Resistivity of reservoir sandstones and organic rich shales on the Barents Shelf:Implications for interpreting CSEM data

Marine controlled source electromagnetic(CSEM)data have been utilized in the past decade during petroleum exploration of the Barents Shelf,particularly for de-risking the highly porous sandstone reservoirs of the Upper Triassic to Middle Jurassic Realgrunnen Subgroup.In this contribution we compare the resistivity response from CSEM data to resistivity from wireline logs in both water-and hydrocarbon-bearing wells.We show that there is a very good match between these types of data,particularly when reservoirs are shallow.CSEM data,however,only provide information on the subsurface resistivity.Careful,geology-driven interpretation of CSEM data is required to maximize the impact on exploration success.This is particularly important when quantifying the relative re-sistivity contribution of high-saturation hydrocarbon-bearing sandstone and that of the overlying cap rock.In the presented case the cap rock comprises predominantly organic rich Upper Jurassic-Early Cretaceous shales of the Hekkingen Formation(i.e.a regional source rock).The resistivity response of the reservoir and its cap rock become merged in CSEM data due to the transverse resistance equivalence principle.As a result of this,it is imperative to understand both the relative contributions from reservoir and cap rock,and the geological sig-nificance of any lateral resistivity variation in each of the units.In this contribution,we quantify the resistivity of organic rich mudstone,i.e.source rock,and reservoir sandstones,using 131 exploration boreholes from the Barents Shelf.The highest resistivity(＞10,000 Ωm)is evident in the hydrocarbon-bearing Realgrunnen Subgroup which is reported from 48 boreholes,43 of which are used for this study.Pay zone resistivity is primarily controlled by reservoir quality(i.e.porosity and shale fraction)and fluid phase(i.e.gas,oil and water saturation).In the investigated wells,the shale dominated Hekkingen Formation exhibits enhanced resistivity compared to the background(i.e.the underlying and overlying stratigraphy),though rarely exceeds 20Ωm.Marine mudstones typically show good correlation between measured organic richness and resistivity/sonic velocity log signatures.We conclude that the resistivity contribution to the CSEM response from hydrocarbon-bearing sandstones out-weighs that of the organic rich cap rocks.     

Environmental analysis of the Norwegian fishery and aquaculture industry—A preliminary study focusing on farmed salmon

This article addresses the present status of seafood-oriented environmental methods and analyses, and pinpoints areas for further development. A recent study of the CO₂ emissions associated with the production of farmed salmon in Norway, following the life cycle from hatching to consumption, is presented. The study was initiated due to the increased focus on environmental impacts from food production among consumer organizations, retailers, and authorities. In general, several methods are being currently applied to measure environmental performance. Unfortunately, different methods provide quite different results. An additional challenge is that most of these methods were originally developed for land-based production. If assumptions about the performance of the seafood industry are established on the basis of incorrect information, consequences for both the management and the market level may not be desirable.     

Wild and farmed salmon in Norway—A review

The Salmon industry in Norway includes three sectors, namely sea and river fishing for wild salmon, and salmon farming, or aquaculture. The three sectors provide different social, economic and cultural benefits to society, but also face many problems and challenges. They have different interests, practices, traditions and audiences, and are also administered by different authorities and regulated under varying management regimes and legislations. On the one hand, they complement each other in terms of product supply, employment creation and income; on the other hand, they face conflicts over management objectives and strategies. This paper provides an overview of the salmon sectors associated with their status, challenges and management regimes. It further analyzes their interests and conflicts over economic contribution and management. Finally, some potential solutions are suggested in an attempt to solve these conflicts.     

