Relationship between Salinity and Nutrients in the Subsurface Layer in the Suruga Bay

We investigated the water structure and nutrient distribution in the Suruga Bay from April 2000 to July 2002, especially the Offshore Water, which occupies a large part of the bay. The maximum salinity in the upper 200 m varied between 34.49 and 34.71, indicating a temporal change in the influence of Kuroshio Water on the Offshore Water. Seasonal variation in nutrient concentrations was largest from surface to 50 m. On the other hand, the variance in nutrient concentrations within each season was largest in the subsurface layer of 100–300 m in spring, summer and fall. In the Offshore Water, the change of nutrients was negatively correlated with that of salinity in each season. This suggests that an increasing intrusion of saline water brings about a lower nutrient concentration in the Offshore Water. Likewise, negative correlations were observed between the change of the maximum salinity and chlorophyll a (Δ [chl.a-int])/nutrients integrated in the upper 200 m. Δ[chl.a-int] was significantly correlated with the changes of nitrate and phosphorus, but there were no significant correlations between Δ[chl.a-int] and the change of silicate. These results suggest that the concentrations of chlorophyll a and nutrients in the Offshore Water were decreased due to the increasing intrusion of Kuroshio Water. The Offshore Water is likely to be related to the regulation of primary production by nitrate.     

Fluid–Sediment Interaction in a Marine Shallow-Water Hydrothermal System in the Wakamiko Submarine Crater, South Kyushu, Japan

The Wakamiko submarine crater is a small depression located in Kagoshima Bay, southwest Japan. Marine shallow‐water hydrothermal activity associated with fumarolic gas emissions at the crater sea floor (water depth 200 m) is considered to be related with magmatic activity of the Aira Caldera. During the NT05‐13 dive expedition conducted in August 2005 using remotely operated vehicle Hyper‐Dolphine (Japan Agency for Marine‐Earth Science and Technology), an active shimmering site was discovered (tentatively named the North site) at approximately 1 km from the previously known site (tentatively named the South site). Surface sediment (up to 30 cm) was cored from six localities including these active sites, and the alteration minerals and pore fluid chemistry were studied. The pore fluids of these sites showed a drastic change in chemical profile from that of seawater, even at 30 cm below the surface, which is attributed to mixing of the ascending hydrothermal component and seawater. The hydrothermal component of the North site is estimated to be derived from a hydrothermal aquifer at 230°C based on the hydrothermal end‐member composition. Occurrence of illite/smectite interstratified minerals in the North site sediment is attributed to in situ fluid–sediment interaction at a temperature around 150°C, which is in accordance with the pore fluid chemistry. In contrast, montmorillonite was identified as the dominant alteration mineral in the South site sediment. Together with the significant low potassium concentration of the hydrothermal end‐member, the abundant occurrence of low‐temperature alteration mineral suggests that the hydrothermal aquifer in the South site is not as high as 200°C. Moreover, the montmorillonite is likely to be unstable with the present pore fluid chemistry at the measured temperature (117°C). This disagreement implies unstable hydrothermal activity at the South site, in contrast to the equilibrium between the pore fluid and alteration minerals in the North site sediment. This difference may reflect the thermal and/or hydrological structure of the Wakamiko Crater hydrothermal system.     

Seafloor spreading, obduction and triple junction tectonics of the Mineoka Ophiolite, Central Japan

The Tertiary Mineoka ophiolite occurs in a fault zone at the intersection of the Honshu and Izu forearcs in central Japan and displays structural evidence for three major phases of deformation: normal and oblique-slip faults and hydrothermal veins formed during the seafloor spreading evolution of the ophiolite at a ridge-transform fault intersection. These structures may represent repeated changes in differential stress and pore-fluid pressures during their formation. The second series of deformation is characterized by oblique thrust faults with Riedel shears and no significant mineral veining, and is interpreted to have resulted from transpressional dextral faulting during the obduction of the ophiolite through oblique convergence and tectonic accretion. This deformation occurred at the NW corner of a TTT-type (trench–trench–trench) triple junction in the NW Pacific rim before the middle Miocene. The third series of deformation of the ophiolite is marked by contractional and oblique shear zones, Riedel shears, and thrust faults that crosscut and offset earlier structures, and that give the Mineoka fault zone its lenticular (phacoidal) fabric at all scales. This deformation phase was associated with the establishment and the southward migration of the TTT Boso triple junction and with the kinematics of oblique subduction and forearc sliver fault development. The composite Mineoka ophiolite hence displays rocks and structures that evolved during its complex geodynamic history involving seafloor spreading, tectonic accretion, and triple junction evolution in the NW Pacific Rim.     

Origin of layering in cumulate gabbros in the Oman ophiolite: Insights from magnetic susceptibility measurements in the Wadi Sadm area

Abstract   Magnetic susceptibility and the anisotropy of magnetic susceptibility were measured on an 800-cm-thick succession of cumulate gabbro in the Sadm area of the Oman ophiolite. The section contained three distinct cumulate units. The susceptibility tends to decrease upward in each from a melanocratic layer (several tens of centimeters thick) to a leucocratic layer (a few meters thick). The susceptibility decreases in accordance with the decreasing number of magnetite grains, which are the alteration product mainly of olivine minerals. This suggests the cyclic downward accumulation of olivine in the cumulate gabbro. The apparent strain deduced from the patterns of magnetic and grain fabrics was the result mostly of simple shear, so that the layering of gabbro is understood to be formed primarily by a crystal cumulus process followed by simple shear deformation.     

