The sediment-water interface increment due to the complex burrows of macrofauna in a tidal flat

The architecture of macrofaunal burrows and the total area of the sediment-water interface created by biogenic structure were investigated in the Donggeomdo tidal flat on the west coast of Korea. Resin casting methods were applied to recover burrows of four dominant species, Macrophthalmus japonicus, Cleistostoma dilatatum, Perinereis aibuhitensis, and Periserrula leucophryna, and whole burrows within the casting area at three sites in different tidal levels.P. leucophryna excavated the largest burrow in terms of a surface area among them. In the case of whole burrow casting, the space occupied by the biogenic structure was extended into deeper and expanded more greatly at the higher tidal level. In the uppermost flat, the burrow wall surface area within sediment was more extensive than the sediment surface area. Increased oxygen supply through the extended interface could enhance the degradation rates of organic carbon and also change the pathways of degradation. Quantifying the relationship between the extended interface and mineralization rate and pathway requires more extensive study.     

Some stability properties of large-scale baroclinic flows with nonlinear zonal current profile

The stability properties of a baroclinic zonal current with nonlinear velocity profile are investigated. The integral method is applied to the governing eigenvalue equation having the vertical velocity as the dependent variable. Expressed in terms of the Rossby number and the Richardson number, stability criteria, unstable regions in the complexc plane, and the upper bound of the unstable wave growth rate are found. Some differences in the results are noted between the present model and the quasi-geostrophic streamfunction model, particularly in connection with the effect of the velocity profile curvature termU _zz . It is conjectured in the present model that, depending on extreme behaviors ofU _zz , the propagation speed of unstable waves can be greater thanU _max or smaller thanU _min .     

Geophysical and geochemical observations on actively seeping hydrocarbon gases on the south-eastern Yellow Sea continental shelf

In the southeastern Yellow Sea, active seepage of hydrocarbon gases has been observed by high-resolution (3.5 kHz) seismic profiling both in 1987 and 2001, occurring through a large number of plumes from the topmost pre-Holocene sedimentary layer. It is strong enough to compensate for current speed, extending vertically up to the sea surface. The gas seepage often appears to be explosive to form craters and diapirs, although pockmarks are rare due to the redistribution of mobile palimpsest sands. In core-top seawater and sediments, the gases are characterized by high amounts of C₂, homogenous ¹³C₁ values and a large difference (19.7 on average) between ¹³C₁ (–55.2 to –53.6 PDB) and ¹³C₂ (–36.8 to –32.5 PDB) values. The gases are considered to be generated with a smaller amount of C₁ at the early thermal cracking stage of labile source materials, after which the C₂ gas is enriched in ¹³C by diffusion or biological alternation at the generation or accumulation site. The homogenous ¹³C₁ values may be one of the geochemical characteristics of gases acquired at depth which are less altered in the case of rapid diffusive gas migration to the seafloor.     

Bacterioplankton growth and production at the Louisiana hydrocarbon seeps

The growth rate and potential production of bacterioplankton in cold hydrocarbon seeps located along the Louisiana coast were determined using a pulse-labeling technique. Surprisingly, community doubling times are on the order of 1.1 h, which compares to laboratory-grown cultures. We also found that there are differences in growth rates on relatively small geographic scales, suggesting the influence of site-specific geological features (e.g., gas hydrate mounds). Proceeding downslope to deeper waters, methane-oxidizing bacteria appeared to play a more significant role in community productivity. These preliminary experiments indicated, quite unexpectedly, that water column microbes are growing at a more rapid rate than in any other marine system so far studied and that methane may serve as a primary nutrient (carbon) source in these seep-associated microbial assemblages.     

Evaluation of bending moments and shear forces at unit connections of very large floating structures using hydroelastic and rigid body analyses

This paper investigates the characteristics of bending moments, shear forces and stresses at unit connections of very large floating structures (VLFS) under wave loads. The responses of VLFS are calculated by solving multi-body motion equation considering hydroelasticity and connection stiffness. Hydroelastic responses are calculated by the direct method. Higher-order boundary element method (HOBEM) is used for fluid analysis and finite element method (FEM) is introduced for structural analysis. The equation of motion is modified to describe the unit connections by employing spring elements. Bending moments and shear forces at the connections are obtained from the dynamic equilibrium condition for pressures and inertia forces. Two types of VLFS units such as tandem arranged units and side-by-side arranged units are considered in the numerical examples. The influences of connection stiffness, wave frequency and heading angle on responses of VLFS are investigated through the numerical examples. Rigid body analysis along with hydroelastic analysis is also carried out in the numerical analysis and comparison of those two approaches is discussed.     