Tempestite facies variability and storm-depositional processes across a wide ramp: Towards a polygenetic model for hummocky cross-stratification

The hydrodynamic mechanisms responsible for the genesis and facies variability of shallow-marine sandstone storm deposits (tempestites) have been intensely debated, with particular focus on hummocky cross-stratification. Despite being ubiquitously utilized as diagnostic elements of high-energy storm events, the full formative process spectrum of tempestites and hummocky cross-stratification is still to be determined. In this study, detailed sedimentological investigations of more than 950 discrete tempestites within the Lower Cretaceous Rurikfjellet Formation on Spitsbergen, Svalbard, shed new light on the formation and environmental significance of hummocky cross-stratification, and provide a reference for evaluation of tempestite facies models. Three generic types of tempestites are recognized, representing deposition from: (i) relatively steady and (ii) highly unsteady storm-wave-generated oscillatory flows or oscillatory-dominated combined-flows; and (iii) various storm-wave-modified hyperpycnal flows (including waxing–waning flows) generated directly from plunging rivers. A low-gradient ramp physiography enhanced both distally progressive deceleration of the hyperpycnal flows and the spatial extent and relative magnitude of wave-added turbulence. Sandstone beds display a wide range of simple and complex configurations of hummocky cross-stratification. Features include ripple cross-lamination and ‘compound’ stratification, soft-sediment deformation structures, local shifts to quasi-planar lamination, double draping, metre-scale channelized bed architectures, gravel-rich intervals, inverse-to-normal grading, and vertical alternation of sedimentary structures. A polygenetic model is presented to account for the various configurations of hummocky cross-stratification that may commonly be produced during storms by wave oscillations, hyperpycnal flows and downwelling flows. Inherent storm-wave unsteadiness probably facilitates the generation of a wide range of hummocky cross-stratification configurations due to: (i) changes in near-bed oscillatory shear stresses related to passing wave groups or tidal water-level variations; (ii) multidirectional combined-flows related to polymodal and time-varying orientations of wave oscillations; and (iii) syndepositional liquefaction related to cyclic wave stress. Previous proximal–distal tempestite facies models may only be applicable to relatively high-gradient shelves, and new models are necessary for low-gradient settings.     

Tidal amplification and along‐strike process variability in a mixed‐energy paralic system prograding onto a low accommodation shelf,Edgeøya,Svalbard

The study describes the depositional development and sediment partitioning in a prograding paralic Triassic succession. The deposits are associated with the advance of large prism‐scale clinoforms across a shallower platform area. Approaching the platform, the limited accommodation and associated relative higher rates of deposition generated straighter clinoforms with lower foreset angles. The vertical restriction across the platform is interpreted to have amplified the tidal signature. Sediment was redistributed from the coast into increasingly sandy delta‐front deposits, compared to offshore equivalents. The deposits comprise extensive compound dune fields of amalgamated and increasingly clean sandbodies up‐section. Rapid deposition of significant amounts of sand led to differential subsidence and growth‐faulting in the delta front, with downthrown fault blocks further amplifying the tidal energy through funnelling. A mixed‐energy environment created along‐strike variability along the delta front with sedimentation governing process‐regime. Areas of lower sedimentation were reworked by wave and storm‐action, whereas high sedimentation rates preserved fluvially dominated mouth bars. A major transgression, however, favoured tidally dominated deposits also in these areas, attributed to increasing rugosity of the coastline. Formation of an extensive subaqueous platform between the coast and delta front dampened incoming wave energy, and tidally dominated deposits dominate the near‐shore successions. Meanwhile formation of wave‐built sand‐bars atop the platform attest to continued wave influence. The strong tidal regime led to the development of a heterolithic near‐shore tidally dominated channel system, and sandier fluvial channels up‐river. The highly meandering tidal channels incising the subaqueous platform form kilometre wide successions of inclined heterolithic stratification. The fluvially dominated channels which govern deposition on the delta plain are narrower and slightly less deep, straighter, generally symmetric and filled with cleaner sands. This study provides important insight into tidal amplification and sand redistribution during shallowing on a wide shelf, along with along‐strike process‐regime variability resulting from variations in sediment influx.     

