drilled along a 600 m long section. The aplite-granite belongs to the suite of Variscan granitoid intrusions of the Aar massif and contains a variety of accessory minerals typical of highly differentiated granites. Rock forming fluorite, partly enriched in yttrium (Y) and rare earth elements (REE), is intergrown with the late Y- and REE-bearing carbonate mineral synchysite. The granite contains a variety of Ti- and Y-REE-niobates, thorite, and zircon. Compared with the calc-alkaline central Aar granite (cAgr), Bristen granite is strongly depleted in Ti, P, Mg, Sr, and Ba and shows a remarkable enrichment in incompatible elements such as Rb, Th, U, Nb, Y, HREE and F. Bristen granite is the most evolved granitoid rock of the Aar massif. The composition of Brgr is typical of post-collisional reduced (ferroan) A-type granites. The Brgr melt formed in the lower crust and crystallized from a highly differentiated melt at the cotectic point in the quartz-feldspar system close to 100 MPa and 700 °C. The Brgr intruded as a small isolated stock pre-Variscan gneisses with sharply discordant contacts. The primary igneous host of Nb, Ta, Y, U, Th and REE is biotite in addition to minor amounts of allanite, and zircon. The presence of Y-REE-fluorite, synchysite, parisite and Y- and Ti-niobates and other REE-minerals can be related to reaction of igneous biotite and primary fluorite with hydrothermal fluids. The reaction is associated with alpine metamorphism, because Y-bearing fluorite and synchysite have been reported from Alpine fissures. The transformation of primary biotite to chlorite and muscovite released the heavy metal oxides under lower greenschist facies conditions that formed the Alpine diagnostic mineral stilpnomelane at about 300 °C.     

Combined effects of pumped-storage operation and climate change on thermal structure and water quality

Climatic Change - The assessment of ecological impacts of pumped-storage (PS) hydropower plants on the two connected water bodies is usually based on present climatic conditions. However,...     

Desorption and coagulation of trace elements during estuarine mixing

Mixing experiments of seawater and the Hudson and Mississippi riverwaters with radiotracer spikes show that Co, Mn, Cs, Cd, Zn and Ba will be desorbed from river suspended particles, while significant fractions of “dissolved” Fe, Sn, Bi, Ce and Hg will be coagulated during estuarine mixing.