硫酸皮肤素寡糖的分离与制备

利用软骨素酶 ABC (Chondroitinase ABC,EC4 .2 .2 .4 )对硫酸皮肤素 (Dermatan Sul-fate,DS)进行控制降解。对得到的混合寡糖首先采用低压凝胶渗透色谱 (L PGPC)进行分级 ,然后对每一组分再利用强阴离子交换高压液相色谱 (SAX- HPL C)进行分离 ,最终制备出聚合度为 2 ,4 ,6 ,8,10 ,12的寡糖纯品。寡糖纯度采用 SAX- HPL C,毛细管电泳 (CE)以及聚丙烯酰胺凝胶电泳(PAGE)进行检验 ,结构采用电喷雾离子化质谱 (ESI- MS)以及核磁共振波谱 (NMR)技术确定     

The reliability of analytical data for tributyltin (TBT) in sea water and its implications on water quality criteria

To investigate the reliability of analytical data for tributyltin (TBT) in sea water, split water samples were distributed to ten laboratories in six countries. The sub-surface samples comprised: (i) an offshore (0·5 km) water sample, (ii) the same sample but spiked with an undisclosed quantity of TBT standard compound (175 ng TBT⁺ liter⁻¹), and (iii) a sample taken from a yacht marina. The seven acceptable data sets were in good agreement for the spiked sample (178 ± 26 ng TBT⁺ liter⁻¹) but showed a greater variation in concentrations reported for the yacht marina sample (366 ± 93 ng TBT⁺ liter⁻¹). Atomic absorption and gas chromatographic-flame photometric detection techniques produced results of similar accuracy and precision. Samples acidified with 1 ml of 10% (v/v) acetic acid appeared stable for more than 2 weeks when stored refrigerated and in darkness. Analyses of the offshore seawater sample revealed TBT contamination (9 ± 7 ng TBT⁺ liter⁻¹) indicating dispersion of the compound to the shelf waters off Monaco. The spread in values reported by the laboratories demonstrates inherent difficulties in obtaining good precision below approximately 20 ng TBT⁺ liter⁻¹. This observation is discussed with respect to the setting and enforcing of water quality standards.     

Yeosu dinosaur track sites of Korea: The youngest dinosaur track records in Asia

Eighty two dinosaur trackways were newly discovered in Upper Cretaceous lacustrine deposits on islands in the vicinity of Yeosu, Korea. Most dinosaur tracks occur in marginal lake deposits with polygonal desiccation cracks. The dinosaur tracks at the Yeosu site include 65 ornithopod trackways, 16 theropod trackways and one sauropod trackway. The prevalence of ornithopod tracks and the limited occurrence of sauropod tracks at the Yeosu site evidently reflect decreased sauropod diversity in the Upper Cretaceous. All ornithopod trackways represent bipeds, and most of the ornithopod tracks are similar to Caririchnium from other sites of the Korean peninsula. All fossil wood specimens collected in the study area represent conifers (three species of cupressaceous and two species of taxodiaceous conifers, and a new species) except for one, which is a discotyledon. It is thus inferred that the southwestern part of the Korean Peninsula was primarily covered with mesic forests with taxodiaceous trees during the Late Cretaceous. The K–Ar age of the Yeosu tracksite is determined as 81–65 Ma (Camapnian to Maastrichtian). It indicates that the Yeosu track site contains the last records of dinosaurs living in Asia. Consequently, semi-arid palaeoclimatic conditions, together with a large lake as a persistent water source and rich vegetation of gymnosperm trees as food, resulted in the preservation of abundant dinosaur tracks in the Upper Cretaceous on the Korean Peninsula.     

Contrast in Fluid M etallogeny between the Tianmashan Au-S Deposit and the Datuanshan Cu Deposit in Tongling, Anhui Province

A comprehensive contrast of ore-forming geological background and ore-forming fluid features, especially fluid ore-forming processes, has been performed between the Tianmashan and the Datuanshan ore deposits in Tongling, Anhui Province. The major reasons for the formation of the stratabound skarn Au-S ore deposit in Tianmashan and the stratabound skarn Cu ore deposit in Datuanshan are analyzed in accordance with this contrast. The magmatic pluton in Tianmashan is rich in Au and poor in Cu, but that in Datuanshan is rich in Cu and Au. The wallrock strata in Tianmashan contain Au-bearing pyrite layers with some organic substance but those in Datuanshan contain no such layers. Moreover, the ore-forming fluids in Tianmashan are dominantly magmatic ones at the oxide and sulfide stages, but those with high content of Cu in Datuanshan are mainly groundwater fluids. In addition, differences in compositional evolution and physicochemical condition variation of the ore-forming fluids result in gradual dispersion     

Optimal design of viscoelastic dampers using eigenvalue assignment

In this study a procedure for determining the optimum size and location of viscoelastic dampers is proposed using the eigenvalue assignment technique. Natural frequencies and modal damping ratios, required to realize a given target response, are determined first by the convex model. Then the desired dynamic structural properties are realized by optimally distributing the damping and stiffness coefficients of viscoelastic dampers using non‐linear programming based on the gradient of eigenvalues. This optimization method provides information on the optimal location as well as the magnitude of the damper parameters. The proposed procedure is applied to the retrofit of a 10‐story shear frame, and to a three‐dimensional structure with an asymmetric plan. The analysis results confirm that the responses of model structures retrofitted by the proposed method correspond well with the given target response. Copyright © 2003 John Wiley & Sons, Ltd.