CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

Application of AVO Analysis to Seismic Data for Detection of Gas below Methane Hydrate Stability Zone in Nankai Trough Area

Abstract. For the purpose of development of methane hydrate, occurring in the deep marine subsurface, as a resource, the most important issue is to understand the methane hydrate system (generation, migration and accumulation) as well as to delineate the methane hydrate reservoir properties. We have applied the Amplitude Versus Offset (AVO) analysis to the seismic data acquired in the Nankai Trough, offshore Japan, in order to confirm the occurrence of gas just below the methane hydrate-bearing zone, assuming that gas will show a so-called Class-3 AVO response. Knowledge of the amount and occurrence of gas in the sediment below methane hydrate-bearing zone is one of the keys to understand the methane hydrate system.
We have utilized the qualitative analysis of AVO methodology to delineate how gas is located below the BSR, which is thought to be the reflection event from the interface between the methane hydrate-bearing zone and the underlying gas-bearing zone. In the region of MITI Nankai Trough Well PSW-3, we observe two BSRs separated by 25 ms. After AVO modeling using well data, we applied AVO attribute analysis and attribute crossplot analysis to the seismic data. Finally we applied an offset-amplitude analysis to CMP gather data at specific locations to confirm the results of AVO attribute analysis. The AVO analysis shows that there is very little gas located in the underlying sediment below methane hydrate-bearing zone. This result supports the fact that we could not obtain any clear evidence of gas occurrence just below the methane hydrate-bearing zone in the Nankai Trough well drilling.     

Detection of Methane Hydrate-Bearing Zones from Seismic Data

Abstract. The MITI Nankai Trough wells were drilled offshore Japan in the Tokai area in 1999 and 2000. The occurrence of methane hydrate was confirmed by various indicators in the borehole logs and from core data. These findings have a large impact on potential future Japanese energy resources and other related-scientific interests.
We first tried to find the methane hydrate-bearing zones using interval velocities derived from NMO velocity analysis. However, this analysis produced poor resolution. To achieve a more detailed delineation of the gas hydrate- and gas-bearing zones, we executed a seismic impedance inversion calibrated by the logs from two of the MITI Nankai Trough wells. Although these two wells are only about 90 m apart, we were able to produce an impedance section with fine detail by adopting a simple initial model and incorporating physical properties of the methane hydrate-bearing zones. The locations of the methane hydrate-bearing zones are readily apparent in the final section.     

ACTIVE system for monitoring volcanic activity: A case study of the Izu-Oshima Volcano,Central Japan

A system is proposed for the monitoring of changes in the underground structure of an active volcano over time by applying a transient electromagnetic method. The monitoring system is named ACTIVE, which stands for Array of Controlled Transient-electromagnetics for Imaging Volcano Edifice. The system consists of a transmitter dipole used to generate a controlled transient electromagnetic (EM) field and an array of receivers used to measure the vertical component of the transient magnetic field at various distances, with automatic operation of both units. In order to verify the performance of the proposed system, numerical and field experiments were carried out by application of the system to the Izu-Oshima volcano, where a remarkable change in the apparent DC resistivity over time had been detected in association with the eruption in 1986.     

Quaternary vertical offset and average slip rate of the Nojima Fault on Awaji Island, Japan

Abstract Drilling was carried out to penetrate the Nojima Fault where the surface rupture occurred associated with the 1995 Hyogo-ken Nanbu earthquake. Two 500 m boreholes were successfully drilled through the fault zone at a depth of 389.4 m. The drilling data show that the relative uplift of the south-east side of the Nojima Fault (south-west segment) was approximately 230 m. The Nojima branch fault, which branches from the Nojima Fault, is inferred to extend to the Asano Fault. From the structural contour map of basal unconformity of the Kobe Group, the vertical component of displacement of the Nojima branch–Asano Fault is estimated to be 260–310 m. Because the vertical component of displacement on the Nojima Fault of the north-east segment is a total of those of the Nojima Fault of the south-west segment and of the Nojima branch–Asano Fault, it is estimated to total to 490–540 m. From this, the average vertical component of the slip rate on the Nojima Fault is estimated to be 0.4–0.45 m/10³ years for the past 1.2 million years.     

Paleomagnetic Constraints on Mineralization Age of the Nansatsu-type Gold Deposits in Southern Kyushu, Japan

Abstract: Two mineralization stages, stage I and stage II, have been identified from textural, mineralogical and crosscutting relationships in gold ore from the Nansatsu-type gold deposits of Kasuga, Iwato and Akeshi. Mineralization age of each stage in each deposit was determined with paleomagnetic methods on 432 specimens from 312 oriented samples. As results, mineralization ages of stage I of each deposit fall in the same period, the reversed polarity subchron of 4.18–3.58 Ma, and those of stage II are limited in the normal and reversed polarity subchrons of 3.58–3.22 Ma. Contrasting with previous results based only on K-Ar ages, our conclusion shows that these Nansatsu-type gold deposits were formed contemporaneously.     

东亚大陆边缘的构造格架及其中-新生代演化

燕山运动在亚洲大陆雏形东缘形成2条北东向的剪切带:郯庐断裂带和长乐-南澳-中央构造线断裂带,晚侏罗世—古近纪早期沿之发生地体/地块的拼贴。系统叙述了各移置地体/地块的主要岩石记录和拼贴时代,据起源分为3类:异地的(包括源自冈瓦纳的和源自盘古大洋的)、半异地的和准原地的;据拼贴位置分为2组:拼贴后基本位于原地的(日本海张开以前) 和发生过向北东错移的。新生代内东亚大陆边缘发生解体,可以台湾岛以北的菲律宾海盆断裂为界将东亚大陆边缘弧分为2段,北段仍处于剪切-拉张中,南段已进入剪切挤压-造山阶段。强调该地区中—新生代演化经历了2个里丁旋回, 形成早白垩世的北东向和新近纪的北东东向2期新生构造。     

Retrieval single-doppler radar wind with variational assimilation method-part i: objective selection of functional weighting factors

In variational problem, the selection of functional weighting factors (FWF) is one of the key points for discussing many relevant studies. To overcome arbitrariness and subjectivity of the empirical selecting methods used widely at present, this paper tries to put forward in optimal objective selecting method of FWF. The focus of the study is on the weighting factors optimal selection in the variation retrieval single-Doppler radar wind field with the simple adjoint models. Weighting factors in the meaning of minimal variance are calculated out with the matrix theory and the finite difference method of partial differential equation. Experiments show that the result is more objective comparing with the factors obtained with the empirical method.