Supradetachment to rift basin transition recorded in continental to marine deposition; Paleogene Bandar Jissah Basin,NE Oman

A transition from supradetachment to rift basin signature is recorded in the ~1,500 m thick succession of continental to shallow marine conglomerates, mixed carbonate‐siliciclastic shallow marine sediments and carbonate ramp deposits preserved in the Bandar Jissah Basin, located southeast of Muscat in the Sultanate of Oman. During deposition, isostatically‐driven uplift rotated the underlying Banurama Detachment and basin fill ~45° before both were cut by the steep Wadi Kabir Fault as the basin progressed to a rift‐style bathymetry that controlled sedimentary facies belts and growth packages. The upper Paleocene to lower Eocene Jafnayn Formation was deposited in a supradetachment basin controlled by the Banurama Detachment. Alluvial fan conglomerates sourced from the Semail Ophiolite and the Saih Hatat window overlie the ophiolitic substrate and display sedimentary transport directions parallel to tectonic transport in the Banurama Detachment. The continental strata grade into braidplain, mouth bar, shoreface and carbonate ramp deposits. Subsequent detachment‐related folding of the basin during deposition of the Eocene Rusayl and lower Seeb formations marks the early transition towards a rift‐style basin setting. The folding, which caused drainage diversion and is affiliated with sedimentary growth packages, coincided with uplift‐isostasy as the Banurama Detachment was abandoned and the steeper Marina, Yiti Beach and Wadi Kabir faults were activated. The upper Seeb Formation records the late transition to rift‐style basin phase, with fault‐controlled sedimentary growth packages and facies distributions. A predominance of carbonates over siliciclastic sediments resulted from increasing near‐fault accommodation, complemented by reduced sedimentary input from upland catchments. Hence, facies distributions in the Bandar Jissah Basin reflect the progression from detachment to rift‐style tectonics, adding to the understanding of post‐orogenic extensional basin systems.     

The role of shelf morphology on storm‐bed variability and stratigraphic architecture,Lower Cretaceous,Svalbard

The dominance of isotropic hummocky cross‐stratification, recording deposition solely by oscillatory flows, in many ancient storm‐dominated shoreface–shelf successions is enigmatic. Based on conventional sedimentological investigations, this study shows that storm deposits in three different and stratigraphically separated siliciclastic sediment wedges within the Lower Cretaceous succession in Svalbard record various depositional processes and principally contrasting sequence stratigraphic architectures. The lower wedge is characterized by low, but comparatively steeper, depositional dips than the middle and upper wedges, and records a change from storm‐dominated offshore transition – lower shoreface to storm‐dominated prodelta – distal delta front deposits. The occurrence of anisotropic hummocky cross‐stratification sandstone beds, scour‐and‐fill features of possible hyperpycnal‐flow origin, and wave‐modified turbidites within this part of the wedge suggests that the proximity to a fluvio‐deltaic system influenced the observed storm‐bed variability. The mudstone‐dominated part of the lower wedge records offshore shelf deposition below storm‐wave base. In the middle wedge, scours, gutter casts and anisotropic hummocky cross‐stratified storm beds occur in inferred distal settings in association with bathymetric steps situated across the platform break of retrogradationally stacked parasequences. These steps gave rise to localized, steeper‐gradient depositional dips which promoted the generation of basinward‐directed flows that occasionally scoured into the underlying seafloor. Storm‐wave and tidal current interaction promoted the development and migration of large‐scale, compound bedforms and smaller‐scale hummocky bedforms preserved as anisotropic hummocky cross‐stratification. The upper wedge consists of thick, seaward‐stepping successions of isotropic hummocky cross‐stratification‐bearing sandstone beds attributed to progradation across a shallow, gently dipping ramp‐type shelf. The associated distal facies are characterized by abundant lenticular, wave ripple cross‐laminated sandstone, suggesting that the basin floor was predominantly positioned above, but near, storm‐wave base. Consequently, shelf morphology and physiography, and the nature of the feeder system (for example, proximity to deltaic systems) are inferred to exert some control on storm‐bed variability and the resulting stratigraphic architecture.