Based on the observed surface suspended matter in the East China Sea in February 2007 and June 2015, an empirical model was established using L1 b's band 4 data to retrieve surface suspended matter from the Moderate Resolution Imagine Spectroradiometer Terra imagery. The squared correlation coefficient is 0.8358, and the root mean square error is 0.4285 mg L-1. The model reflects the distribution characteristics of surface suspended matter in the inner shelf of the East China Sea. In this paper, the satellite images of the study area were retrieved in January from 2001 to 2015, and the monthly distribution of surface suspended matter were obtained. The inter-annual distribution of the study area is similar, and the concentration of surface suspended matter is higher near the shore than offshore. A large amount of surface suspended matter is transported southeast under the influence of Zhejiang and Fujian coastal current and Taiwan warm current. Only a small amount of surface suspension can reach the Kuroshio area. The surface suspended matter concentration changes obviously near the estuary because of the effect of differences in the flux of the Yangtze River. Meanwhile, winter monsoon, temperature front, El Ni?o events, and other factors affect the distribution of surface suspended matter in 100 m isobath to coastal water but minimally influence the distribution in 100 m isobath to deep sea. 相似文献
This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features. 相似文献
The transfer and evolution of stress among rock blocks directly change the void ratios of crushed rock masses and affect the flow of methane in coal mine gobs. In this study, a Lagrange framework and a discrete element method, along with the soft-sphere model and EDEM numerical software, were used. The compaction processes of rock blocks with diameters of 0.6, 0.8, and 1.0 m were simulated with the degrees of compression set at 0%, 5%, 10%, 15%, 20%, and 25%. This study examines the influence of stress on void ratios of compacted crushed rock masses in coal mine gobs. The results showed that stress was mainly transmitted downward through strong force chains. As the degree of compression increased, the strong force chains extended downward, which resulted in the stress at the upper rock mass to become significantly higher than that at the lower rock mass. It was determined that under different degrees of compression, the rock mass of coal mine gobs could be divided, from the bottom to the top, into a lower insufficient compression zone (ICZ) and an upper sufficient compression zone (SCZ). From bottom to top, the void ratios in the ICZ sharply decreased and those in the SCZ slowly decreased. Void ratios in the ICZ were 1.2–1.7 times higher than those in the SCZ.
Natural Resources Research - Mining-induced fracture plays a key role in gas drainage for gas burst-prone underground coal mines, especially for closely multilayered coal seams. The layout and... 相似文献