Transpressional tectonics of the Mineoka Ophiolite Belt in a trench–trench–trench-type triple junction, Boso Peninsula, Japan

Abstract   Structures developed in metamorphic and plutonic blocks that occur as knockers in the Mineoka Ophiolite Belt in the Boso Peninsula, central Japan, were analyzed. The aim was to understand the incorporation processes of blocks of metamorphic and plutonic rocks with an arc signature into the serpentinite mélange of the Mineoka Ophiolite Belt in relation to changes in metamorphic conditions during emplacement. Several stages of deformation during retrogressive metamorphism were identified: the first faulting stage had two substage shearing events (mylonitization) under ductile conditions inside the crystalline blocks in relatively deeper levels; and the second stage had brittle faulting and brecciation along the boundaries between the host serpentinite bodies in relatively shallower levels (zeolite facies). The first deformation occurred during uplift before emplacement. The blocks were intensively sheared by the first deformation event, and developed numerous shear planes with spacing of a few centimeters. The displacement and width of each shear plane were a few centimeters and a few millimeters, respectively, at most. In contrast, the fault zone of the second shearing stage reached a few meters in width and developed during emplacement of the Mineoka Ophiolite. Both stages occurred under a right-lateral transpressional regime, in which thrust-faulting was associated with strike-slip faulting. Such displacement on an outcrop scale is consistent with the present tectonics of the Mineoka Belt. This implies that the same tectonic stress has been operating in the Boso trench–trench–trench-type triple junction area in the northwest corner of the Pacific since the emplacement of the Mineoka Ophiolite. The Mineoka Ophiolite Belt must have worked as a forearc sliver fault during the formation of a Neogene accretionary prism further south.     

An experimental study on felsic rock–artificial seawater interaction: implications for hydrothermal alteration and sulfate formation in the Kuroko mining area of Japan

Experimental studies on the interactions between artificial seawater (ASW) and fresh rhyolite, perlite and weakly altered dacitic tuff containing a small amount of smectite suggest changing cation transfer during smectite-forming processes. Initially, dissolution of K from the rocks accompanies incorporation of Mg and Ca from ASW during both earlier (devitrification stage) and later smectite formation, whereas Ca incorporated with early smectite formation redissolves with progressive reaction. Barium mobility increases toward the later smectite-forming reactions. Therefore, the large amounts of barite, anhydrite and gypsum in Kuroko ore deposits are considered to have precipitated from hydrothermal solutions derived from the interaction with previously altered felsic rocks during late smectite formation, rather than by the reaction with fresh felsic rocks.Editorial handling: D. Lentz     

GDP and employment effects of policies to close the 2020 emissions gap

Four policies might close the gap between the global GHG emissions expected for 2020 on the basis of current (2013) policies and the reduced emissions that will be needed if the long-term global temperature increase can be kept below the 2 °C internationally agreed limit. The four policies are (1) specific energy efficiency measures, (2) closure of the least-efficient coal-fired power plants, (3) minimizing methane emissions from upstream oil and gas production, and (4) accelerating the (partial) phase-out of subsidies to fossil-fuel consumption. In this article we test the hypothesis of the International Energy Agency (IEA) that these policies will not result in a loss of gross domestic product (GDP) and we estimate their employment effects using the E3MG global macro-econometric model. Using a set of scenarios we assess each policy individually and then consider the outcomes if all four policies were implemented simultaneously. We find that the policies are insufficient to close the emissions gap, with an overall emission reduction that is 30% less than that found by the IEA. World GDP is 0.5% higher in 2020, with about 6 million net jobs created by 2020 and unemployment reduced.

Policy relevance

The gap between GHG emissions expected under the Copenhagen and Cancun Agreements and that needed for emissions trajectories to have a reasonable chance of reaching the 2 °C target requires additional policies if it is to be closed. This article uses a global simulation model E3MG to analyse a set of policies proposed by the IEA to close the gap and assesses their macroeconomic effects as well as their feasibility in closing the gap. It complements the IEA assessment by estimating the GDP and employment implications separately by the different policies year by year to 2020, by major industries, and by 21 world regions.     

Generalised observations of wave characteristics on near‐horizontal shore platforms: Synthesis of six case studies from the North Island,New Zealand

Most field studies of wave processes on shore platforms in front of eroding cliffs focus on a single site, revealing aspects of wave dynamics at that location. Here, we analyse data from six platforms around northeastern New Zealand and describe the fundamental control of shore platform width, gradient and elevation on wave processes, including greater attenuation of short‐period waves at lower tidal stages and increases in longer period wave energy towards the cliff toe. These data suggest that empirical formulae developed from coral‐reef environments provide better predictions of wave height on platforms than formulae currently used in shore platform models.     

Structure and development of the Sagami trough and the Boso triple junction

The Sagami trough is located at the particular plate margin where the Izu forearc is subducted underneath the Honshu forearc. At its southeastern end, the world's only known TTT-type triple junction (Boso triple junction) has developed. Several different kinds of basins occur in different segments along the Sagami trough and at the triple junction. The bathymetric, geologic, and geophysical data obtained during the Kaiko Project and from additional studies are summarized together with our onland studies. We suggest that the right-lateral oblique plate motion formed an eduction margin in the Sagami basin, while a normal subduction margin and an oblique subduction margin have been formed in the Middle Sagami trough basin. These tectonic phenomena resulted from the long-lasting compressional covergence between the Philippine Sea plate and Eurasian plate since the early or middle Miocene. The North basin on the northeasternmost margin of the Philippine Sea plate near the Boso triple junction has developed as a stretched basin due to the westward motion of the Philippine Sea plate with respect to the Eurasian plate.